Interference can be caused by a number of factors. Interference in receiving the desired station is often caused through overloading of the radio's first amplifier by a different but nearby station. If you know that you are in an area where a radio or television transmitter is located, this may be your problem. There are several cures for this problem.

You'll need these if you need to modify your vehicle for new speaker cutouts or to accommodate a new head unit. Helps for detailed modifications of door panels or carpeting, especially when installing new speakers. In addition to the fuses for your stereo system, check your car's fusebox to find the various sizes you'll need. Also, you can use needle-nosed pliers to pull fuses. A flashlight will do - you just want something that you can poke around the innards of your car with.

Because Stormscope weather mapping systems detect electrical discharge activity, antenna placement relative to other active electrical components is critical. The antenna must be placed at a location that is free from excessive electrical interference. The ideal location varies for aircraft to aircraft. To ensure an interference-free antenna location, every aircraft must be skinmapped prior to installation of the Stormscope antenna.

We recommend Times Microwave LMR-series , Andrew Heliax , Belden RF-series or NK Cables USA cable for the lowest losses. Times LMR-1200 or Andrew LDF5-50A Heliax will produce 2.3 dB loss in a 100 foot run. Times LMR-400 and Belden RF400 will produce 3.3 dB loss in a 15m (50') run at 2450 MHz. Belden RG-213/U cable may also be used for runs of less than 7.5m (25'). Total attenuation should not exceed approximately 3 dB. Cables and connectors may be ordered through TESSCO.

No. You must install an Ameri-King antenna that has been certified for use with an Ameri-King ELT. The TSO C91a requires that the antenna be part of the approved "system" that the letter of TSO is granted to. Ameri-King specifies the 30-inch minimum to reduce the chance of re-radiation problems and GPS interference. Installation of the antenna closer than 30 inches will not violate the TSO but is done so at the installers risk.

If you want to improve signal strength in ONE direction at the expense of other directions, get a directional antenna. But remember that the higher the gain, the harder it will be to setup the antenna for best overall wireless performance.

The customer may perform installation with start-up accomplished by the contractor to ensure installation was properly accomplished.

Proper spacing down the length and width of the building is essential to ensure consistent comfort levels. The design should also take into account safety margins for zone heating, warm up times and comfort levels. In many buildings, the best heating solution employs a mix of tube and luminous heaters.

with any building material the beauty of that product is greatly enhanced by how well it is installed. With Eldorado Stone, careful consideration regarding the type of profile and color selected, the actual installed stone “pattern”, and the type of grout technique used, are all very important factors to regard. It is always best to create a mock up board with the desired aesthetic appeal prior to installation on your project.

A variety of antenna mounting solutions can be found by contacting ROHN Towers. This company carries everything from non-penetrating roof mounts to side building mounts and eave mounts.

The installation of the STB would take approximately 45 minutes to one hour. It includes a complete antenna systems check (required because the set up and quality of individual TV systems is different), the installation of the STB, a full network scan and TV/Video retune.

We install a small antenna (12" tall x 3.5" wide and weighs less than 1 pound) on or near the roof of your home or business with a Cat5 Ethernet cable that is run down and into your home to a single point where your PC or router will be installed. Please see our "How it works" section for a more detailed description. Please note that we do not get into cabling from that point to multiple rooms or drops.

A satellite receiving antenna may not be erected in a residential district unless it is accessory to a residential or institutional use and it is located in a rear yard. A satellite receiving antenna may be erected after the issuance of a building permit provided the following conditions are met: The antenna shall be permanently secured to the ground. No antenna shall be installed on a building or on a portable or movable structure, such as a trailer.

Visit http://www.antennaweb.org and enter your address and zipcode. You will be given a list of digital stations in your area and by clicking on the antenna type it will tell you what type of anteena you will need to receive a signal from that station. Pay attention to the stations that are marked "Digital".

Our cellular antennas are designed and tuned for maximum gain of 9dB. The little antenna on your cell phone simply does not have any gain or range.

Answer: Once the fitting has been installed you can visually verify that the pipe is located in the correct position within the fitting by viewing the Install and Inspect marks. The purpose of the install and inspect ovals are to establish the correct positioning of the pipe within the fitting.

article published several years ago proclaimed that a small loop antenna (about 5 ft diameter) known as the DDRR was suitable for listening to Jupiter. Most seasoned observers doubt the claims made for this antenna. As far as we know there has never been a good scientific comparison made between the small loop antenna and full size antennas like the Jove dual dipole array.

Garmin and Gilsson seem. These models are discussed in a long thread here. Another shorter discussion starts here. Neoprene and sharkskin cases for the 60C and 60CS are discussed here and here. A great thread on cases for the 76C and 76CS can be found here

Yes. If you currently use an antenna to receive your over-the-air programming, you will still need it after you install a converter.

You can, and some do, in certain special circumstances. If you're standing somewhere (on top of a building or hill) and want to sense stations at a distance, you can use a directional gain antenna to "warscan" by rotating it on a camera tripod or just aiming it by hand.

Any panel-type antenna whose gain does not exceed 9dBi. Please refer to the WJ MPR Series operations manual for further compliance and operation details and usage information. The MPR cards are, however, a firmware update needs to be performed. Please download the software here. Not only does this include the C1G2 update, but also includes updated algorithms for better overall performance. For non-Gen2 applications, this firmware upgrade is still beneficial.

For the MPR5000, it does not matter which one is selected since the antenna port it hardwired inside the unit, however with the MPR6000 and 7000, the reader can select between the two.

Typical installation takes less than an hour. Only two wires need to be connected and routed. Mounting on the instrument panel is accomplished with a Velcro? hook and loop fastener. Routing of the two wires must consider possible sources of abrasion. Good aircraft electrical wiring practices must be followed.

A minimum roof slope of 2-in-12 is recommended, though lower slopes are acceptable if the side laps are caulked. Met-Tile may be installed over existing shingles or decking, and may also be applied over open steel purlins or wood rafters.

No. You drill the few holes needed for your kiln, place the EnviroVent 2 spring loaded plenum cup under your kiln and mount the motor to the wall. We supply the aluminum drier ducting that is used between the plenum cup and the motor. Skutt even supplies the stainless sleeve that is needed to pass through the wall. It runs on 115V household current. If you install the EnviroVent on a kiln with a metal floor plate, you will need an electric drill.

We install a small antenna on or near the roof of your home or business. Then a Cat5 cable is run down and into your home.