How do I connect my iPod up to my home stereo?
IVCA Event Podcast & FAQEasy, all you need is a cord that is has two RCA connectors on one side and an 1/8th inch jack on the other. You can buy one at Radio Shack. You can get the fancy one that says it is for iPods for $30, or one that does the same thing but does not say iPod on it for $6 bucks.
Related QuestionsApple - iPod - FAQYes. Third-party stereo adapters are available for listening to your iPod music library using home stereo speakers. Compatible devices must be self-powered and support audio output through a 3.5-mm headphone jack. For optimal sound quality when using external speakers, set the iPod volume at less than half the maximum output and adjust your listening volume through your stereo controls. This prevents overamplification, which can cause distortion and reduced audio quality.Related Questions
iPod FAQYou can purchase a separate cable that connects to your stereo's RCA audio input. In fact, there are several accessories available for listening to your iPod at home — see our guide to listening to your iPod at home for more information.Related Questions
Can I connect iPod to my home stereo and car stereo?
iPod Accessories FAQsYes! iPod will sound great on your home stereo and your car stereo. The only thing is that you must make use of iPod car accessory in order to connect to the amplifiers and speakers of your car stereo. iPod accessories are to be used while connecting the iPod to the home stereo too. These iPod accessories can be available in all car stereos or home stereo stores. We have a wide selection available for you to chose from.
Related QuestionsQuestion: Can I connect iPod to my home stereo?
iPod: Frequently Asked QuestionsAnswer: Yes. With its powerful 60 mW amplifier and 20 Hz to 20 kHz frequency response, iPod will sound great on your home stereo. Third-party stereo adapters are available for listening to your iPod music library using home stereo speakers. Compatible devices must be self-powered and support audio output through a 3.5 mm headphone jack.
Related QuestionsHow do I connect my iPod to my car stereo?
iPod FAQThere are several different accessories for this, including adapters designed just for the iPod, auxiliary input adapters, cassette adapters, and FM modulators and transmitters. For help finding the right accessories for you and your car, check out our guide to listening to your iPod in the car. back to top
Related QuestionsQuestion: Can I connect iPod to my car stereo?
iPod: Frequently Asked QuestionsAnswer: Yes. iPod will also sound great on your car stereo. Use an extension cable with 3.5 mm stereo connectors on each end to connect iPod to your car stereo system's auxiliary input, or use a cassette adapter if your car stereo doesn't have a sound input port. These items can be purchased at stores that sell car stereo accessories, or at the Apple Store.
Related QuestionsHow do I connect a wireless system to my home stereo?
Audio-Technica - Microphones, headphones, wireless microphon...Connecting a wireless system directly to your home stereo system is not recommended, because the voltage provided by the wireless system may not be strong enough to drive the input on your home stereo system. Most home stereo system’s line level RCA inputs require a minimum voltage of 300 mV, while the balanced and unbalanced outputs on all Audio-Technica wireless systems are providing much less.
Related QuestionsCan I connect the Jukebox to my stereo or home theater?
HelpYes, the jukebox has a line output on the back panel. You can find a suitable cable in our online store by clicking here.
Related QuestionsI control my iPod from my car stereo. Can I also listen to podcasts in my car?
Podcasting Frequently Asked Questions (FAQ)If your iPod does not have a Click Wheel, you can do this. If your iPod has a Click Wheel and you've installed iPod Updater 2005-6-26 or later, you won't be able to do this unless you create a playlist of podcasts (in addition the special Podcasts playlist created for you by iTunes); then just listen to that playlist in your car.
Related QuestionsWhy can?t we just setup an IPOD or stereo system ?
Fort Myers Wedding Mitzvah Party DJ Naples Estero Sanibel Ca...Many reasons. Most importantly a good dj/emcee not only plays music and does announcements and introductions they also coordinate the event to keep it on schedule and make sure you don?t run out of time before all the things you want to happen take place. A good dj also "works" the crowd by playing certain songs and encouraging the crowd to be active and be involved and get them on the dance floor. Home stereos are not made for travel.
Related QuestionsHave an iPod?
juliangel's Queue of videos and podcasts - a Personal Queue ...Click to learn how to customize this widget - change the number of thumbnails shown, background color, width, layout, and more!
Related QuestionsHow can I connect an iPod to a Windows Computer?
ZA StoreThe iPod is able to connect to a Windows Computer via a USB2.0 port. Only the iPod shuffle is able to connect using USB 1.1. The iPod nano and the larger iPods require USB 2.0. All iPods ship standard with a USB 2.0 cable.
Related QuestionsDo you use home stereo equipment for your show ?
FAQ, Infinity-Lighthouse Disc Jockeys serving Dubuque, Iowa ...Answer: Absolutely NOT ! We ONLY use professional public address systems for all of your events. We do not believe in cutting corners when it comes to our equipment.
Related QuestionsHow do I connect the digital box to my stereo TV and stereo VCR?
Cogeco - Customer Support - Digital Cable TV support - FAQ -...Please click here for a detailed downloadable diagram. (The file size is 88 KB and the approximate download time is two seconds for a 56K modem). The diagram for download is in PDF format and requires the Adobe Acrobat Reader for viewing and printing.
Related QuestionsHow do I connect QChord to stereo speakers?
FAQs All about the QChordThe sound quality QChord delivers through its built-in mono speaker and bass port system is impressive. But you'll be truly amazed when you hear it in stereo. To connect to your own stereo system, you need a QChord Stereo Cable. Note that you are supposed to connect to your stereo amplifier, not directly to the stereo speakers.
Related Questionsd -How do I connect and set up a stereo cabinet with my amplifier/amplifiers?
Marshall Amps :: Frequently Asked QuestionsIf you are connecting a stereo amplifier or two different amplifiers to a stereo cabinet make sure the impedance and power handling of the cabinet matches your amplifier/amplifiers. If you are using our standard 4x12" this has two sockets and a selector switch on the back, setting this switch to stereo splits the cabinet into right & left. The two sockets will now have an impedance of 8 ohms with a power handling depending on the cabinet you have.
Related QuestionsHow do you connect a subwoofer to a stereo?
Audio Speaker FAQ - WikiFAQ - Answers to Frequently Asked Qu...Many subwoofers contain their own amplifier and crossover. For these, take the preamp output and feed it into the subwoofer amp input and also into the main amplifier. For other subwoofers, just run them in parallel with your main speakers, or combine them into your system with your own bass amplifier and crossover. Some A/V receivers contain a splitter specifically for use with subwoofers.
Related QuestionsHow do I connect my computer to my Sony changers and stereo system?
TitleTrack Jukebox Frequently Asked QuestionsWhen you purchase the "TitleTrack Jukebox Complete Package," you get most of the cables and other hardware required to connect an available USB port on your computer to your Sony changers and stereo system. You will need to purchase a USB to RS232 adapter.
Related QuestionsHow do I connect my stereo or tape deck to my computer?
Frequently Asked QuestionsTo do this you need a cord that will go between the two. The cord should have an 1/8 inch plug on one end and a stereo RCA adapter on the other.
Related QuestionsHow can I connect my active subwoofer to a stereo amplifier?
Magnat Audio Produkte GmbH - Home und Car Hifi - Lautspreche...Your subwoofer possesses a left and a right high-level input and you will need an appropriately long and thick normal loudspeaker cable to connect to your amplifier. Either connect the subwoofer to the same output terminals to which your speakers are connected. Doing so will mean that the speakers and the subwoofer will run in parallel in the low-bass range. Due to the fact that the subwoofer is high-ohmic, this will cause no problems where impedances are concerned.
Related QuestionsHow do I connect my turntable or stereo system to my PC's soundcard?
DART - Digital Audio Restoration TechnologyThe first step you'll need to take to get started recording is to set up your sound card's connection to the "outside world." There are many different types of soundcards and audio cards on the market, so the information we provide here can only give you general guidelines on how your connections will be made. Please be sure to refer to your sound device's printed or online documentation when setting up to record from its inputs.
Related QuestionsHow do I connect my Bluetooth Stereo Headset to my SPL?
FAQ - SPLFirst, you must put your headset into "Visible/Discoverable" mode so that the SPL can find it. Check the user manual of your headphones to find how to do this. Enter the passkey to bond the two devices. Typically the passkey is 0000 , but refer to your headset's user manual to find out what the code is. Press "Next" when you have entered it. After switching off and on your SPL or your Stereo headset, you may find that you need to re-assign the Stereo Service.
Related QuestionsHow do I connect my Bluetooth Stereo Headset to my Smartflip?
FAQ - SmartflipFirst, you must put your headset into "Discoverable" mode so that the Smartflip can find it. Check the user manual of your headphones to find how to do this. After a few seconds, the name of your headphones will be displayed. Highlight their name and press the 'Next' key. Enter the PIN code to bond the two devices together. Typically the passkey is '0000', but refer to your headset's user manual to find out what the code is. Press "Next" when you have entered it.
Related QuestionsWill the Tesla Roadster's stereo work with my iPod?
Tesla Motors - FAQsYes, you can connect your iPod to the Tesla Roadster's stereo using a mini jack available at most consumer electronics stores.
Related QuestionsHow do I listen to my iPod, or other MP3 player, through my cars stereo system?
E60 Information NetworkBMW offers an Auxilary Audio Input option which your dealer can install for you. Once this is installed you'll have a new screen in iDrive and be able to plug in any mp3 player, cd player, etc.. and play it through the cars stereo system. Home | Information | Forums | Members Photo Gallery | Frequently Asked Questions | Do It Yourself | Donate | Contact Us
Related QuestionsHow can I connect from home?
MFCF/CSCF Frequently Asked Questions: Connecting from off-ca...If you already have an Internet Service Provider (ISP) and want to access your files from home, you can connect to one of our Unix servers through SSH. In order to do that, you need to obtain an SSH Client first. Follow the instructions for your respective OS bellow: Linux/Unix: your distribution most likely comes with an SSH client. If you don't know how to use it, see "man ssh".
Related QuestionsLearning EdgeNotebooks come with a high-speed Ethernet and wireless network card to connect to your residential Internet ISP. Students have to arrange on account with the ISP of your choice.Related Questions
Do I need an iPod Dock to connect and charge my iPod?
ZA StoreThis allows the cable from the computer or charging source to plug directly into the iPod, or into the Dock, whichever is more convenient. No the iPod and it's iTunes software requires Windows 2000 or Windows XP. The iPod of course also works with the entire Apple Macintosh range.
Related Questions