Absolutely. Radiantmax Floor Systems let you heat only those rooms you want to heat. The bathroom is a big priority for people who don't like to step onto cold tile.

Depending upon the type of system you have, it is usually possible to install ceramic over radiant heat floors. Some applications will require a membrane in between the tile and subfloor. Ask your contractor what is best for you. One of the rubs against ceramic tile is that it is cold and hard. There are floor heating systems available to make your floor more comfortable to the touch, but in terms of hardness, yes, ceramic is much like hardwood in that it doesn’t have much give.

Recommended water temperature by Balneo therapists is about 38º C (nicely warm - watch out for cooling of the bath) as hot water could cause fatigue. Some patients may prefer hotter bath - generally OK but watch for high blood pressure, heart problems and fatigue factor.

Patients may shower when their surgeon determines that the wound has sealed and there are no signs of an infection. This is usually a week after surgery. If there is any concern, a water resistant protective dressing may be worn during showers. Soaking in a bathtub should be avoided for at least three weeks until the incision is fully healed.

Ceramic tile can be bonded to ceramic tile with a polymer modified thinset BUT your installation will only be as good as the weakest tile in the old installation.

If your tile floor is properly maintained, you can expect it to last 20 years or more. You will greatly enhance the life of your tile floors or walls by using a properly installed cement backer board. Properly maintained tile walls installed over a cement backer board can also last 20 or more years.

Because the system will act as a giant storage heater initially it may take several hours to heat up.

Yes, whatever the shape and size of your room. Thermonet can heat your floor all over. For more complex installations the heatmats quickly convert into a fully flexible single wire system. Virtually none. Under a tiled floor the heatmat disappears within the adhesive bed. Nominal height 2.5mm.

Insulated floors heat faster than un-insulated floors. The type of floor finish can make a difference too. If your floor is un-insulated, using Dukkaboard will reduce floor heat-up times and the system will cost less to run.

long as proper steam cleaning techniques are followed, there should be no danger of heat damage. Floor materials like marble, sealed hardwoods, granite, ceramic and tiles can be steam cleaned safely. Tecnovap's boilers are wrapped with a thick layer of insulation protection and are several inches above the floor. While they are very hot inside (155 o C and above), the base of the machine remains warm and will not damage the floor underneath.

Yes, and there are actually several ways to do it! To serve your daily hygienic needs, there are mobile showers at several locations. This service is only available for those who have Camping Tickets or purchased several daily tickets. Those who fancy going to the beach, can use the stretched-surface swimming pool in the territory of the Honvéd holiday resort. The use of the swimming pool is free, but its capacity is restricted due to healthcare regulations.

Our goal is to create a new and exciting environment for you using our products and design talents. When designing a space for you, we utilize the strengths of the particular manufacturer's cabinetry that is most appropriate. A design by us may not translate into another manufacturer's product. We believe the best situation is to have your kitchen, bath, wardrobe, etc., designed with the end products in mind throughout the entire process.

Bathroom panels offer several benefits - easy to clean, no grout to go mould, no maintenance etc. The more cladding you install, the greater the benefit will be. If you only panel 20% of the room, you will only get 20% of the benefit!

For a water bath canner to work successfully on a ceramic cook top, the canner bottom must be flat, in contact with the cook top and extend no ore than 2 inches beyond the design on the cook top surface.

It's important that your floor be strong and without any flexibility. Your joists should be 2"x10" centered every 16". The plywood subfloor must be either 5/8" exterior grade plywood or 3/4" OSB before you begin adding to the substrate. Deflection both dead and live loads must not exceed L/360 for ceramic tile or L/720 for natural stone and some larger ceramic tiles. There are allowances made for variances to the above. Check with the pros in the forum for recommendations.

Tile is the most durable flooring and facing material available. It is color permanent and virtually abrasion resistant. It will not cut, tear, gouge, puncture, warp, rot, burn or require refinishing.

Although glazed ceramic tile requires less floor care than most of the other flooring types, there are things you need to do to maintain the beauty of the ceramic tile floor. Wash regularly. Wash the floor regularly to remove any dirt or grit. Use a mild, diluted detergent solution, such as Mr. Clean or Spic & Span. If in doubt, call us to get the file manufacturer’s cleaning recommendations. Always rinse.

We base that statement on the fact that UniBond PVA is the only PVA to be independently audited and rigorously tested at least twice a year. It is the only PVA to hold BS Kitemarks and BBA Certification in the UK. Yes, you may remember using PVA as a child at school. It is safe to use hence schools often use it within their art departments for young children to use.

Sogo, a fully homogenous tile is far superior to ordinary ceramic floor tiles. Ordinary ceramic floor tiles are porous products and require to be glazed before use. Sogo on the other hand is an unglazed product. It is made of single compact body mass and is fully vitrified (water absorption near zero). This makes it stronger and more durables.

We generally recommend that the underlayment be removed because the subfloor may mot be adequate to support tile; however if your existing vinyl floor was installed over an adequate subfloor using a full spread installation method then yes, it can be done if you use the proper installation products.

No. Mastic is best used for wall tile, especially in high-humidity areas. For most floor installation, we recommend latex thinset.

Typically, the floor temperatures achieved with underfloor heating never exceed 22°C and 27°C. This ensures that the floor will not get hot enough to damage your floor coverings. See our Floor Coverings page for more information.

Standard radiators operate with water temperatures of 60°C to 70°C. Under floor heating can operate at temperatures as low as 40°C. Heat pumps are far more efficient when operating at these lower temperatures. Because ground source heat pumps draw their energy from the ground they usually require a large collector area, this may not always be available, in this case an air source heat pump might be more suitable.

With a good level of floor insulation and the correct choice of heating cable to get the maximum coverage and output, then in most circumstances under-floor heating will provide the required room temperature. Most conservatories are not required to pass any building regulation U Values, so depending on the type of glass structure you have, supplemental heating may be required for odd occasions like cold winter nights.

Cork is a natural insulator so just by having a heated house; the floor will draw the warmth. If you still want to install radiant heat, it has posed no problems. The floor may take slightly longer warm up but the heat will be retained efficiently. Only floating floors should be installed over radiant heat systems. Floating floors tend to go through normal contraction and expansion as a unit since they are not attached to the sub-floor.

This type of plan is very popular and you will find these in both of our current projects, Lacamas Meadows and Hazelnut Grove.

ABSOLUTELY. To receive constant Far infrared heat using your (control panel), simply set the controller to its highest setting. During a 30 to 45 minute session, the heaters will be emitting 100% Far infrared heat, with no intermittent shut off.