Warranty requirements on the label of each product can include dry film thickness and millage rates. If you go back to the manufacturer for a warranty at a later date, they will require that the dry film thickness and millage rate was to their specifications. It is very important to apply elastomeric paints very heavily for them to do what they're designed for to protect surfaces and seal them from the elements

ASTEC is always applied with a dry film thickness (dft) between 12 mils (305 microns) and 15 mils (382 microns). Any additional thickness will be wasted because the principle of solar radiation control has nothing to do with thickness but everything to do with solar reflectivity and thermal emissivity.

The tax rate, or millage rate, is set annually by the Stephens County Commissioners and the Stephens County Board of Education. A tax rate of one mill represents a tax liability of one dollar per $1,000 of assessed value. Each governing authority estimates their total revenue from other sources. This figure is subtracted from their overall budgetary needs, and then a millage rate is set that will generate the necessary revenues to fulfill budgetary requirements.

Absolutely. A person can rate as many of the entries as they'd like. However, you can't rate the same film more than once. These people should enter their favorite school in that section. It doesn't matter to us whether it's the school they attended, their favorite sports school, or the one closest to their house. They can choose and have fun with it.

Ad valorem taxes for fiscal year 2005 are based upon the tentative calendar year 2004 Certification of Taxable Value, multiplied by the millage for fiscal year 2005. For the current fiscal year the City's operating millage rate is set at 5.768 mills and a debt service millage rate of 0.258 mills, for a total of 6.026 mills. A mill is one-tenth of a penny, or $1.00 of ad valorem tax for each $1,000 of certified taxable value.

The millage rate is calculated by dividing the total amount of money to be raised through property taxes by the total value of the tax digest.

The millage rate would increase by 1 mill over current tax rates. The current tax rate includes an existing .54 mills of existing bond debt on the current tax digest for the downtown conference center. The new 1 mill would be added to the second half of the 2006 tax bills due in Dec., 2006. These figures are based on the current tax digest. As the tax digest grows, the actual millage necessary to underwrite the bond will likely decrease over the term of payment.

The way this bond issue works, the millage rate will actually go down to an average of 3.69 mills with the last years being about 2 mills. The average millage rate will actually be a part of the bond issue language. The link below will help individuals accurately access what the proposal will cost each homeowner based on their actual circumstances. All Swartz Creek buildings will experience additions and/or renovations should Proposal 1 pass.

After the Assessors' staff has completed their review of current appraisals; we then turn the data over to the Tax Commissioners office to add other taxable property such as motor vehicles to the tax digest. The Tax Commissioner and Assessors office then balance all assessments and exemptions. After a thorough review of the digest valuations and exemptions has been completed, we then hand the tax digest totals over to the "Governing Authorities".

Once the 10+” of wool layers are stuffed into the cotton cover, the final thickness of the Cuddle Ewe Underquilt is approximately 3”. With use, the Cuddle Ewe Underquilt will compress to a thickness of about 1.5” to 2”. This is very normal and to be expected. Once the wool has compressed, there is nothing that can be done to re-fluff it, but it will still be comfortable. With proper care, you can maintain the Cuddle Ewe’s loftiness for a long time.

Farmington Hills residents pay 10.2221 mills -- the 7th lowest out of 32 communities in Oakland County. A mill equals $1 in taxation for every $1,000 in taxable value.

The City's current millage rate is 8.63 mils. Since 2000, the City has held or lowered property taxes every year. In 2005, the City implemented a homestead exemption in the amount of $10,000 to further reduce property taxes on its citizens that occupy the house they own. The net difference in millage rates for Griffin taxpayers and those outside the City in Spalding County is even less at 5.58 mils.

The current millage rate for the town of Shalimar is 2.2 mills. This means the Shalimar property tax will be $2.20 for each $1,000 of property's assessed value (minus any exemptions like the Florida Homestead). For example, a property assessed at $125,000 with a $25,000 Florida Homestead exemption would currently be assessed $220 in Shalimar property taxes.

The Millage rate for the City of Bloomfield Hills in the Bloomfield Hills School District can be found on our Tax Millage Rates page.

Film thickness is expressed in mils - one mil is equal to one thousandth of an inch. One gallon of 100% solids material covers 1600 square feet at one mil thickness (about the thickness of a sheet of copy paper). To figure the coverage of Sport Kote (#222) to achieve one mil thickness, you would take 1600 ft2 X 0.29 (29% solids) = 465 square feet. Since Sport Kote is used at 800 to 1000 square feet per gallon, users are typically getting 0.6 mil (465/800) to 0.5 mil (465/1000) coverage per coat.

Also, don't store film in tight-fitting cans; let it breathe. Safety has a tendency to go vinegar if sealed-up in a can (not so much if the temp is low), so keep the film in loose-fitting, oversized cans. If you can afford it, throw in a few molecular sieves per can; it can't hurt (at least as far as we know!). I think so. The greater volume of air would be easier to stabilize and maintain a good relative humidity level.

The film with the highest rating at the end of the public rating period will win one of the grand prize packages. Additionally, the 25 films with the highest ratings will be screened by our celebrity judges who will pick their favorite film to receive a second grand prize package.

You need to be registered with ODEON and logged into our website to be able to rate a film. Once you are logged on, simply drag your mouse over the stars to change the rating from the current average rating to your own personal rating.

Portage Schools is currently at 2.20, the lowest of all the districts, and with these two proposals, would become the 3rd lowest.

Cold weather and humid conditions can lengthen the dry-out time, while warm, sunny weather will speed it up. Dry-out times can vary from a few days to as long as six months, but the film will eventually dry completely. Moisture that is trapped during the installation process can cause bubbles or a slightly cloudy appearance. This is normal. Do not try to “pierce” or cut the film in an attempt to drain the trapped moisture. This will damage the film.

It helps us detect cheating and fraudulent behavior when we require the extra step of signing in to rate films.

This product is available in two thicknesses only: 8 mils (a 6-mil film base with 2-mil adhesive) and 14 mils (a 12-mil film base with 2-mil adhesive.) M sells the bulk rolls through authorized distributors. Please visit the Where to Buy section of this website to find a complete list of Authorized Converters Scotchgard™ Paint Protection Film.

A millage rate is the tax rate used to determine how much taxes a property owner pays per $1,000 of taxable property. Example: A millage rate of $5.10 means the property owner pays $5.10 for each $1,000 of taxable property value.

Yes. There are standard reports, which identify items, which the Credo Trend Analysis tool has predicted will require to be retired with n years.

European Television Standard European television conforms to the PAL (Phase Alternation by Line) standard, which runs at 25 frames (50 fields, or half-frames) per second. This is close enough to the film standard of 24 fps, that 24 fps films are often simply run at 25 fps, with possibly a bit of pitch-shifting on the soundtrack to make it sound less 'screechy.

Advanced Photo System films use a different film base technology that absorbs less water than current 35 mm films, leading to a more efficient drying position. Extensive testing with large lab cine applications indicated Advanced Photo System films can be sufficiently dried at a temperature of approximately 115° F (46° C), 20° F (-6.7° C) lower than the average dryer temperature currently used in the trade.