You can use primer to prepare a sub-floor for vinyl tile. It aids in preparing the floor for the adhesive. We recommend Jasco Primer. NEVER USE A SEALER! TrafficMaster Pro Basement Proofer is a type of primer that acts like a sealer, but allows adhesion of the tile to concrete floors. Most importantly, it helps prevent moisture from getting between tiles and the sub-floor.

The Basement De-Watering System® is the ideal solution for carpeted basements. If the carpet has not been destroyed by years of water damage, enough of it can be moved or removed to provide clearance for the Basement De-Watering System®. Some carpets must be trimmed and replaced after the installation. If vinyl flooring has survived past seepage, it will be trimmed about 2 1/2" from the wall before the Basement De-Watering System® is installed.

We recommend using a non-rinsing cleaner that leaves no film. We suggest that you vacuum, sweep or dust mop more frequently. Wipe up food or other spills immediately using a non-abrasive cleaner and a soft cloth. You should NEVER USE ABRASIVE CLEANERS, POWDERS, OIL CLEANERS, WAXES OR DISH DETERGENT; this will scratch the surface or leave a film.

Concrete Floors must not contain a sealer or finish of any kind. For installing below grade (below floor level, like in basements), we recommend Basement Proofer to prepare concrete floors. First, clean the sub-floor for any remaining dirt and grease. Tiles must be in the room of installation for at least 2 days to stabilize temperature. Never use polyurethane over vinyl tile.

When the vinyl is firmly adhered to the floor and all contaminants and waxes have been stripped from the floor. If the vinyl is “cushioned,” it should be removed. Bear in mind that some older vinyl may contain asbestos, which can be dangerous if inhaled. In unsure, contact a professional.

We generally recommend that the underlayment be removed because the subfloor may mot be adequate to support tile; however if your existing vinyl floor was installed over an adequate subfloor using a full spread installation method then yes, it can be done if you use the proper installation products.

SkimStone is formulated for application over concrete floors. Good adhesion has been achieved over a wide variety of materials but bare concrete is the only recommended substrate for SkimStone floors.

Our technicians do not install floor tile, but we can recommend and coordinate with tile contractors to give your bathroom a completely new look.

Typically the removal and disposal of that type of asbestos containing material is not regulated by EPA (even commercially) if it is in good condition. If the material can be taken up with no significant breakage, there is little risk for fiber release.

Yes. The Texas Asbestos Health Protection Rules (TAHPR) allow a person who has had the Resilient Floor Covering Institute (RFCI) guidelines training to use those guidelines for flooring removal in leu of a license. The guidelines must be followed strictly.

The first step to take would be to back up your current game files in case of problems during installation of The Sims 2 Seasons. To do this, follow the steps listed below: Right-click on your desktop and choose the 'paste' option. This puts a copy of your current The Sims 2 folder on your desktop. Move the copy of your The Sims 2 folder to any location you wish for safe keeping. This could be another folder in My Documents or better still, how about compressing it into a .

After scheduling your free evaluation and estimate, one of our highly qualified and trained prefessionals will meet you on-site, where they will take measurements, evaluate the project and make recommendations if warranted and/or requested. Following the evaluation, a proposal will be submitted. Upon acceptance of the proposal, we will then contact you a couple of days prior to our arrival so that you may prepare for the installation.

On most occasions, nothing. We take care of everything “ from coordinating with the landscaper or builder to getting permits if required. We will call the local utility companies to mark underground cable, phone lines, gas lines, etc. You just need to inform us of any drain tile or any cables that you may have installed.

Yes, it is possible. However, there are some conditions which must be adhered to. Existing floors must be overlayed with at least WBP grade plywood. However, marine ply is best. It must have a minimum thickness 19mm, screwed down (not nailed) at 150mm centres. All timber surfaces should be primed on the reverse side and all edges. It is essential that one uses powdered adhesive with a latex additive when tiling onto plywood.

Yes, when proper installation methods are followed. Exterior applications require special precautions and installation methods. Do not install floor tile on exterior walls unless the product specifically recommends this application.

Ceramic tile in either glazed or unglazed form do not need to be sealed. These products are impervious to moisture and topical sealers will not properly adhere to them. Also, you can not change or alter the appearance or the sheen of a ceramic tile by adding a sealer. Therefore, a sealer in not recommended for glazed and unglazed surfaces.

Tile mosaics are a wonderful, lively addition that complements the appearance of your pool. They can be selected and ordered upon your visit to choose waterline tile.

No, we do not recommend doing this, as a wall is generally a P.E.I. 1 tile, that is it has a very low wearing and will not last very long.

Wall tiles are generally more porous, which helps with their adhesion to walls, the glaze is used more for the appearance, and is resistant to detergents etc. On the contrary, floor tiles have low porosity, with low to medium water absorption, which will give them better technical characteristics, as the glaze is more than the look, it is also used to prevent wear and promote scratch resistance.

The definition of Regulated Asbestos Containing Material (RACM) includes Category I nonfriable asbestos (including floor tile) that has become friable or has been subjected to sanding, grinding, cutting, or abrading. This includes floor tile that is in poor condition and can be crumbled, pulverized or reduced to powder using hand pressure and floor tile that has been removed utilizing mechanical methods.

We would prefer that you did not. Floor heating systems are professionally installed through our trained personnel.

Water and oil will bead up on your floor when sealed as recommended in our Installation Specification Guide. You need only mop it up with a sponge. For routine cleaning vacuum or sweep it, as you would any other natural stone floor or a wood floor. To wipe up, use a non-acid based cleaning product. Warm, soapy water is also fine. AquaMix makes a tile cleaning product, Concentrated Stone & Tile Cleaner, which can be used on your floor. Check their website at www.aquamix.

If the structure of the counter is strong enough to support the weight of the heavier floor tile, then this should be fine.

A tile, whether it be ceramic, porcelain or natural stone is usually a good retainer of heat. Therefore it can often be the warmest floor in your home or building. It depends on the air temperature under the floor and the exposure to sunlight etc. Under-floor heating is a good option to warm your floor but it’s real intention is to provide an efficient, effective heating solution that gives you comfort throughout your home, therefore fulfilling your complete heating requirement.

You can use a two part ‘rubber based or latex modified’ flexible adhesive to tile directly onto the timber. (Ensure the product chosen is manufactured specifically for this purpose). The timber will need to be clean and stable. (You will need to confirm floor joists and spans will be acceptable). This option is best suited when there are concerns of adding extra height to the existing floor and/or in smaller areas not subject movement or high traffic.

No paint must be removed off of a concrete floor before tile can be applied. Removal of Paint can be done by scraping it or a shot blaster machine.

If the floor is cracked it is advisable to use an anti-fracture membrane, otherwise cracks may transmit through the tile. Also as stated in question #2 you cannot tile over a painted concrete floor.