The person to remove the existing carpet needs to be determined prior to the day of installation, whether it be yourself or the installers. Removing and hauling the old carpet and padding away will require an additional fee.

Yes, we will move your furniture, and take up old materials like your old carpet, padding, wood floors and window treatments. And not only will we do all the labor, we’ll even haul the old stuff away. Not many companies provide that kind of service. Of course, it is the customer’s responsibility to move all small, delicate, and breakable items.

Use Sticker-Off! Decal Adhesive Remover. Just spray it on the adhesive, allow a few minutes for the product to penetrate and then wipe away with a clean, soft cloth.

Vacuum the carpet thoroughly before the installers take up the old carpet, rolling up the old carpet when at all possible. After the carpet and pad has been taken up, vacuum the floor again before the new pad is put down. You may want to be out of the house for the first 24 hours, ventilating the first 48 to 72 hours.

Our recommended cleaning procedure is the use of a mild liquid dishwashing detergent with sufficient quantities of water to flush the stain out of the carpet. After each application of the detergent and water, be sure to blot any excess moisture with a clean white cloth. Always blot from the outer edge of the stain, moving towards the middle to prevent spreading. On more difficult stains or larger areas, we recommend a professional cleaning.

Treat the stained area immediately. The more time that elapses before treatment, the more difficult a stain will be to remove. Gently scrape a food spill with a spoon or dull knife to remove as much as possible. Always work from the outer edge of the stain towards the center to avoid spreading. If you need to use a detergent, use a mild, clear, non-bleach laundry detergent. Cloudy detergents can leave a sticky residue on your carpet. Measure a ? teaspoon of detergent to 32 ounces of water.

Yes we can. The cost is usually ?20.00 per room, and we put the old carpets at the front of the house. We can not dispose of carpets.

When urine is allowed to dry and remain in the carpet or other material, it begins bonding itself to the fibers. The longer it is allowed to remain the stronger the bond becomes. Proteins (chains of amino acids) physically bond to the fibers while other portions of the urine crystallize into salts, forming ionic (electric charge) bonds. At this point it has become impossible to completely remove by cleaning alone.

Let the wax cool. Carefully remove larger pieces of wax. Place a paper towel over the spill and use an iron (on low setting) to heat and absorb wax (a hairdryer can also work). Change the paper towel repeatedly. Turpentine will dissolve paraffin wax. It also may take the colour from your carpet so be very careful

A If necessary, I can remove your carpet. I charge an hourly rate for doing so. I can often arrange for local handymen to remove carpet for you.

More often than not, YES! Let the stained item soak in a solution of Stain Solver liquid overnight. If the stain is still there, increase the concentration and try it again. Continue to increase the concentration until you succeed or fail. Remember, you have NOTHING to loose. Until such time as the stain is removed from the garment, it is headed for the rag pile.

The best thing to do is probably bag it up and take it to a landfill. At least it’s organic and will rot away. Make sure you don’t put the infested mulch somewhere where you could be held responsible for someone else’s artillery fungus problem. This is out of my field, but it has been suggested that the infested mulch could be put in a yard waste-composting facility. But you really need to ask this question to a “compost expert.

Use a hair dryer for newer stickers or a warm iron over a wet towel on a hot, sunny day for old dried out stickers to soften the adhesive, and they peel right off. A little Goo-Gone, Goof-Off or lacquer thinner will remove any remaining adhesive.

Foundation preparations will depend on the building size and application you require. Your local Dealer is equipped with the essential information to suggest and arrange an appropriate foundation suitable for your Cover-All?.

Yes, and after installation if system is to be monitored, just a click to contact monitoring centre is all that's need for a test.

Please take down all breakables hanging on walls very close to windows. Please move all furniture near your windows and doors, away from the construction area to prevent damage or sawdust. Affordable Windows, Doors & More, Inc. will cover floors with drop cloths but depending on the number of windows, doors, or amount of new lumber being installed, there can be excessive dust in the air.

Yes. A resistance reading can be taken with an ohmmeter. Insulation resistance can be verified with a megger. Do Not energize the cables prior to installation.

This possible odor usually comes from 4-phenylcyclohexene (4-PC), a by-product of the latex binder used to hold the fibers and backing together reports the Carpet and Rug Institute. The odor is not harmful and will go away within a few days.

In most cases, you will need to remove certain heat-sensitive items from the treatment area. The document below provides a list of such items usually removed or specially protected during treatment. Always consult your ThermaPureHeat® technician to ensure the best possible results.

Usually not if you're installing the metal roof over existing asphalt, fiberglass or composition shingles (maximum of two layers thick). In most situations, the metal roof can be installed directly over the old roof.

Bleach spots are from the removal of color from the carpeting. The only way to repair the spots is to re-add the missing color to return the carpet back to its original color (spot dyeing).

The SafeNow? Carpet Shampoo and Stain Remover is designed to remove grease, dirt, blood, coffee, grass and other tough stains.

Pet odor is derived from a pet doing something that leaves protein behind. Applying an enzyme agent like Pet Stainoff will digest protein and eliminate the odor. A good hot water extraction cleaning would also help.

If the foam has not cured (it is still moist), it may be removed by wiping with a clean, dry cloth or by using acetone (or nail polish remover containing acetone). Do not use soap and water as moisture helps to cure foam. If the foam has already cured (it's firm and dry), it cannot be removed from clothing, upholstery or carpets. Cured foam is difficult to remove, but may be trimmed, scraped or sanded from rigid surfaces; however, this may result in a need to repaint or re-stain the surface.

First determine the type of adhesive that was used. A dark or tan color adhesive usually is tar-based, and mineral spirits can be used. A light or clear adhesive (usually carpet tape) can be removed with an all-purpose adhesive remover. A yellow-looking substance generally is carpet adhesive. This can be lightly scraped or chipped off easily, and an all-purpose adhesive remover will work.

Our car interior and exterior trims product are designed to be permanent. It can be removed but you will need to install another trim on top.

The air intake will be dismantled and the Surbo put in, and most items put back like before. We will brief the customer on the minor changes if any before starting work. If you are far away, you can make a request for emailed model-specific installation details.