To change the Drive letter used by your RDX media storage drive in Windows XP or 2003 follow the instructions below. Click on "Change" and assign a new drive letter from the drop-down box. Make sure no other device or network share is using the new drive letter.

long as your kernel is new enough you should not need to modify drivers or kernel to use RDX SATA or USB drives. A few useful Linux commands are listed below. Refer to the man pages for each command for more information. Use the eject command with the device or partition handle to eject the cartridge. When using a default formatted (NTFS) cartridge you will likely need to reformat to EXT3 for use with Linux. Please refer to the instructions here for more information.

The RDX USB drive will work on Mac OSX systems without any additional driver installation. Simply plug the media storage drive USB into an available USB port. The RDX USB should be able to be accessed through the "Disk Utility" application after plugging in and powering up. (Under the "Finder" application, select Applications->Utilities->Disk Utility.) If using a default (NTFS) formatted cartridge, you will need to reformat for MAC OS Extended (HFS+.

Removable hard disk drive cartridge formatting steps vary based on the operating system used. Links to formatting instructions based on OS are listed below.

Removable Hard Disk Drive — Troubleshooting Q: Windows - Media storage drive eject button does not work periodically on RDX USB device If the service is installed and running, there are some cases when the Windows OS does not notify the RDX Eject service of the presence of the RDX removable hard disk drive in the system. Selecting the device in Windows Explorer fixes this problem. Note that you must wait at least 10 seconds after selecting the device before the eject will occur.

The RDX removable media storage device has successfully completed all necessary testing to be included in the Windows Server Catalog for the Windows Server 2003, Windows Server 2003 x64, Windows XP, and Windows XP x64 families. Additional extensive testing included, but was not limited to: Windows XP Service Pack 2 or later The following Linux distributions have been tested extensively; however many other Linux distributions will support the RDX removable media technology.

OK. If you want to change the letter on a drive which is already assigned to another drive, you may have to assign an unused letter to the other drive first. In other words, shuffle the drive letters around until you have the desired combination. You may have to restart Windows to complete an assignment before making another one. One cannot assign a new letter to the boot partition/drive. Some programs reference the drive letter of a CD-ROM drive etc.

Right click on My Computer and choose Manage. In the window that appears, click on Disk Management. Then right click any partition you want to reassign and choose Change Drive Letter and Path. You cannot change the drive letter of the boot or system partitions (typically C:).

Click start Control Panel Administrative Tools Computer Management Select Disk Management Right click on the disk to rename and click "Change Letter and Path" Select the new path

Yes, but it's kinda painful, and you should ask yourself whether or not you really need to do it. First of all, it will involved editing the registry, and that is, as any Windows users knows, is a Task Which Can Destroy The Whole Damn House of Cards. Do you trust me to give you good advice on what to do? Remember, I'm a dumbass. Anyway, here's the procedure.

For a generic RDX removable hard disk drive Users guide installation quick reference, please see the RDX Users Guide.

The users guide for your RDX removable media storage product should be downloaded from RDX partner support sites. Links to RDX partner sites are available here.

There is room for a user label on the front of the removable hard disk cartridge. Do not place labels on the surfaces that contact the device bay as the cartridge is inserted.

Please download the latest RDX Utility software from the support sites for RDX partners. A list of links to RDX partner support sites may be found here.

The RDX USB device requires Mass Storage support, and support for USB 2.0 is recommended for maximum performance. Support for these features was available starting with Linux kernel 2.4.22. All Linux 2.6 kernels should support USB Mass Storage and USB 2.0. The RDX SATA device requires support for SATA ATAPI devices. SATA ATAPI support is available and enabled by default on distributions based on kernels 2.6.16 and later.

Follow the instructions for installation from the RDX User's guide. For links to download the RDX Users guide from support websites, please click here.

the first situation is that the source disc is with protection technology; in this case, just check the checkbox next to "Skip Reading Errors" and "RAW Mode + Sub-Channel Information" and then you can make your image file successfully; another situation is there might be scratches or damages on the source disc, although not protected. In this case, just check off the checkbox next to "Skip Reading Errors", if there is still error message, it means that your disc is damaged.

A - This decision is made by the Department of Motor Vehicles, but most patients have their license reinstated within twelve months after the surgery if they are no longer having seizures.

The Q drive is a University-wide, informational drive. It is read only; you cannot save information to this drive.

If the removable disk cartridge does not eject using either the eject button or the right-click eject methods then use the following emergency eject hole method to recover the removable disk cartridge: If using the RDX removable storage drive, turn off your computer. If using the RDX removable storage drive, unplug the power cable. Insert a large straightened paper clip (or similar object) into the Emergency Eject Hole (see the figure above.) Do not insert the object in the hole at an angle.

If your system BIOS supports it, you can create a bootable installation of Linux on your RDX USB media storage drive. For more information, please see the "Booting Linux From RDX" whitepaper.

The write protect switch is the red tab on the top edge of the removable disk cartridge. To set the write protect tab, eject the cartridge and slide the red tab to the leftmost position. The removable disk cartridge will now be write-protected. To remove the write protect, slide the red tab to the rightmost position. The cartridge will now allow write access.

Note: Formatting your cartridge NTFS is not typically required. Cartridges are shipped pre-formatted with NTFS. Deleting all files on the disk will be a sufficient method for re-initializing a cartridge in most cases. Two possible cartridge formatting methods exist for Microsoft Windows XP or 2003 installations. The most straightforward method for formatting cartridges in an RDX SATA device is through the right-click format menu.

The RDX removable storage drive and cartridge will support any file system format supported by the host system. The RDX removable hard disk cartridge is shipped pre-formatted with NTFS. NTFS is typically the best choice for Windows operating systems. Linux systems will typically use ext3 formatted cartridges. Mac systems typically use HFS+ (Mac OS Extended) formatting.

You may be able to boot your Linux distribution from an RDX USB cartridge if the installer supports booting from USB removable disk devices and your system BIOS supports boot to USB devices. Support is available natively with the Fedora 6 installer. Fedora 5 can be made bootable with some workarounds. System BIOS typically does not support boot to SATA ATAPI devices. For this reason boot from the SATA RDX device is not typically supported.

Microsoft Windows OS do not allow boot from removable storage media. Please refer to Microsoft's article at: Current versions of Windows should not be installed to USB hard disk drives because Windows does not support USB hard disk drives as the primary boot device. For instructions on setting up a bootable Linux USB RDX cartridge please see the "Booting Linux from RDX" whitepaper here.

A - A highway letter was a document that certified that a building owner had the proper "road", "curb" and "sidewalk" in front of a new or altered building. This has been replaced by the filing of the Builders Pavement Plans application.

You should see the icon next to the drive letter. Depending on the operating system that you have, it could appear as a "local drive" or "removable drive".