Search 5,000,000+ questions and answers.

Frequently Asked Questions

Q4. Where should I set up my ThermaSCENT unit and how high off the ground should it be?

We recommend laying your ThermaSCENT on the ground in a horizontal position with the grill and mat facing up or strapping your ThermaSCENT around a horizontal tree limb using the optional ThermaSCENT holster Do not put ThermaSCENT or any deer scent higher than your waist. You want a buck to approach with his head down. If you put the ThermaSCENT unit up high such as in your stand, the buck will raise his head up, making it more likely that he will see you.
Related Questions

Q2. How far away from me should I set up my ThermaSCENT unit?

Always set up your ThermaSCENT unit where you want to shoot your deer . If I'm bow hunting, I have my ThermaSCENT unit between 10 to 15 yards away from my stand. If I'm gun hunting with a shotgun (slug) I have my unit between 25 to 35 yards away from my stand. If I'm hunting with a rifle I keep my ThermaSCENT about 60 yards away from my stand. I've found through my hunting experience that these distances work best for me. Experiment to see what works best for you.
Related Questions

Q6. How do I turn my ThermaSCENT unit on?

To turn your ThermaSCENT unit on, remove the end cap from the unit and insert the cartridge into the scent dispenser turning it clockwise until it is snug. Replace the end cap. Remember that starting the unit is a two step process, similar to turning on a gas grill. 1: Slide the "ON/OFF" switch to the "ON" position; the butane gas will begin to flow. 2: After about 5 seconds, press the "START" button a few times in rapid succession.
Related Questions

If a unit is on high ground will it miss the same % as in real Starcraft?

Project Revolution - Frequently Asked Questions
We are doing everything we can to ensure gameplay in Project Revolution is identical to that in SC/BW. This definitely includes the advantage units on higher ground have.
Related Questions

How high off the ground should the Power Bar be used?

Frequently Asked Questions and Customer Comments - The F.O.D...
For the M & MW Series units the recommended operating height from the ground is the lowest possible height up to a maximum of five inches (12.7 cm). This is typically 3" to 5" (7.5 to 12.7 cm). Measure the highest known obstruction that will be driven over in the operations area, and use that as a starting point. Raise or lower until optimum performance height is reached.
Related Questions

How deep do fence posts have to be set into the ground?

Freedom Fence Frequently Asked Questions
This depends on many factors, including the type of material used and the climate conditions in your area (snow loads, frost, winds, etc.). The American Fence Association (AFA) recommends that you consult with an experienced local fence contractor (preferably an AFA member) who is familiar with the specifications and standards associated with fence installation.
Related Questions

Do I have to put a protective coating on wood fence posts before they are set in the ground?

Freedom Fence Frequently Asked Questions
The American Fence Association (AFA) recommends that you consult with an experienced local fence contractor (preferably an AFA member) to ensure the type of wood you choose is compatible with the soil in your area. BACK TO TOP
Related Questions

What is the difference between a ground set and a pit set?

Oak Creek Homes and Vic Cox Homes - Frequently asked questio...
In a “ground set” there is minimal excavating done to allow for the construction of the prepared pad onto which the home is placed and blocked. In most cases this is a concrete slab. The bottom of the frame is then set to allow for a crawl space area in the case of repairs and to assist in ventilation. Site conditions, such as high water tables etc., may require a ground set. In most cases this type of home placement is less expensive than a “pit set”.
Related Questions

How do I set the unit to operate in Binary mode?

Technical Support
Simply hardwire connect the Memory Recall Port (MRP) terminals numbered 5, 6 and 8 to the COM terminal. This will enable the unit to accept binary memory recall input and yield 24 memories.
Related Questions

How high off the ground should a bird feeder be?

Birdfeeding.org
Feeder placement depends on the birds you hope to attract to your feeding station. As much as possible, it should resemble the way birds feed in the wild, so keep colors neutral, put some feeders almost at ground level and others as much as six feet high. Another consideration is traffic from squirrels and other four-footed visitors.
Related Questions

How high off the ground should I hang my hammock?

Island Hammock
Different hammock lengths (ring to ring) will require different instructions. We can only make recommendations and you will have to tweak the installation to suit you. If your hammock is 13 feet long you will want a space approximately 15 feet apart with a foot of chain or rope at each end to adjust the hammock up or down from the ground. The hammock hooks that you hang the hammock from should be at least 4 to 5 feet off the ground.
Related Questions

How high are the balconies from the ground floor?

Fox Cities Performing Arts Center - Events/Tickets
Our first balcony, the Dress Circle, is 30 feet from the floor; our second balcony, the Grand Tier, is 60 feet from the floor; and our third balcony, the Family Circle, is 90 feet from the floor.
Related Questions

Can an enclosure be set or mounted on the ground?

BearGuard -- Metal Shelters Built Like A Fortress
Generally speaking, most county codes require that trash enclosures be mounted 18 inches above ground level. It is best to consult with your local county building dept. for further details.
Related Questions

Can I use more than one set of outputs on my unit? How much signal loss will occur if I do?

Technical Support
When multiple outputs are used, or a Y-cord is connected to drive parallel inputs, under the vast majority of situations no signal loss will occur. For the technically inquisitive, a minimum load impedance of 10 times the source is recommended. Most Rane outputs are 100 ohms per leg balanced, so net impedance limit is 1,000 ohms (or 1K). You may safely use all outputs at once, with the only concern being mixed mode wiring with balanced and unbalance combined can contribute to ground loops (i.e.
Related Questions

I just set the unit up, checked all my connections, but still get no sound. What's wrong?

Technical Support
When the unit is initially powered up all the outputs are muted. Run through the setup procedure in the manual and make sure the the inputs are assigned correctly to the applicable groups. Also be sure the groups are assigned to the outputs in use. (SR 1L remote users must also assign remotes to groups.)
Related Questions

Q4: How do I set object's coordinates?

FlexGraphics - Delphi Graphics Components (CAD, GIS, SCADA, ...
A4: Flex-objects' coordinates are stored in the coordinate system of the parent object. The TFlexSchemes schemes list coordinates and the TFlexScheme scheme coordinates always contain (0, 0), and such system is called the document coordinates system. The units in this system depend on the value in the constant PixelScaleFactor of the FlexUtils module (see Q5) and by default 1000 units correspond to 1 pixel on the screen at the scale of 100%.
Related Questions

Do we have to break ground to install the PERMEATOR unit?

Arid Technologies | General Information | FAQ
No, depends on the specific vapor-piping configuration. If the storage tanks are manifolded underground, no excavation is required. If storage tanks are not manifolded below ground, a small diameter vapor return line can be coaxially located within the existing vent lines or minimal excavation can be used to allow for tie-in of the vapor return line. Third party testing has verified that the evaporative losses are within the range stated above.
Related Questions

Can I leave the unit on the ground when I use it outdoors?

AmpliVox Frequently Asked Questions ? Look here first for Co...
To get the best area coverage put the SW905 on a tripod. You may also put the unit on a raised platform. When the unit is placed on the ground, the usable range is reduced.
Related Questions

Is it really important to ground my Vagabond unit?

White Lightning: Frequently Asked Questions
Yes. The grounding rod is provided for your safety, and the Vagabond unit must be properly grounded whenever it is used.
Related Questions

Q4. - How do I find out my drilling or spacing unit size for a well?

Frequently Asked Questions
Call your State's Oil and Gas Conservation Commission and ask them how to get a copy of a drilling or spacing unit order for the well you are interested in. Here are phone numbers for the appropriate state agencies:
Related Questions

What is the high precision calibration unit and what is it for?

APAS Info
ADI: As with any system, there must be a "calibration" device that is used to calibrate the recorded image. This is simply and object that has points of known distances relative to a single origin. These points are digitized as part of the analysis and are used in the Transformation algorithms to compute the spatial coordinates from the digitized information. Any object can be used for the calibration as long as there are points with "known" X, Y, Z coordinates.
Related Questions

How high is the level of unit control?

FREELANCER: Your tactical source
There is no strict level of unit control fixed. Apparently, each unit can act separately. Squad joint actions are planned too.
Related Questions

What is the high time unit?

Kiwi Feather Propeller - FAQ
While not obvious from an external examination, inside the unit are two dogs and stainless steel torsion spring that allows for 100 deg of rotation between the casting carrying the blades and the boss - which is mounted on the shaft and contains three reversing rollers.
Related Questions

Why do I have to pay if I live on high ground?

City of Colorado Springs - Topic Pages
Every property in Colorado Springs has stormwater runoff that contributes to existing water quantity and quality problems, and to the need to operate and maintain the storm sewer system. Driveways, parking areas and rooftops in every part of the City contribute to the amount of water that must be managed. It is most equitable to have all developed properties pay a fee that is proportional to the amount of water that runs off of each property.
Related Questions

How high does the trampoline stand off the ground ?

Family Trampolines
The 12ft trampoline is 33" (84cm) high, the 14ft trampoline is 36" (91cm) high. We sell a short ladder to make it easier for small tots and less atheletic grown-ups to climb on and off.
Related Questions

How high do you set your hitch ball?

FAQ
First, check the owners manual for your pop-up, it will indicate the correct height that the ball should be when hooked up. These measurements are usually taken to the top of the ball when hitched up. To account for varying heights of tow vehicles and trailer heights, hitch drawbar can be purchased in different heights above and below the hitch receiver. These are known as step up or step down hitches.
Related Questions

Can I use EarthLink High Speed on multiple computers? Can I set up a network?

EarthLink® High Speed - Frequently Asked Questions
Yes, EarthLink Home Networking* lets you share one high speed connection on all your home computers, as well as share files, printers, and peripherals. And with the free wireless equipment that comes with EarthLink Home Networking, you can enjoy high speed access as you move around your home with a laptop, even connecting from the front porch or backyard.
Related Questions

Q4:   Why do I need a Ground Stability Report?

Mining Reports FAQs
Please see our  Ground Stability Report overview  information which explains why ground stability reports are considered to be essential for those assembling Home Information Packs (HIPS) and anyone considering buying, selling or developing any property or site anywhere in Britain.
Related Questions

Got A Question? Ask Our Community!


More Questions >>

© Copyright 2007-2008 QueryCAT
About • Webmasters • Contact