The DVD media might not be compatible with your DVD player. Please choose more compatible media such as Ritek.

With some movies that are recorded over 2 hours long, the data is spread across 2 layers on one side of the disc (dual/double layer). The freeze occurs when the first layer has been read and the player changes to the second layer. It is not a fault with either the disc or the player.

If you pause a DVD that you were playing without importing, then you can resume playback from the "New" tab of the Movie Collections page on the onscreen display, by selecting "DVD in drive" and "Resume Disc".

Our DVD recordable media is compatible with roughly 95% of all DVD players and DVD-ROM drives and meet universal standards for compatibility. Any incompatibility is due to nonconforming players and not the fault of the disc.

DVD-RAM disks are compatible with a very limited number of DVD-ROM drives and movie players. Rewritable DVD-RW and DVD+RW disks can be read by a majority of late model drives and players. The highest compatibility comes from -R and +R media which play in the majority of drives and players. If your drive/player supports RAM, +RW and -RW it will usually be indicated in the manual and/or on the front of the unit.

There can be a large variation in the storage required from one DVD movie to another, but an "average" DVD movie requires approximately 6.7 gigabytes of storage. Therefore, you can expect to store approximately 112 DVDs on a 750 GB Disk Cartridge and 150 DVDs on a 1 TB Disk Cartridge.

Macrovision is a copy protection technology that applies to the analog video outputs of DVD players. Kaleidescape has a Macrovision license and our products have been tested and approved by Macrovision Corporation. That license and certification enable Kaleidescape to apply the Macrovision copy protection technology to a Movie Player's analog video outputs. This has nothing to do with making a digital copy of the information on a DVD disc.

If you've been wondering how all those MBs and GBs stack up when it comes to storing music, you're not alone — it's a common question. "MB" is the abbreviation for megabyte: it's a unit for measuring data. "GB" is the abbreviation for gigabyte, which is a larger measurement of data. There are 1024 megabytes in a single gigabyte. So how much music can a given player store? The basic rule of thumb is "one megabyte holds one minute.

It is likely you are using the coax or optical out from your motherboard. It has been observed on a few motherboard using Soundmax: solution can be find a driver for your motherboard that can fix the problem. One is listed in this thread , see if it works for you

A superior way of viewing video images compared to the traditional interlaced method. Progressive scanning creates a picture signal with double the scan lines of a conventional interlaced picture: 480i (the "i" stands for "interlaced") creates a noticeably sharper image. The 480p ("progressive") image helps eliminate motion artifacts, so even on large screens, the progressive-scan lines are less noticeable and picture flickering is greatly reduced.

No, none of the chips we sell will effect your DVD player, you dvd player will work as good or better then it does now. Yes better then original as some of the products such as the Gameshark2 actually turn your DVD player into a mulitregion DVD Payer allowing your console to play movies from other countries.

For DVD playback you must have installed MPEG2 decoder filters, together with AC3 decoders in your system. These filters are included in Coda Codec Pack. Another possible cause is that your DVD is region-protected and your DVD drive is unable to read DVD's of other regions. To fix this there is a software that will make the DVD seem unprotected to all applications trying to access it (eg. video players). The name of this software is AnyDVD.

DVD's that are produced by any major movie studio are encrypted to prevent piracy. They cannot be played back without the proper keys to decrypt them. There is a program out there called decss that will decrypt and play these DVD's properly, but in the US we have a law called the DMCA (digital melinium copywright act) which prohibits the distrobution of this program, as it circumvents the copywrite protection on the DVD's.

Digital audio (IEC-958 Type II RCA coax [S/P DIF] or EIAJ CP-340 optical [Toslink]). Raw digital audio (AC-3, MPEG-2, PCM, or optional DTS or SDDS) requires an external decoder or an amplifier/receiver with built-in decoder. (Note: The digital AC-3 audio output is not the same as the RF AC-3 output on laserdisc players.) Component interlaced analog video, NTSC or PAL (YUV: 3 RCA connectors, RGB: SCART connector or 3 RCA).

It depends on your audio/video system and your DVD player. Most DVD players have 2 or 3 video hookup options and 3 audio hookup options. Choose the option with the best quality (indicated below) that is supported by your video and audio systems. Progressive video (very best): Playeres have been announced (but not released) with progressive-scan YUV component video output in the form of 3 BNC or RCA connectors.

quot;Dedicated to the generous hearts of all parents and to our sweet children who enter the world with such trust."

If your DVD player was produced in the past 3 years, you have a 99% chance of it being compatible with DVD-R disks. If your disk doesn’t play, it is because of an incompatibility issue, not a problem with the disk. We urge you to test out the DVD in the player you are going to use BEFORE your special event to ensure you do not accidentally have an incompatibility issues. If the DVD does not play, we would suggest you try the disk in a different DVD player

Over 98% of DVD players on the market support our DVD format. If you purchased your player in the last 2 to 3 years, you will have no problem playing your DVD in your DVD player on on a computer that has a DVD drive. If your DVD and it does not work with your player, simply return the DVD to us, and we'll exchange it for a VHS copy.

Nearly all DVD players are DVD-R compatible. Particularly those sold in the last couple of years. You should check your individual model for compatibility before ordering. If you have an older DVD player that is not DVD-R compatible you might want to treat yourself a more modern machine that will accept all formats. They can be bought for under $50.00. Click here for DVD player compatibility information.

The DVD's are region free which means they will play on over 99% of DVD players. This includes the major Gaming Systems (Sony Playstation and Microsoft XBox) If you experience problems with the DVD's we will be happy to offer you a Full Refund.

Kaleidescape Movie Players and Music Players provide reference-quality audio and video output that is comparable to the very best CD and DVD players that are available today.

The maximum playback length of tv-player is limited only by the amount of free available system memory with a maximum total usage of 2 GigaByte (see below). If tv-player operates in YUV 4:2:2 or RGB 16 bit colorspace only 2 bytes (16 bit) are needed to store a single pixel, i.e.: This is half the amount of memory used by any other available player. Even though today memory is not expensive, it is still the limiting factor in playback length of all RAM based players.

Please select a retailer... › amazon (us) › ebay (us) › walmart (us) › ebgames (us) › etoys (us) › k.b toys (us) › buy.com (us) › compusa › jr.

You should check the DMA settings of your DVD drive and hard disk. DMA ( Direct Memory Access ) will dramatically reduce the CPU usage when transferring data. If a high speed drive is not using DMA, it will never reach it's rated speed. This results in decreased performance, since the DVD device depends entirely upon the speed of the CPU. You can download a free utility DVDSpeed to test your DVD drive's real speed. If it's lower than 3x, DVDIdle cannot work properly.

The average length of our DVDs is about 80-90 minutes. Anything longer then that and there is the possibility of visual compression degradation. The period of time we allow for the DVD is ample for the edited video we produce. If you breakdown the parts of the video into scenes, you can get an idea of the average timeline (depending on the chosen package).