Can I set up my own wireless network in my room?
Frequently Asked QuestionsNo, at this time we do not allow access points in rooms due to their potential to disrupt the network. Unauthorized access points will be removed from the network.
Related QuestionsCan the Technician set up my wireless network?
DSL FAQYes. Our technician can turn on the wireless feature in your Qwest modem and configure your wireless devices, such as your wireless card in your computer. One additional computer can be configured, parts not included, at no additional cost. Each additional system can be configured at a special discounted rate. Please contact us for more information.
Related QuestionsHow do I set my wireless network up?
wireless networking FAQsThe wireless hardware we supply is designed for easy self installation. The user manual and quick installation guide provided with your hardware should get you going in no time. We have also put together a Quick Setup Guide for Wireless. If you have any problems along the way, you can get help by calling the Belkin Support line on 1300 554 780.
Related QuestionsTangent: Mobile Wireless Classroom, Wireless Lab - FAQThere are two parts to setting up the network. One, you need to set up the notebooks to communicate with the access point and two, you must set up the access point to communicate with the existing network. The installation of drivers and enabling wireless capability is performed at the factory. Customer must set up access point on-site.Related Questions
WelcomeEnsure that you have "wired" Internet access through your broadband modem before attempting to establish a wireless Internet connection. To complete the installation process, use the order of restarting your wireless equipment as described below, or the connection could fail. Your wireless router might have been shipped with an installation CD. Such CD's usually contain installation and troubleshooting information. Load the required software according to the manufacturer's instructions.Related Questions
What if my computer is set up in one room but the wireless signal is stronger in another?
Roger.com - Business Portable InternetNot a problem. With optional accessories called power line adapters or a wireless router, you can set up the Business Portable Internet modem anywhere in the house, regardless of where your computer is located. Power line adapters use existing electrical wiring to extend the signal from the modem to your computer, without having to run cables through your house. Wireless routers allow for multiple computers to share the same connection, wherever they are located in your home or small office.
Related QuestionsClearwire To Go - Frequently sked QuestionsNo problem - with optional accessories called ClearPlugsTM, you can set up the Clearwire modem anywhere in the house, regardless of where your computer is located. ClearPlugs use existing wiring to extend the signal from the modem to your computer, without having to run cables through your house.Related Questions
What do I need to set up a wireless network in the office?
Real estate - Expert insights - Mobile technology frequently...A wireless LAN consists of two main components: a wireless 802.11 LAN-enabled client, and an access point (this of it as a small antenna). A variety of notebook PCs, Pocket PCs, Tablet PC's, printers and other devices from HP come with wireless functionality built right in. Computers and devices that aren't already wireless-enabled can quickly be made so with the simple addition of a wireless LAN card. The center of the wireless to wired LAN connectivity is the wireless access point.
Related QuestionsCan I set up a wireless network at home (or in my office)?
Sierra Advantage Wireless Broadband -- 1-877-EDC-WISP / FAQ'...Yes, it is possible to have wireless connectivity at your home or office, but specific equipment is required. We recommend that you consult our technical support staff before buying any wireless equipment.
Related QuestionsHow do I set up a wireless router on Cornell's network?
Cornell College - ResNetIf you connect a router to the Cornell network, remember it is very important to manage your router. We suggest that you only allow certain Mac addresses to connect and use your router. The instructions for implementing this will be outlined in the manufacturer's instruction manual or online documentation. You can use these general instructions to connect a router to the Cornell network.
Related QuestionsHow do I secure my wireless network?
Grande Communications - FAQs ; How-TosLimit the number of DHCP addresses to the number of wireless access points that you will be using. Optionally, set static IP addresses, set to non-standard network blocks. Consider using VPN, SSL, Firewalls, RADIUS, Kerberos or other access control, or end-to-end encryption. Most of these can be integrated into your 802.11b appliance.
Related QuestionsWill a firewall protect my wireless network?
Firewall: FAQA firewall will help protect a computer on a wireless network, but will not restrict access to the network itself. You should configure your wireless network to use a network key using either Wi-Fi Protected Access (WPA) or wired equivalent privacy (WEP). For more information, see How to keep others from hijacking your home wireless network or consult the manual for your wireless networking devices.
Related QuestionsHow many people can be on the wireless network at once?
TNS: FAQsThe campus wireless network can handle hundreds of users logged in at any one time, but the more active users, the slower the network becomes. On average, one access point can handle approximately 30 users without a noticeable degradation in performance.
Related QuestionsCan I set up a switch/router/wireless access point in my dorm room?
OIT HelpDesk - Wireless - Frequently Asked QuestionsYou need to be logged in as the administrator and go in the control panel and select admin tools, then services, and scroll all the way down until you see wireless zero configuration. Make sure it is enabled and set to automatic. That sometimes fixes the problem.
Related QuestionsI want to set up a wireless access point in my room. Is this allowed on Resnet?
UT ResnetNo, you may not connect a wireless access point to Resnet (refer to the Management of UTnet Wireless Access pages for more information). Such action will result in service termination. However, you can access Resnet wirelessly from any dorm, and if you need wireless access outside of the dorms, visit the Public Network Web site to find a coverage area close to you.
Related QuestionsHow does Network Magic protect my wireless network from intruders?
Network Magic - Frequently Asked Questions - FAQMore and more intruders are tapping into unprotected wireless Internet connections. And anti-virus software protects a single computer, but not your entire network. Network Magic helps keep your wireless network and data safe by detecting when an intruder attempts to log on to your network and alerting you. Once detected, you can allow the computer on your network (for example, a visiting friend), or kick it off.
Related QuestionsHow do I set up my notebook computer for Pharos printing through the wireless network?
The George Washington University Law School - Computing Serv...The Help Desk in Burns 204 is your primary provider of printing assistance. They regularly monitor the printing supplies, but should be notified quickly if any unforeseen shortages occur. Access to the storage containing the printing supplies is restricted, so in the absence of Help Desk support (i.e., during late night extended hours for exams) there may not be anyone available to re-supply the printers. If foreseen, the Help Desk may place extra supplies near the printers for self-service.
Related QuestionsHow do I set up my computer to access UW's campus wireless network?
WCER - Technical Services FAQsThe DoIT wireless support page provides a good overview of how to connect to wireless UWNET (wireless WiscWorld).
Related QuestionsHow should I set up my laptop to connect to the wireless network on campus?
Res Tech FAQ PageFor information on how to set up your laptop on the wireless network at Mason, how to secure your computer on the wireless network, coverage areas, and wireless FAQs, see http://itusupport.gmu.edu/wireless_network.
Related QuestionsHow do I set up my WiFi wireless card to work with the EthoStream Hospitality Network?
Welcome to EthoStreamI wanted to send you a quick e-mail and let you know how extremely satisfied I have been with the service that Jason Tienor and his entire Team at Ethostream. Jason's entire Team has responded to our request for service in Green Bay and quickly was able to get out to the job site to stay ahead of the sheet rockers. All too often we only tend to contact the Brand due to negative issue and felt that you should hear about this awesome service that they extended to us.
Related QuestionsHow do I set up WDS with my current wireless LAN (WLAN) network?
Cisco - Wireless Domain Services FAQIn order to set up WDS, you must designate one AP or the Wireless LAN Services Module (WLSM) as the WDS. The WDS AP must establish a relationship to an authentication server through authentication with a WDS user name and password. The authentication server can be either an external Remote Authentication Dial-In User Service (RADIUS) server or the local RADIUS server feature in the WDS AP.
Related QuestionsDo I need a wireless network set up in my office to use Mobile-DBA?
Mobile-DBA Wireless Handheld DBA tool for monitoring an Orac...No. Mobile-DBA is network independent and operates on both wireless LANs or cellular networks. If you don't already have a WLAN in your office then all you need is a wireless device with a wireless card (CDPD, CDMA, etc.) and an account with a wireless carrier like ATT, Cingular, Sprint, ..
Related QuestionsHow do I set up my wireless device to connect to Cornell's network?
Cornell College - ResNetYou can use our Wireless Network instruction page for directions on setting up your device (generally a laptop or pda) for wireless access to Cornell's network.
Related QuestionsCan I use any wireless receiver to connect to the campus network?
VPN-FAQProbably. Any wireless receiver supporting the industry standard 802.11b or 802.11g protocols should work. However, in rare cases, we have found wireless receivers which had compatibility issues with the computer upon which it was installed.
Related QuestionsIs NetStumbler a wireless network cracking utility?
Wardriving FAQ by Jeff Duntemann (Wireless LAN Security & Wa...Emphatically not. Netstumbler is a good and courteous listener. It only records those elements of data that the access point (AP) makes public. It has no machinery for sniffing packets, reverse-engineering passwords, or even connecting to an unprotected network. Furthermore, NetStumbler respects the wishes of network owners in terms of the public visibility of their networks: If the owner of an AP disables the AP's beacon broadcast, NetStumbler will not detect it.
Related QuestionsCan I print from the wireless network?
Wireless FAQNo. The best solution to this problem if you must print immediately is to transfer your document to a floppy or USB flash drive and bring the disk or drive to the Academic Technology lab on the ground floor of the library for printing.
Related QuestionsCan I do email over the wireless network?
Wireless FAQIf you are using web-based mail, then the answer is yes. For security reasons many non-standard Internet ports are blocked on the wireless network, so non-web-based email will not work. We recommend that you do not try to download large email attachments or run streaming media over the wireless network.
Related Questions