Search 5,000,000+ questions and answers.

Frequently Asked Questions

HOW LOUD IS YOUR ARRAY?

Dakota Audio - Focused Sound - Exhibit Sound - Museum Sound ...
Due to safety considerations, since our arrays are often used in areas where children are present, we limit the maximum output to approximately 90 dB in the target area.
Related Questions

Will it be too loud?

Rock N Roll Dating
We make sure to limit the sound levels in the room to a level where you can both enjoy the music and talk to your date without going deaf or having to scream bloody murder. Also, free earplugs are available at all of our events (just in case).
Related Questions

Useful information written by Alan Garner Professional Trave...
Generally, any disco will be loud, however, if at any point during the event, you feel that it is too loud or guests have complained, I won't be offended if during the night, you ask me to turn it down, nor, will I turn it back up again five minutes after you ask either!
Related Questions

Faqs
With most devices, the HS92 speakers are plenty loud. If your audio device was specifically designed for ear buds or isn't putting out enough watts, you would want to purchase our HS24 Iasus speakers. Our helmet speakers can be compared side-by-side at HelmetSpeakers.com.
Related Questions

The alarm is a siren that is inbuilt into the unit, it is 110Db, so its is very loud on the scale of warning sirens.
Related Questions

Coila - FAQs
We supply enough volume for the dancers while allowing guests that want to sit and chat to do so. If you want more or less volume, then let us know on the night.
Related Questions

California BMW Triumph Motorcycles | Shop | Staintune Freque...
Staintune pipes decibel range will vary depending on the bike, and whether or not you use the sound restrictors. On average, as a general rule, the pipes run in the low 90's with the restrictors in place and just over 100 with the restrictors removed. This is a general rule of thumb and can vary up or down depending on the individual bike. A Ducati twin will definitely be more heart and ear pounding than an inline four BMW. The design of the engine can vary the number a few decibels +/-.
Related Questions

Untitled Document
We play traditional instruments including acoustic bass - so there's no rock bass and drum to worry about! We can play an acoustic set - i.e. without a PA system. However, this is only suitable for very small venues. We normally use a high quality PA and play at the appropriate volume given the audience and venue - we will always turn it down (or up!) if asked! We are happy to discuss our PA requirements with your venue management in advance of the event.
Related Questions

ThrustPac
The THRUSTPAC motors are very quiet. The propellers make the sound you are familiar with on an airplane. We like the sound as it alerts pedestrians and motorists we're coming and they're more aware and cautious because of the attention we receive.
Related Questions

What is an array?

Qbasic / Quickbasic News - Learning Center - FAQ
array is a list of data item inmemory that all have the same name and whose elements are differentiated by a subscript. In simple terms, an array can be anything that is a group of related numbers such as prices, phone numbers, catalog order numbers and the list goes on and on.
Related Questions

ListenUP! Canada : Frequently Asked Questions
Sounds are measured in decibels (dB's). For example, the wind in the trees is 20 dB; a person talking is approx. 55 dB; a chainsaw could be measured up to 95 dB and a single handgun blast can be as much as 160 dB! Short exposure to a noise of 120 dB or above, without hearing protection is highly dangerous and can result in permanent damage.
Related Questions

Canadian Academy of Audiology - FAQ - What is noise?
We measure sound in units called decibels or dB's. While there are laws guiding the amount of noise a person can be exposed to in the workplace, noise is considered to be too loud if the sound is over 85 dB and hearing protection should be worn. To give you a reference, the wind in the trees can be 20 dB; a person when talking can be 55 dB.
Related Questions

Cold Jet - Frequently Asked Questions
Noise is a function of air volume and air velocity. Within the nozzle, the stationary air is sheared by the high velocity air causing turbulence which creates noise. With appropriate hearing protection an operator can safely operate the system all day.
Related Questions

Technical Support
It can be extremely loud, but it depends on your headphone impedance and sensitivity. For a list of the most popular headphones, and the SPL expected from each, See Understanding Headphone Power Requirements.
Related Questions

How loud should my system be set when I use the analyzer?

Technical Support
Basically you want the PA set for a normal "playing" volume. Don't get ridiculously loud but have the system at a level loud enough to overcome any background noise.
Related Questions

How noisy are they... are they loud?

WWW.RCHELISPOT.COM :: View topic - Frequently asked beginner...
All model helicopters are flown with mufflers (quieter but with a little less performance) or tuned pipes (somewhat louder but with more performance) and on the average are quieter than a similar size model airplane. Generally speaking the noise level is acceptable to most people.
Related Questions

Trumpet and Brass Playing Articles - Brass FAQ
If your playing is out of control and your sound is unfocused and spread you are too loud. If your pitch is not on because of playing too loud you are working against yourself. Playing in tune with a good sound has more to do with projection than brute force. Look at the Chicago Symphony brass section and notice how they can produce more sound with better quality than an entire marching band. It is skill and precise pitch.
Related Questions

What is a DNA array?

The Bioinformatics Resource
Thanks to Bioinformatics.Org member Ravi Jain for the following answer, which I present verbatim.] DNA microarrays consist of thousands of immobilized DNA sequences present on a miniaturized surface the size of a business card or less. Arrays are used to analyze a sample for the presence of gene variations or mutations (genotyping), or for patterns of gene expression, performing the equivalent of ca. 5 000 to 10 000 individual "test tube" experiments in approximately two days of time.
Related Questions

Bioinformatics FAQ
DNA microarrays consist of thousands of immobilized DNA sequences present on a miniaturized surface the size of a business card or less. Arrays are used to analyze a sample for the presence of gene variations or mutations (genotyping), or for patterns of gene expression, performing the equivalent of ca. 5 000 to 10 000 individual "test tube" experiments in approximately two days of time. Robotic technology is employed in the preparation of most arrays.
Related Questions

What is the function of the array?

Alternative Med Concepts - Alternative Health Products
The array is the conductive transfer unit of the direct current into the water which generates the ionic field and hence transfers the energy into the body.
Related Questions

MP3 - How loud is too loud when the volume wheel tells me nothing?

Dangerous Decibels: Frequently Asked Questions
A rule of thumb is if you can not understand someone talking to you in a normal speaking voice when they are an arm's length away... it is too loud. This rule works with standard earbuds and headphone. If you are using noise-canceling headphone, see the following rule of thumb.
Related Questions

what's the difference between array and &array?

Arrays and Pointers
Under ANSI/ISO Standard C, &array yields a pointer, of type pointer-to-array-of-T, to the entire array (see also question 2.12).  Under pre-ANSI C, the & in &array generally elicited a warning, and was generally ignored.  Under all C compilers, an unadorned reference to an array yields a pointer, of type pointer-to-T, to the array's first element. (See also question 2.3.)
Related Questions

Is the MAD Array a Line Array?

Frequently Asked Questions about MAD Speakers
Yes, but it goes beyond this and it is more proper to say that the MAD Array is a Planar Magnetic Surface Array™. It works as a line array in both vertical and horizontal direction. Directivity, control, and throw of the sound are much better than in other "classical" line array systems. The MAD Array can project sound hundreds of feet away without losing sonic details.
Related Questions

Is your band really loud?

Hooch - Southern California's Premier Cover Band! Frequently...
We are a live band, and we get fairly loud, but not ear piercing. If noise complaints from neighbors becomes an issue, we can play indoors, or acoustically to remedy the situation. Usually, things go fine. Index
Related Questions

Why don't they tell us out loud what the NTI is anymore?

Miscellaneous: World News Now FAQ
Recent executive producer Ray Brune didn't care for the NTI, not understanding its usefulness and importance. While strong viewer outrage kept him from dropping the NTI altogether, he did not accept that it must be part of World News Now. His successor, Bret Marcus, has not changed the NTI policy.
Related Questions

Got A Question? Ask Our Community!


More Questions >>

© Copyright 2007-2008 QueryCAT
About • Webmasters • Contact