The Indiana-American Water Company reads the meters and bills the customer each month. This is a private company, and for information and questions you may call them at 1-800-492-8373.

For the remainder of the year bills are calculated based on estimates. These estimates are arrived at by taking an average of the consumption of previous bills. Customers are encouraged to phone in their meter reading to 786-1739. On the water bill there is a section at the bottom called "important notes", this will give the date as to when the readings should be phoned in.

Your meters usually are read about the same time each month. You can contact PNM Customer Care to obtain a meter reading schedule.

Yes. Reading a meter is easy to do once you learn how to do so. It also can help you better understand how you're being charged for your energy use.

Each city, county, and property is different. There are many ways in which meters can be read. The following are some examples: Manual Meter Reading System: a meter reader will walk up to your meter or remote counter and read it. Automated Meter Reading System: generally the meter is inside a dwelling or enclosed area that is not accessible. The meter is wired to Meter Counter Modules (MCM) located in the maintenance room of your building.

To find out more about water meters, see our water meters Web page, or send us an email to request an educational water meter video.

Water Services reads meters on a monthly basis, usually the third week of each month. The city uses a "touch-read" system for reading the meters. The data is uploaded into a data box from a wand that is touched on the top of your water meter box. This is why it is important to keep the top of your meter box free of landscaping. The data is then uploaded from the data box to the city's finance system, which in turn generates your bill.

We require meters to measure water use, establish equity in paying for water used by each service, and to encourage water conservation.

Yes, all meters are read every month. When our meter readers used to read with books and pencils, they were able to do "bar stool" readings (not all did!). That was sitting in a restaurant somewhere and making up readings for customers based on their past usage. With their new hand held computer units it is impossible for them to guess at what the meter reading is.

Your local utility will continue to read your meter and is responsible for sending your usage information to your new supplier.

For units that have been purchased after 2000, when you open the cap (not the battery end) there will be 4 switches on the opposite side of the circuit board from where the cap snaps in. The 2nd switch from the right (or the 3rd switch from the left) is the unit of measure switch. For Meters, push the switch back (away from you), and for Feet, pull the switch forward (towards you).

Every single 800 Series Sierra Flow meter is calibrated on a Primary Standard. Sierra does NOT use transfer standards. We can not stress how beneficial this is to YOU as the end user! The reason nobody else calibrates EVERY meter on a Primary Standards because the cost to calibrate Flow Meters with Primary Standards is IMMENSE however it is TRULY the ONLY way any company manufacturing Mass Flow Meters with accuracies of 1% or better could justifiably make such claims of accuracy.

Yes. The meter pulse relay can be used for any pulse-initiating meter until other Eka Systems’ products become available. The meter pulse relay will easily adapt to gas and steam meters. We expect our gas submeters to become available in Spring 2003, and our water submeters to become available in Fall 2003. These components, when available will fully integrate into our network.

Yes, all the water connections are required to be fitted with meters. However, some of the domestic connections falling in Rural Areas, Slums Rehabilitation Colonies, Janata flats etc are sanctioned without meters.

The City owns meters ranging from 5/8" through 4". Meters larger than 4" and all fire line meters are owned by the customer.

We typically field test meters 3" and larger every two years for high consumption users; every three to four years for small water users. Meters 1-1/2" and 2" are tested every five years if they are between 15 - 20 years old. Newer meters are tested every ten years.

Generally, the water meter nearest to your property is your water meter. To verify this, turn on a spigot inside your house or at the outside hose bib. While the water is running, go out to the water meters and observe which one is registering (i.e., the meter register is changing numbers or the leak detector is spinning).

Yes. Meters are factory tested and calibrated to be within accepted standards of accuracy. Moreover, the utility must maintain its meters within those accuracy standards specified in the Utility Tariffs.

You can have as much land as you choose. Change the amount of land you have and your monthly fee will adjust accordingly. See Virtual Land: Cost.

Unfortunately color meters available to cinematographers are far from being scientifically accurate when reading fluorescents. They act as a great comparative tool to determine differences between two given light sources but are inadequate in providing definitive data. You will rarely find two color meters, even if they are the same make and model, that provide equal data. Results between meters may be similar but not identical.

To provide a more equitable system, Council was concerned that smaller families, especially seniors and those on fixed incomes, were subsidizing large families and the commercial sector.

Nowadays, it is vital to have an online presence. A corporate web site gives your water company a more professional look. It provides your existing customers with an online resource for updated company information, monthly promotions, and even perhaps a monthly newsletter. Potential customers can take a look at your company, at their convenience, and see all the products and services that you have to offer.

You mean in addition to the Virtual Book Club? The 2008 novel will be TOUCHSTONE, a stand-alone set in 1926 England when the General Strike threatened revolution and terrorism waited in the wings. CBS, which had optioned Keeping Watch, has decided it will not be making movies for a while, so there are currently no projects underway, although much discussion in various directions.

One of the important outcomes of the programme is the efficient use of freshwater. To achieve efficient use it is crucial to gain an insight into the actual amounts of water used by major water users, such as irrigators, hydroelectricity companies, and city and town water supplies. The programme proposes to investigate the use of methods to measure the use of water so that we have consistent data around the country.

in any purchase, talk to your friends and neighbors -- who do they use? Are they happy with them? Check with the Better Business Bureau for complaints. The BBB can't prevent shady business, but they can and do keep a file of complaints filed by people who have had dealings with them. Ask at least two to come to your home to look at your plumbing and then give you a quote on their equipment. Have them explain all the features of the unit, as well as the warranty.

This can appear if either the cabin or the premises were locked, or it was not possible to read the meters. However, if the meter is unread, the consumer gets a bill, which is based on his previous billing pattern and could be comparatively lower or higher. The corrective adjustments for the same are made in the next bill.

Every pit situation is very different --- the make-up of pit materials, surrounding environments, etc influence a radio signal --- so results will vary. Extremes can be from a few feet to more than one mile. The average installation yields perfectly acceptable results.

The measurement principle of the VapoMeter differs completely from the conventional devices in the market. It is a closed chamber system that calculates the evaporation rate from the increase of relative humidity in the measurement chamber. Compared with the open chamber technique the measurement time is shorter, the device is smaller and portable and ambient air flows do not disturb the measurement.

I have read many highlights of the Energy Policy act of 2005 and they all mention "Federal Facility Metering - By October 1,2012 Federal facilities need to be metered". I looking for any recent metrics done on the higher education sector for energy use/cost indexing for research labs, dormatories, arenas, classrooms, dining halls, etc. for the northeast region of US. I'am the building engineer at a larger building in Lincoln Nebraska.