We could probably accommodate requests for any weight of manikin up to 100Kg; anything not from our current range would certainly be more expensive and would not have the weight screen printed on the warning label on the head.

Yes! Use an automotive paste wax like Turtle Wax on the areas of the vinyl skin where the pads are to be placed. The pads will peel off easier, too.

Yes we now produce an excellent carrying bag for the dummies, they make moving the dummies far easier for two people.

No- the typical stock speaker weighs about 35 grams. Our ANR units weigh 34.6 grams, so the overall effect on the weight is negligible.

If you replace the clunk fuel line with thicker/stiff fuel tubing and you plan on doing 3D, then you might need a heavier clunk like the KSJ 537.

All the different models are made in exactly the same way, with an innerbody weighted with aggregate to human proportions, held inside the outer carcass. The aggregate is distributed around the body in weighted packets in such a way that slumping of the weight is prevented, allowing the dummy to maintain its form during and after use.

Make the nut slots slightly wider. Not doing this will cause extra pressure on the nut, which can cause the nut to crack, particularly on the lower strings. This is best accomplished by using a file. Be careful not to widen it too much! You should also check the intonation, which will probably need to be adjusted. That is covered in another FAQ.

Follow CDC protocols for disease control, and manikin instructions for maintaining best protection. Airways must be replaced according to instructions to remove any chance of bacteria growth and contamination. Use household cleaners like soap and water, 409, Fantastic, or others to remove dirt and grime from the manikins. Laerdal adapters function only with Heart Stream models. Heart Start models will not work.

The Safety Chair models all have multiple points of lift to employ up to 6 points of lift to transport heavier passengers. Should there be a tight stairwell, the extra lift points can be quickly and easily removed using our quick detach system. The Safety Chair models are the only evacuation chairs on the market designed to easily relocate or evacuate a passenger all while keeping optimum ergonomic lifting position in mind.

Apparently, the medication prescribed to control Jeremy's bipolar disorder built up in his system over time and wreaked havoc on his heart, causing him to retain water. This explains his bloated appearance in many later episodes. When Jeremy's heart began to fail, his medication was adjusted. Heart medicine and diuretics were prescribed, and his weight returned to nearly normal (unlike his health, unfortunately).

USE THE ABOVE MENTIONED FORMULA TO CALCULATE THE NUMBER OF VE NEEDED. FOR EXAMPLE: HOW MANY VE DO I HAVE TO USE IF I HAVE TO SUPPORT 96 POUNDS? EACH VE SUPPORTS 12 POUNDS; 96 POUNDS :12 = 8. IN GENERAL, IF YOU ARE CLOSE OR AT THE MAXIMUM WEIGHTBEARING CAPACITY OF A VE, USE AN EXTRA ONE. NEVER SAVE A FEW DOLLARS TO COMPROMISE THIS IMPORTANT ISOLATION STEP. YOU CAN PLACE THREE ON THE FRONT PART OF THE SHELF, THREE IN THE BACK AND THREE ALONG THE CENTERLINE OF SHELF.

The pattern and flow of your periods will change throughout your life cycle and is usually normal. Most women find that heat application is comforting and Ibuprofen 800 mg (4 over-the-counter tablets) every 8 hours will help relieve cramping and decrease bleeding.

MiraClear II (M3000) and ZOOM Clear (V2010) are both high-solids urethane clears. As such, there are fewer solvents in the formulas, making the end products heavier, or higher in viscosity. You may need to adjust your application technique when using these products. In some areas, you may consider reducing the activated clear by about 5%-10% with a urethane-grade reducer, but first check local environmental regulations to ensure this is within your local V.O.C. limits.

The three main types, Flame Retardant (FR), Water Rescue (WR) and General Purpose (GP), all use different materials; the GP manikins (our most popular models) use heavy duty canvas, Nylon and polyurethane foam, whilst the FR models are made using a mixture of glass fibre, Kevlar, PBI Gold and heat resistant foam. The WR manikins use P.V.C, Nylon mesh and non absorbent foam. All manikins apart from the FR models are reinforced using high density polypropylene webbing.

Yes we have a rescue training dummy risk assessment and an equipment note covering the whole dummy range, this information can be found at the bottom of the Rescue Training Dummy page.

A range of accessories are available for Ruth Lee rescue manikins: Kevlar lined leg protectors, thermal tabards and heat packs, injury armbands and weighted vests in both 10 and 20Kg weights.

Yes, we can provide N.S.N numbers for the RL50 and RL20 general purpose manikins, we can also supply them for the water rescue man overboard model.

Because the Water Rescue manikins are made from a tough Nylon mesh, water will very easily drain from the carcass; holes are also drilled in the Wellington boots to aid the process. with all the manikins, we recommend that they are hung up to dry using the webbing loop on the back of the carcass .

CPR manikins may be purchased from EMS Safety Services. The manikins retail for anywhere from $35.00 to $422.00 depending on your training needs. It is recommended that instructors purchase manikins and keep them available for upcoming classes. Once you purchase a set of manikins, you can rent them out to new instructors to help generate money for your business.

The recommended temperature range for usage of CPR Prompt manikins is from 40 to 100 degrees Fahrenheit. If the manikins were exposed to very cold temperatures, they would not be damaged, however the chest compression piston will be stiffer until it warms up.

To relieve aches and pains with hot fomentation treatments, it is necessary for the heat to effectively transfer deeply into body tissues. To make the Thermophore pack more efficient, we have positioned weights to cause the Thermophore pack to conform to body contours. This reduces air spaces between the Thermophore hot pack and body; so more heat is transmitted to the body tissues. Ordinary stiff plastic heating pads leave air pockets. Which result in uneven transfer of heat.

Because it's thicker, the DR® cord is much longer wearing. You can trim along stone walls and foundations without it quickly wearing out and breaking, the way ordinary and thinner cord does. This means you change it much less frequently. The thicker DR® cords also enable you to mow thicker, fibrous vegetation that would easily cause the cord on ordinary trimmers to wrap and break.

In bull-baiting, when the bull attempts to shake the bulldog off, it would be less likely that the dog's back would be broken.

Whilst modifications to the pinion valve are sometimes possible, it is both difficult and expensive to do.

Today players demand fabrics that are comfortable and have fabulous performance on and off the field. We continue to conduct research for fabrics that do more than just look good. TotallyField Hockey features four of the best high-performance, all-season fabrics: Premier Pique, Premier Air, Pro Diamond and Jogo Air. These fabrics are engineered to achieve and maintain a comfortable climate between your skin and the Field Hockey uniform.

Not necessarily. When woven tarpaulin fabrics are made, tapes of polyethylene are loomed to make the woven base or scrim, much like they are with clothing fabric. Once the scrim is made, it is then coated with a layer of polyethylene. This makes the fabric an impermeable membrane. In the lighter weights of fabrics, both the scrim and the coatings are thinner, making the physical properties, such a tear strength and mullen burst rather low.

Some composite products are heavier than wood but many are lighter. Regardless, each deck is constructed with the span length of the product and the weight of it taken into account.