Yes. Almost all software designed for Windows 95 will run well (sometimes even better) under Windows 98. There are a few cases with various utility programs in which you will need to check the companies website for an update. With Windows 98, you can use more than one monitor at a time. You can spread out your work (and play) across your monitors, just as you might spread out papers across your desk.

The interfaces are similar. But the Windows 98 interface is more like a Web browser. So you can use the same navigation and viewing techniques whether you're searching your hard disk or the Internet. Most of these options can be adjusted or switched off to resemble Windows 95. Don't worry. Windows 98 setup will have an FAT16-to-FAT32 conversion process.

I boot with Knoppix from the CD drive. Once it has fully loaded to the KDE desktop, I open a konsole command window.

Yes. Windows 98 has built-in support for digital video disc (DVD) drives. One DVD can hold about 15 times more information than a CD. An entire movie - with full-motion video and lush surround sound - can fit on just one disk. Note: Windows 98 own DVD Player does not have great support for a variety of DVD Decoder cards - only a couple are currently supported, this will change in both the SP 1 and OSR releases.

Casper Tech Edition has full support for cloning Windows 95, 98, and ME systems, including dual boot cofigurations consisting of Windows 2000/XP/Vista and Windows 9x/ME. While Casper Tech Edition is designed to run only on Windows 2000, XP, Vista, and later platforms, the Casper Tech Edition CD may be used to boot and run Casper Tech Edition on a Windows 95, Windows 98, or Windows ME system. Yes.

Yes, as long as it is installed on a 1.9G or smaller hard disk partition. Large hard drives can easily be partitioned using Partition Magic or Partition It without any loss of current programs or data. (Lesspace.com is not applicable to Q&A for Windows.) More details are in the August 1998 issue of The Quick Answer. For setup and configuration details on running Q&A in Windows, see Setup Q&A to Run On Your New PC.

There is limited support of MIMIC on Windows 95 / 98 / Me as documented in the online documentation Windows Installation Instructions. Windows 95 / 98 / Me will restrict you to running only 10 agents. If you want more then that you will need to use Windows/NT or Unix. Under Windows 9x you have to manually assign IP addresses which means you have to reboot the system everytime you change it.

Yes. It has been tested under a variety of configurations. Note however, that since the Windows environment is so diverse we cannot possibly guarantee all functionality under all conditions. If you encounter a problem, please let us know. If you want to be kept up to date on official releases, please subscribe to the mailing list. If in doubt, feel free to try out the freeware version to see if it meets your needs.

No. The Commander NE system will not run on Windows 95 or 98. It will run on Windows 2000 Professional. We recommend Windows XP Pro or the new Windows Vista as your Windows operating system.

YES. WE ARE IN NEED OF THE CERTIFICATES TO GIVE OUT WITH THE COMPUTERS DONATED TO KIDS TO MAKE SURE WE STAY LEGAL.

Yes, IrfanView is compatible with all Win9x- and later Windows versions. Win9x means: Windows 95, 98, 98 SE and Windows ME.

Windows XP is an upgrade for almost every 32-bit version of Windows; you will be able to upgrade Windows 98, 98 SE, and Me to Windows XP Home Edition or Professional. You will also be able to upgrade Windows 2000 Professional and Windows NT 4.0 Workstation to Windows XP Professional as well, but not to Home Edition. In case it isn't obvious, then, Windows 95 and Windows NT 3.

No, even though Windows Me ships with a newer version of DirectX 7, there is little speed increase in any game we have tried out, the main difference is stability across all fronts.

While Casper can be used to clone all versions of Windows Vista, Windows XP, 2000, ME, 98, and 95, Casper will not run on Windows 95, 98, or ME systems. These platforms may be cloned only when running from the Casper Startup Disk or by using the included Drive2Drive. Yes. Casper supports cloning of various mutiple boot configurations, including multiboot Windows Vista and Windows XP/2000, multiboot Windows XP/2000, and dual boot Windows Vista/XP/2000 and Windows 9x/ME configurations.

Last time I tested, Behold was still working under Windows 98. Over time, more incompatibilities will arise. It is unfortunate, but to fully support XP and Vista, poor old Windows 98 loses out. When off in the future, I finally add Unicode to Behold, that will probably spell the end of 98 support. But that's probably over a year away. If you don't upgrade to a new operating system by then, you're going to be having more problems than just worrying if Behold will run or not.

Even though the PDF literature and Senao data sheets say the cards support Windows 95, they DO NOT. We've had several problems with Windows 95 drivers, so we do not recommend using our products with the Windows 95 operating system. We have also had some problems with Windows 98 machines. Remember these operating systems were invented before wireless or broadband communication was available.

We have experienced countless problems when running CAREWare on a Windows 98 system. Because of this, we will not be able to provide technical support for CAREWare users who use the Windows 98 operating system. In the server.config there is a connectionAgeLimit which is set to 120 by default. Increase this number to 600 to resolve the error. This exception is a result of a slow server, or a request that takes longer than the allowed timeout.

Microsoft SDK or Gnu SDK (only assembler, linker, make utilities and C libraries required). Microsoft SDK recommended. opengl32.dll og glu32.dll is required to run openGL programs. [new feature in r4.2] For more information, see W02. W02) SDK Requirements for Windows 95, 98, 2000 or Windows NT In order to use the Mjølner System you need to have an assembler, a linker, a make utility and C libraries from Microsoft or Gnu. The Microsoft utilities are recommended. ML.

In the middle section labeled How do I dial from this location put a check in front of the line that reads This location has call waiting. In the box next to To disable it, dial: set it to *70, (for tone dialing) and click on the OK button.

There is no version of Q&A designed exclusively for Windows 95, 98, 2000 or XP. All versions of Q&A run well in Windows 3.x, Windows 95, 98, 2000, and XP as long as Q&A has been properly installed and set up. (Q&A will not run on NT Workstation but can be installed on NT Server and run, for example, on Windows 95 or Windows 98 workstations.) All Q&A files, including temporary files (those that Q&A creates during certain operations) and database files, must reside on a 1.

To see the list of current variables, type "set" at a command prompt, with no parameters. To set a variable, use the command: set my_file_dir=c:\transfer To use a given variable, precede and follow the variable name with the percent sign. For example, if you want to see the files in the directory you had defined as "my_file_dir" you could type this command: dir %my_file_dir% And if you just wanted to know what one specific variable was set to, you could use "echo", like this:

None of the above software will be compatible with Windows NT. At this time there are no drivers available to make these software programs compatible with Windows NT. There is an update available for the Picture Navigator software to work with Windows 2000 and XP in the Customer Support area of this site. (When executing the update be sure to have Picture Navigator closed).

A. We left Windows 95 support, as this operating system is out of date at present. Our program may function under MS Windows 95, but we strongly recommend to upgrade your OS at least to MS Windows 98 Second Edition.

No, the system is designed to run on Windows XP, Service Pack 1 or greater, and Windows 2000, Service Pack 3 or greater.

At this stage only POP3 is supported. For Hotmail and MSN support as well as future IMAP and AOL support, you can purchase MailWasher Pro. You may not have specified a default email client, to change this you will need to fiddle with the registry, but its not too difficult. Uncheck the options labeled Send and receive messages at startup and Check for new messages every ( ) minute(s).

On Windows 95, 98 and all newer Windows versions no problems running the 32-bit mIRC (mirc32.exe) are to be expected. By default Windows installs all things you need when you install your modem (or network adapter) and Internet software. It does not matter what kind on Internet connection you use. mIRC works fine with modems, cable connections, DSL, ADSL, and all sorts of network solutions. trv