Most manufacturers say that the chairs should be given a rest after about an hour, to avoid overheating. Most massage programs are less than a half hour though, and overheating is rarely a problem.

The 15 kW system was designed for batch rather than continuous operation, however, our 50 kW system is designed to operate 24 hours per day, 6 days per week. The longest that the current pre-commercial 15 kW system has been operated at full power, on 100% biomass, to date is 100 hours, and 149 hours for the 50 kW system. The need for continuous operation increases with system size.

It will not harm the motor but be careful not to over humidify your home. Go by the guidelines in the instruction manual for recommended relative indoor humidity levels.

Yes, inradisk was especially designed for this kind or operation! The integrated hard drive will be switched to stand by after an idle time of about 20 minutes, it will stop spinning to save power. External USB drives can not do this! backup, media server or data archive, that will access and spin the drive for only about 2,400h per year, there is no limitation. The mentioned 2,400h per year actually conforms to the average operating time of a standard PC.

Not generally. John Zink burners are designed for stable operation with or without a pilot. However, your facility may have its own rules about continuous or intermittent pilot operation. If your burner appears to be unstable without a continuous pilot, the instability may signal a serious safety condition that must be remedied. John Zink has an array of pilots and ignitors designed to provide optimum performance and safety.

If you turn a radon fan off, the radon levels will return to the pre-mitigation levels within a few hours. In addition, ground moisture will begin to enter the bearings and motor, causing a pre-mature failure of the fan so it is best to keep the fan running even if you go on an extended vacation.

The slings can be safely worn all day. While most people report immediate and complete relief from the pain of sitting slouched, you can realistically expect the benefits to continue as long as you wear the sling. And when you stand up or walk after using the Nada-Chair, it is not uncommon to feel a "halo effect" of well being and good posture for sometime thereafter.

Unfortunately there is no set answer for this question. The Onan portables are designed for long life, heavy-duty operation, and long run times. Gasoline units should be shut down during refueling to reduce the potential for starting a fire by spilling gasoline on hot exhaust components. The oil level should be checked and the unit inspected for signs of fatigue or abnormalities (cracked receptacles, etc) before restarting.

lt;If freezing you should turn off the pump, remove it... if freezing to more than an inch or permanently, remove the livestock (including plants) to elsewhere during the cold season... Please, PLEASE read: http://www.wetwebmedia.com/PondSubWebIndex/pdwintmaint.htm> I think its going 2 die. What should I do? How do I know that the fishes are sick? Please help.

Below the balance point, around 30 ? F it is normal for the outdoor fan to continually run. If the outdoor unit continually runs during normal heating (30 ?-50 ? F outside), possible problems are:

There is no time limit for use, and given that a few basic steps are followed, the unit can run continuously . . . Just adding more melted chocolate to the basin will allow the unit to continue to provide the chocolate flow basically non-stop. If you need to stop the flow for any reason however, (e.g. two functions held on the same day, or unit is used by a candy business where overnight stoppage is necessary) then the following procedure is applicable. The mechanical operation is stopped (i.e.

This is usually due to a bad triac or relay in the gate controller. Swap controllers with a working gate to determine if this is the case. The limit switches may not be functioning properly. Check the limit switches to make sure that they are being actuated by the cam on the gear shaft. Make sure that the cable to connect the limit switches is connected to the gate controller and is firmly seated in its connector.

For standard chairs, it usually takes a minimum of seven business days in Canada and the US. For custom chairs, and anywhere outside of Canada and the US, please inquire. Yes. Broda does offer free, no obligation chair demonstrations and evaluations in most areas of local representation. If you are interested in a chair demonstration or evaluation, or would like further information please contact Broda or your local area representative (See Sales and Service page for your local rep).

There is no set answer to this question. FG Wilson generators are designed to last for long periods of time and function in heavy duty operations. However, it is important that the set is inspected regularly between each use, before restarting to check such things as fuel and oil levels and any signs of abnormalities. FG Wilson sets can run continuously when the amount of load is lowered.

We have done duty testing with a Qwerkbot Classic, operating (on AC power) continuously, for 7 days straight, 24x7, and it has continued working for that entire time. The on-board embedded system cannot run forever, but 7 days or less is clearly just fine. We will be adding functionality so that it can also restart itself, so that its total "autonomous" life can be extended effectively infinitely.

Of course it depends on what "loose" is. Most chair repairs can be returned within a week or less, barring the need for ordered or custom made parts.

This depends on the present physical condition of your back-supporting muscles. In most cases the first adaptation phase lasts several hours, the second phase on the other hand can take from several days to two weeks — until the muscles get strong and take over the task of supporting the spinal column together with the entire back. It needs to be mentioned that after two or three days there can appear a slight pain — sore muscles — this usually lasts one or two days.

Upon verifying Medicare eligibility and receiving all the necessary documents from your Physician, you will receive your chair within 4 to 7 business days. All Equipments purchased ships the next day upon receiving your full payment. If any of the products are not in stock we will inform you of the arrival date, which will not exceed 4 business days.

Typically around 10-25 minutes, depending on the environment in which they're given, as well as the preferences of the client.

If you select a standard fabric, your chair will generally be shipped within five (5) business days, however, the lead time is dependent upon the options you have selected.

No. This is not necessary. During normal operation of the heating or air conditioning, the blower will circulate the air over the UV bulb from 50-75 times a day, which is sufficient. During moderate weather, when neither the A/C or heat is on, it is recommended to open the windows to allow for fresh air infiltration and/or to operate the blower continuously (turn on the fan) to circulate air over the UV light.

The housing material is fire retardant. The motor is of a top quality, water-resistant, fully certified and has a thermal cut off point at 113º C

A3: It is better to run continuously not cutting in and out with appliances such as burner thermostats. It can be switched Off during low demand periods

Try both ways. Running the blower all the time will use a little extra electricity, however the home is usually more comfortable, the temperature is more even throughout the home, and the air is cleaner because it is filtered more. The motors generally last longer because they are not starting and stopping. Some of the new furnaces have the ability to use a slow blower speed for continuous operation, and a faster speed when the furnace or air conditioner are running.

Yes, the instrument can and will run continuously when plugged into the charging adapter. However the instrument can not be taken into a hazardous location when used in this manner. Continuous operation while connected to an external power source will violate the intrinsic safety approvals listed on the unit.

The vaulter's run should meet the vaulter's ability. For example, the vaulter should only run from a distance that he or she can repeat within 6 inches, ten out of ten times. After the vaulter becomes very consistent, use the following distances as a guideline: Note that a vaulter does not need to run from a long distance to jump high – running from slow to fast and taking off from the same place is the most important. Back to Top.

In Running With Man's Best Friend, by Davia Anne Gallup, Alpine Publications, 1986, Kerries are rated as 'good' runners, out of the categories 'fair,' 'good,' 'superior.' I quote: Dogs with a "Good (G)" rating make fine running partners, but may be less capable of running daily or for long distances. I advise no more than 18-25 miles per week. Running five days a week, this is equivalent to 4 or 5 miles a day.