Provided the surface and supporting framework are structurally sound and the surface is even, the tiles are an ideal and cost effective way to bring an existing deck back to its former glory. The pressure on the tile base is normally distributed in such a way that no damage will occur. However if you wish to take additional precautions, then we suggest laying down a suitable geotextile mat before the tiles are laid.

If the slope is not so great that you can actually walk on it, then the tiles could satisfactorily be laid. A. Some slope is ideal as it allows water to drain freely away.

Our patented Clip-Strip® eliminates your problem. These ingenious metal strips fasten the vinyl plank onto your deck or dock’s wood, aluminum or steel substructure. With the hidden Clip-Strip system, there is nothing for you to worry about. The Clip-Strip is an exceptionally strong connector. Its unique design allows for the natural expansion and contraction characteristics of vinyl.

No, not without a seperating layer of plywood or cement sheet mechanically fixed over the existing. Rubber and Bitumen are not compatible with PVC and the adhesives used for PVC will not bond to rubber or bitumen. The thermoplastic properties of the 3 membranes mentioned are totally different and even if they could be bonded together, there would be different amounts of expansion and contraction between the two, causing wrinkling, bubbling and delamination.

Yes, in most cases, if you have a sturdy substructure. The existing wood flooring can be removed and replaced with vinyl deck planks. Vinyl railings and trim can be used to replace or cover all of the outside visible surfaces.

Flooring FAQs ::  Technical Data ::  Shipping Info ::  Employment Opportunities ::  Privacy Policy

If the tile surface is suitably even and meets the requirements for laminate flooring in terms of the subfloor (see above) then it is in principle possible. Any unevenness or variations in height in the tile surface can be evened out with an insulation mat. Contact with your manufacturer to check on your specific case.

A reasonably smooth, hard surface, like concrete, is best. However, the tiles can be laid over almost any surface.

Ceramic tiles can be laid outside and are often seen laid in the front garden walkway of Victorian villas. Cold and sub-zero temperatures in winter and hot temperatures in summer months will not damage the tiles and the density of ceramic makes it almost impenetrable to moisture and subsequent freezing. However if a tile cracks owing to an accident etc.

Should you stain a tile never use acid or an acid based product on carreaux de ciments tiles as the acid will dissolve the slip on the surface of the tile. Any stubborn stains can usually be removed with a specialist alkaline based tile cleaner. To protect a newly installed floor it must be waterproofed and sealed as carreaux de ciments tiles are porous and will stain (you can also make the floor shinier and add lustre as carreaux de ciments tiles in their clean state are 'matt' or 'flat').

I prefer to use a large brush or a mop. You want to get large amounts of Stain Solver liquid on the deck surface. Hand pump sprayers often apply too little solution to the surface. If you must use a sprayer, make sure the product has dissolved completely or you will clog the nozzle! Also, be sure you spray on lots of liquid.

Cabot Decking Stain is an extremely durable stain for use on all types of wood decking. This stain brings out the full beauty of the wood grain and provides deep-penetrating wood protection. It is water-repellent and will resist cracking, peeling and blistering and gives a mildew resistant coating. For a solid white appearance on your new deck we would recommend using Cabot Solid Color Decking Stains.

There are many tarot decks in use, including several different Egyptian decks. The traditions behind each and the meanings of the cards can vary. The spread used depends on the reader and the answers being sought. Absolutely NOT! Satanists are only interested in self-fulfillment and their own perceived superiority. They want power and self-gratification and are willing to step on others to get what they want or think they are entitled to.

In most cases, yes. Because the calculated load on the deck structure and foundation almost doubles, some additional reinforcement is usually required (framing and/or piers).

Yes, provided that it is placed on frames fixed with deep screws reaching the coarse stucco. Notice that very often, behind wall tiles there may be a coat of plaster not firm enough for frames to be fixed on it. Nevertheless, it would be advisable to remove wall tiles because, if the wall suffers from dampness, it will probably start to come off and fall in the free space between the sheet and the wall.

Metal substrates are incompatible with conventional cement base adhesives and they tend to have very low dimensional stability. Nevertheless, it is possible to lay porcelain tiles on a metal stair case if the guidelines given below are followed. Use reactive resin adhesive, such as adhesive of the polyurethane type, which provides high adherence and deformability. Of all residential tile applications, the kitchen is the area where tiles are exposed to the highest level of stress.

The graying is caused by the weather and ultraviolet light damaging the woods fibers. It will easily clean off with DEFY Wood Cleaner. Use DEFY Wood Brightener afterwards and the wood should look brand new again. To look it's best you should. Old stain left on will show through the new stain, leaving blotchy dark spots in the finish.

The decks will get stained when your unit comes up for re-painting. If you want to restain your deck yourself, our Deck Stain is Cabot "Clear Solution" #3002" (Phase I and II). For those homes with mahogany decks, (Phase III only) ask for Cabot "Australian Timber Oil 3400 Mahogany". Cabot Stains are available at Botello's Lumber on Rte. 28.

Yes, it can. Just use adhesive to fill in or suitably thicken the difference in level between the mosaic and the tile.

Always clean weathered wood with Dekswood?? Cleaner using 1 part Dekswood to 4 parts water. Allow the wood to dry for two to three days of dry weather before applying CWF-UV.

Not at all. When done professionally, a very small amount of dried-out dead fiber is removed when your deck is getting a face lift.

The Invisagrip? Deck Fastening System was engineered for hard- and tropical woods. Therefore it can be used for all kind of woods (even softer more conventional deck woods,) also composite woods.

This mainly will depend on the weather. On average a Pressure Treated Pine deck can be sealed in approximately 45-60 days from installation. A Cedar or Redwood deck can be sealed within 21 days. If you have a fair amount of rain you will need extra time for drying the wood out. Essentially you are making sure you don't seal in any moisture as this will promote rotting from the inside out.

Because wood makes sense. When you build a deck on your home -- you use wood! It's strong, durable, and attractive. We go a couple of steps further though, we carpet our decks for comfort and safety -- carpeting doesn't get hot in the sun and it doesn't get real slippery when wet -- unlike other pool decks made of aluminum or composites. We also cover the top rail of our fencing with an attractive PVC extrusion, again for comfort and safety.

You should certainly protect your deck from unnecessary moisture intrusion and the harmful effects of the sun's ultra-violet rays. Use of a penetrating stain, containing water repellant ingredients in most cases will protect your deck best. The pigment in the stain will absorb the ultra-violet rays from the sun and protect the wood fibers from degradation. In most cases a stain will need maintenance every 2-4 years while clear sealers require maintenance every 1-2 years.

Most woods will darken as they age; becoming deeper and richer as they react to daylight. There may also be contrasting reverse-blushes of lighter wood due to naturally occurring white minerals. The effect can be very lovely. The extent of the contrast will be determined by the grade of floor chosen, with rustic floors developing the greatest contrast.

Since the SwiftDeck and LinkDeck tiles are solid wood and attached to a plastic base, you need to take the same care as you would with a conventional wood deck, against fire. The tiles can however be used around barbeque areas provided normal precautions are observed against hot coals or burning embers falling on the tiles.

Yes. Providing the existing tiles are securely fixed and the extra thickness of the decos wall panelling does not interfere with the operation of existing fixtures such as bath taps, shower mixer valves, doors and architraves. Some older bathrooms have walls that are half tiled, and have been stuck on using cement.

Yes, as long as the existing tiles are firm and secure and are able to support the weight of the new tiles.