Search 5,000,000+ questions and answers.

Frequently Asked Questions

I Arm the DIY Alarm System, then I open the door, the Alarm does not sound, why?

Bulldog security FAQ
You must wait at least 1 minute or longer after Arming before you open the door (Dome Light Must turn ON) the vehicle to test the Alarm System.
Related Questions

How does my DIY Alarm know when the door is opened?

Bulldog security FAQ
The alarm's microprocessor is capable of sensing current change through the battery voltage. When the door is opened and the dome light is turned on, the microprocessor notices this change in the current status, activating the alarm.
Related Questions

What is the electric motor sound I hear when I open the door?

Volkswagen Touareg Frequently-Asked Questions
The sound you hear when you open the door is the fuel pump charging the fuel lines to allow the Touareg's engine to start easily.
Related Questions

Does my pedometer count steps when the door is open?

Walk4Life - Frequently Asked Questions
No, because the pedometer counting mechanism is in the door. When you open it, the mechanism is no longer in the vertical plane (parallel to the body) so it will not count. Open the pedometer to check and clear display; close it to resume counting.
Related Questions

How do you arm the alarm?

The Key switch activates the alarm, the light will come on and the alarm will chirp when the alarm is activated.
Related Questions

Why does the alarm not sound?

Infologic Support FAQ
Our AlarmClock application includes a number of in-built alarm sounds, and most of these should work on all phones, however it is possible that one or more of the alarm sounds will not work on your phone. The Setup menu allows you to choose a specific Alarm Sound, and also Alarm Vibrate. Software release 1.1.65 added an Alarm Volume setting which may only apply to some of the sounds. When you exit from the Setup menu after changing the alarm sound the application will play the new alarm sound.
Related Questions

How loud is my DIY Alarm?

Bulldog security FAQ
All of the Do-It-Yourself units are rated 127db (+/-3%) at 1 meter. Each unit is tested on the production line for proper volume before they are shipped.
Related Questions

How do I adjust sensitivity on my DIY Alarm?

Bulldog security FAQ
Adjusting sensitivity on any of the Do-It-Yourself units is done in the same manner. Disarm the alarm, then press and hold button #3 (Finder) until the alarm responds with three chirps (non-talking models) or "Please adjust sensor now" (talking models). Simply hit the vehicle, open handed, above the alarm to adjust.
Related Questions

What is the Yellow wire on the back of the DIY Alarm for?

Bulldog security FAQ
This Yellow wire is the unit's antenna. This receives the signal from the transmitter. Make sure that you DO NOT connect this directly to any metal or to electrical wiring under the hood.
Related Questions

Which way does the door open?

ZACA MEDICINE CABINETS
Both ways because ZACA cabinets are reversible. The direction of door opening is determined simply by orientation during installation. Exception: Arcturus model 52-2-34-00 is not reversible; therefore, hinge location (right side or left) is specified at time of order.
Related Questions

How far does the door open?

ZACA MEDICINE CABINETS
Medicine cabinet door hinges dampen the door swing at approximately 90 degrees of arc. Excessive force could cause the door to pivot beyond the designed resistance angle and could cause damage.
Related Questions

Why does my CO alarm sound when there doesn't seem to be a problem?

Frequently asked questions about BRK Electronics® carbon mon...
Remember, CO is an odorless, colorless gas. If your carbon monoxide alarm went off, it detected CO. Make sure no one has any symptoms of CO poisoning. The CO alarm should be located 15-20 feet away from all fossil fuel burning sources like furnaces and stoves. It should be located 10 feet away from sources of humidity like showers. Check pilot lights/flames for blue color. Appearance of blue flames indicates incomplete combustion-a source of carbon monoxide.
Related Questions

Where can I obtain the door alarm certificate if my pool builder doesn't have it?

City of Frisco - Government
The Certification of Pool Protection Device Installation form and all required pool forms can be obtained from the Planning and Development Services Department front desk located at 6101 Frisco Square Blvd., 3rd Floor.
Related Questions

Why can't I arm my alarm system?

Frequently Asked Security Questions by Omega Security System...
If the Ready light is ON, the system is ready for arming. If the Ready light is OFF, check to see that all doors and windows are closed and that motion is stopped in areas covered by motion detectors. The system cannot be armed unless the Ready light is ON indicating that all zones are closed and the system is in the Ready state. To see what zones are open, simply push the [#] button and the keypad displays a number. This is the number zone which is still open or active.
Related Questions

Why does my glass door fire screen need to be open when burning a fire?

Pleasant Hearth: FAQs (Frequently Asked Questions)
These glass door fire screens are primarily designed to help prevent heat/air conditioning loss up the chimney while the fireplace is not in use. They are also used to add a decorative, finished look to your masonry fireplace opening. The doors use 3/16" tempered safety glass. This tempered safety glass is designed to withstand temperatures between 400 - 600 degrees Fahrenheit.
Related Questions

If I leave the door open, do the interior lights turn off after a while?

Volkswagen Touareg Frequently-Asked Questions
Yes. By design, the Touareg will turn off the interior lights after a set period of time, or if the battery voltage drops to a pre-determined level. [research time, voltage]
Related Questions

Why does the alarm sound when I install a battery or turn on the AC power?

First Alert
It is normal for the smoke alarms to sound briefly (up to 5 - 10 seconds) when they are powered up. If the alarm continues to sound and no smoke is present , the cause may be: Very low batteries or insufficient electrical power (brown out) may cause a continuous weak sounding alarm. For DC models, change the battery (DC). For AC or AC/DC models, temporarily disconnect power at the service panel until the brown out is over.
Related Questions

Sound on waving arm, what kind of sound ?

Association for Unmanned Vehicle Systems International's Aer...
No sound from arm. Sounds may come from the victim and will be recoreded human sounds at realistic human sound levels.
Related Questions

I received an alarm notification sticker/door hanger on my door/window, what does this mean?

Police Department - Alarm Registration FAQ
That false alarm notification sticker/door hanger was left as a courtesy informing you of a false alarm at your address. If this was your third or more false alarm in your 12-month permit period, you will receive an invoice in the mail in the near future. You can contact your alarm company to determine what happened and if a problem exists with your alarm system. The false alarm notification sticker/door hanger is a courtesy to you.
Related Questions

Why does my arm feel like pins and needles?

Frequently Asked Questions
About 6 months ago my right arm began to periodically itch from the shoulder to thumb. Then the upper arm started going into some sort of spasm which felt like a blood pressure cuff being over- inflated. I sometimes get electric sensations down my arm and I feel that my strength in my arm is decreasing. You may be suffering from a cervical disc protrusion or cervical nerve stenosis. This needs to be evaluated with a good neurologic examination.
Related Questions

Where can I obtain the door alarm certificate form if my pool builder does not have it?

City of Frisco - Government
The Certification of Pool Protection Device Installation form and all required pool forms can be obtained from the Planning & Development Services Department front desk located at 6101 Frisco Square Blvd., 3rd Floor.
Related Questions

What should I do if I hear the fire or smoke alarm's sound?

Advanced Detection Systems
NEVER IGNORE THE SOUND OF A SMOKE ALARM. If the smoke alarm is sounding its alarm, there is a reason. You and your family must be able to escape quickly and safely. Here are several steps your family can learn and rehearse for an emergency: B. Feel if the door is hot. Always feel the door to see if it is hot before opening It to escape. If the doorknob or door is hot, do not use that exit. Use your alternate exit to escape. C. Crawl on the floor.
Related Questions

The alarm sound is not very loud. What can I do?

Palmadd Software - FAQ
This is a general problem of the hardware (except on the Palm m100?). Because of the type of the build-in speaker the volume can't be really adjusted but you can try different settings in the multiClock volume preferences. On some machines a setting of 7 for the master volume produces a louder sound.
Related Questions

Can the sound alarm be shut off or muted?

Biological Controls Inc.
The piezo alarm can be muted or the slide switch can be left in the center position for full audio sound monitoring.
Related Questions

How much sound output can you get from the open baffle woofer?

Frequently Asked Questions
I give a formula in Ref. 2 and in Design Models A1 that relates the sound pressure level from a driver on an open baffle to the SPL from the same driver in an acoustically small closed box, assuming that both have the same cone excursion. frequency Fequal the SPL is the same for either driver arrangement. The open baffle driver output decreases at 6 dB/oct below this frequency relative to the closed box.
Related Questions

I return home and find my front door open. Should I go in?

Pembroke NH Town Departments - Police FAQ
NO. Go to a neighbor’s house and call the police. If you return home and notice anything suspicious, broken window, open window, alarm sounding, or anything that you do not feel comfortable with DON’T GO IN. You want to avoid any confrontation with a burglar.
Related Questions

Got A Question? Ask Our Community!


More Questions >>

© Copyright 2007-2008 QueryCAT
About • Webmasters • Contact