If you Click Release, and an error saying "IP Address for adapter is already released" then you do not need to release any more, Try "Renewing your IP"

Click on "Specify an IP address" Type in the IP Address you wish to use. (192.168.XXX.XXX is very standard for home networks) Click on the Subnet mask, and if you know the subnet mask you want to use, type it in, otherwise it should fill in with "255.255.255.0" which is very standard for subnet masks. Click "Use the following IP address" Type in the IP Address you wish to use. (192.168.XXX.

click on the Sharing tab "If you understand the risk but still want to share the root of the drive, click here" Click on "Share this folder on the network" and specify what you want your shared folder to be viewed as. A hand should appear under the drive you wanted to share. This lets you know that it is shared on your network

click the "Sharing" tab, and click "Share the printer" then specify the name that you want the printer to be seen as on the network. Then click "OK"

The Printers and Faxes window should open, on the left side there should be an Add a Printer button under Printer Tasks. Click on Add a Printer Click "Browse for a printer", unless you know the computer name(or IP address) of the printer, and the exact printer name. Or the printer is at a location that can be connected to through the internet.

The Internet Connection Wizard Should open(If this does not open and Internet Explorer Opens up, skip to Section 7) Click "I want to set up my Internet Connection Manually, or I want to connect through a local area network(LAN)" click Next You should be on the internet, If a website does not occur Try to Release IP, then Renew IP, and try to Ping your gateway.

Last time I tested, Behold was still working under Windows 98. Over time, more incompatibilities will arise. It is unfortunate, but to fully support XP and Vista, poor old Windows 98 loses out. When off in the future, I finally add Unicode to Behold, that will probably spell the end of 98 support. But that's probably over a year away. If you don't upgrade to a new operating system by then, you're going to be having more problems than just worrying if Behold will run or not.

Sure. But don't forget to restart your computer after installation, if the "Nice PDF Creator" printer does not function or is offline.

Today's launch of Microsoft's Windows 98 SE operating system will be a decidedly low-key affair, at least compared to the introduction of its predecessor. Some of the improvements to the operating system also lack punch, analysts say. The average Windows user may not need the update, they say. "It's an incremental upgrade," said Dwight Davis, an analyst with Summit Strategies. "It's hard to get really excited, because there's really nothing new.

After started, Windows "Add New Hardware Wizard" will detect "Texas Instruments OHCI Compliant IEEE 1394 Host Controller"device. Click "Next".

After installing your FlyCASE, follow the following procedure: - Install the "PikaOne Format" software by running the installation program available in the "Program" Directory of your "PikaOne Programs and Drivers" CD. - Run the "PikaFORMAT" program, format the disk(s) and partition at your convenience. Refer to the manual. The "FAT" PC option of the "PikaFORMAT" software will prepare the disk in FAT 32. This formatting will enable you to use the disk on all systems starting from Windows 98 SE.

Yes, if there are addresses available. Please note that additional IP addresses are granted on an "as available" basis, and are not guaranteed. The number of available IP addresses is finite, and additional addresses beyond the first may need to be refused, recovered, or revoked by ResNet without advance notice. In all cases, there is a maximum of two additional IP address beyond the first which ResNet will provide.

Open Start/Run dialog and enter "cmd". Then at the command prompt enter "ipconfig". Another way to know the IP address of the computer is to move your mouse pointer over the Radmin server tray icon. It will show you the list of IP addresses.

Although Microsoft makes no guarantees that general system performance will increase after installing Windows 98, many users have seen an improvement after upgrading from Windows 95 + IE4.0. In addition, with the help of FAT32 and the updated Disk Defragmenter, you should see a noticeable improvement in application loading times. Shutdown times and startup times (if your computer supports OnNow) have also been reduced.

Yes. Windows 98 has built-in support for digital video disc (DVD) drives. One DVD can hold about 15 times more information than a CD. An entire movie - with full-motion video and lush surround sound - can fit on just one disk. Note: Windows 98 own DVD Player does not have great support for a variety of DVD Decoder cards - only a couple are currently supported, this will change in both the SP 1 and OSR releases.

Although the technology for this type of IP Messaging is available in Win95/98, it was in the form of a program called WinPopUp. It can be installed or uninstalled from Add/Remove Programs. In Windows 95, it is found in the Accessories section, while in Windows 98 it is installed through System Tools. Although the version in Win95/98 and the version in Win2K/XP are not compatible with each other, they do offer an interesting way to communicate between computers (as long as its not abused).

The interfaces are similar. But the Windows 98 interface is more like a Web browser. So you can use the same navigation and viewing techniques whether you're searching your hard disk or the Internet. Most of these options can be adjusted or switched off to resemble Windows 95. Don't worry. Windows 98 setup will have an FAT16-to-FAT32 conversion process.

Yes. Almost all software designed for Windows 95 will run well (sometimes even better) under Windows 98. There are a few cases with various utility programs in which you will need to check the companies website for an update. With Windows 98, you can use more than one monitor at a time. You can spread out your work (and play) across your monitors, just as you might spread out papers across your desk.

A : We do not track what websites our users visit on the Internet. We only record computer IP addresses, and the date & time of transactions when our users swap Net-IDs, or access the NetIDme website. This information would only ever be disclosed to the relevant authorities in the event of an incident causing concern.

The switches do not obtain an internal IP address, and there are no settings to change. It is fully plug and play.

A Yes. This is only really useful if you are assigned a static IP address by your ISP or Web Hosting company. We prefer not to assign sub-domains to IP addresses that aren't online 24 hours a day (i.e. that are only online when you dial-up).

Windows 98 features Disk Defragmenter as part of its Windows Maintenance Wizard. Disk Defragmenter keeps track of the applications you use most, and puts the files needed to run those applications together on your hard disk and in the order needed for launching them. As a result, Windows 98 is able to launch your applications up to 36% faster.

You can access new drivers, system updates, and technical support for Windows 98 through Windows Update, an online extension of Windows 98 for registered users. You should also check your Graphic card and soundcard makers website for the latest available drivers. When you visit Windows Update, Update Wizard scans your computer, tells you which (if any) of the latest offerings you don't have, and asks whether you want to add them. Yes.

You can't - Internet Explorer 4 is the shell for Windows 98. You don't have to use the browser - Netscape or any other browser will install just fine on Windows 98.

Yes you can - go to http://www.microsoft.com/directx and follow the links to the DirectX Core Components as these are the only ones you can install on Windows 98, or just load up Windows Updated and download it from there. No, but Microsoft Plus! 98-a separate package of enhancements and extras for Windows 98-includes McAfee antivirus software and six months of updates.

Simply copy the win98 folder to your hard drive. Run setup from the copied folder and that's all there is to it. If you have already installed win98, copy the folder anyhow then when an installation file needs a file from the cd, browse it to your copied folder. Remember to keep your product key which is on your cd cover, so even if you don't need the cd to install you need the product key on the cd rom cover. Yes, Open DUN, and click "Connections", "Settings".

You can order it directly from Microsoft - http://www.microsoft.com/windows98/guide/Win98/PurchasingInfo/default.asp

I boot with Knoppix from the CD drive. Once it has fully loaded to the KDE desktop, I open a konsole command window.