A:The chances are that you have a winmodem. Winmodems are less expensive to make and rely on software to do what higher quality modems have hardware do. There is limited Linux support for them at linmodems.org. They don't work as well as better modems, even in Windows, and it is recommended that you purchase a better modem. A quick aside on this... if your machine has a winmodem, the chances are that it is running a program called ptsnoop.

You need to attach your Linux drive to another computer which can boot from Windows, and then restore the files on that computer using R-Studio. No matter how that system recognizes your drive, R-Studio should access it. You may also run R-Studio Agent Emergency which boots up from the single floppy and allows R-Studio to access data on that computer over the network.

Remember, the IO is basically a standard pentium class PC with a standard BIOS and a 16MB flash memory card. Please read some of the messages in the "Technical" area on the I-Appliance Discussion Forum BBS, you will find many posts there talking about different OS's and how other installations went.

Most commonly, the com ports in windows have not been configured properly. To do this, go to the "CONTROL PANEL" in Windows. Select "PORTS". Highlight the comport that the modem is set for. Choose "SETTINGS". Adjust the baud rate as necessary, but do not set the baud rate above 9,200 bps. Select "ADVANCED". Choose the appropriate Base I/O Port Address and IRQ Settings. Choose "OK". A "Your Windows COM Settings Have Changed..

Sooner or later, most people who own an S-100 system need to transfer a file to or from a DOS or Windows (or Macintosh or whatever) computer. A Google search of comp.os.cpm "groups" will find a discussion of this very topic that last occurred in early 2003. It's an old topic. Most people who need to establish serial file transfers to or from a CP/M system (or N* DOS system) of ANY sort end up doing something like this: get a SIMPLE file transfer program onto their CP/M system.

It makes no difference what operating system you are running on your PC; Windows and Mac should work just fine. All you need is Internet access, a web browser that will let you get out on the Internet and access your site, and an FTP program that you can use to connect to your site.

You can very easily run Linux and Windows on the same computer, switching between them whenever you want. There are a couple of different ways to do it, most distributions use a program called LILO (LInuxLOader) that gives you a prompt when your computer boots that you type either 'linux' or 'windows' into depending on what you want to do.

Check to see if the phone line is connected correctly to your system. Make sure it is connected to the LINE jack of the modem. Go into the Device Manager and remove all items listed under "Modems". To remove an item in Windows XP and Windows 2000, select the item, click the Action menu, choose Uninstall. To remove an item in Windows 98 and Windows ME, select the item and click Remove. If the installation asks you for the drivers point the installation to drivers.

Which operating system you decide to use should depend on what features you need. For example, if you are already using IIS, ASP, VBScript, Windows Media, Microsoft Access, Microsoft SQL Server, or Visual InterDev, and you don't have the time to learn Unix-based solutions, you'll have to choose a Windows NT or Windows 2000-based host. Just because your desktop is Windows-based doesn't mean you should use a Windows host.

The short answer is no. Since Linux is a different operating system than Windows, it does things differently and that means that Windows programs such as Outlook Express, MS Word, etc, will not work. The good news is that there are almost always Linux programs that do the same thing as the Windows programs you know and love. Or, if you're like me, the Windows programs you know. The even better news is that these programs are usually free. Free as in $0 dollars.

Answer: This configuration is not currently supported. Page last updated: Tue Jul 24 22:01:55 2007; HPLIP Version: 2.8.2

If you're going to have this kind of a system, it's important that you install the Windows operating system first in the first partition of your hard disk. You can then install Linux and along with it a program known as a bootloader (nowadays, the most popular are LILO and GRUB) which allows you to choose your operating system. The Linux installation process, in most circumstances, leaves your Windows partition alone during the install.

Windows will not automatically detect the modem because of the method it uses in detecting modems. Windows detects modems by sending a signal to all the physical COM ports on your system to identify if there is a UART chip. If Windows does not detect an UART chip it will not identify the modem. HSP modems do not use UART chips, but instead allow the main processor to handle all the data compression and transmission tasks.

http://support.ap.dell.com/ap/en/filelib/download/download.asp?fileid=R47114&devid=&format=55543&sid=&os=Windows_NT

Most PCI internal modems are "Winmodems" and will work only under Windows. Linux drivers are currently not available. To find out whether yours is a winmodem visit http://linmodems.org UDATE: Motorola has released Linux drivers for their winmodems. Drivers are included with PCQLinux 7.1 and bets drivers for RockWell 56K winmodems are available here: http://www.olitec.com/pub/HSF_V1.01.02_K2.2.14.tar Kmail supports multiple POP accounts quite well.

of 2006jun11, there is a Music Animation Machine MIDI File Player for Microsoft Windows . You can download it for free here.

How does Qemu know to exit? I am emulating Linux on Linux, and no matter how I shutdown, Qemu doesn't exit on its own.

For more of an explanation, Windows isn't Unix-like in the least. If you want, and or need, a UNIX operating system then one of the BSDs is a good choice. for Linux, simple answer, it's about choice. The BSD system development philosophy is different then the Linux development philosophy, and some people prefer the BSD philosophy to the Linux philosophy. On top of that, BSD doesn't mimic UNIX, it's a real derivate of UNIX.

Microsoft Windows NT and Unix (of which there are many varieties, or flavors, including Red Hat Linux, AIX, Solaris and more) are computer operating systems. Both Windows NT Server and quality Unix implementations are enterprise application servers that can be used for a variety of critical purposes, including, but not limited to, Web, email, and database hosting. Windows NT was developed by Microsoft and is, in many ways, the flagship of their software solutions.

Over the years, many resources have been poured into both Linux and Windows®2003 platforms to make hosting as easy as possible. Today, there are no differences in terms of ease of use between these platforms. If you are an advanced user who prefers to work in shell environment, then Linux is your choice. However, if you are a beginner, you will find both platforms user friendly, especially with a help of DedicatedCentral's control panel, CommandCentral.

There are actually many reasons to this question. 1. Linux tends to be much more stable when working in a server environment. 2. Linux tends to be much more secure. This is because they make it very easy to update the system software to the latest versions. Also, many of the "hackers" tend to exploit windows because of it's many "backdoors" that allow them to get access to system files very easily. 3.

Yes, it is a common practice to install Linux alongside Windows, but it will require you to re-partition your harddrive. I personally prefer getting a second harddrive as they are so low cost these days and it allows you to avoid the fear of accidentally messing up your Windows partition. Sometimes after you've completed installation, you may notice that the screen resolution is not optimal or some piece of hardware was not detected and isn't working.

This depends on what applications you plan to use on your web site. For example, if you need a database driven web site, you can choose either PHP/MySQL combination under Linux or an ASP/Access combination under Windows 2003. The trend is for solutions to be supported in both platforms. For example, we support Microsoft FrontPage, one of the most popular web site editors on the market, on both Linux and Windows 2003.

We offer Linux web hosting accounts (Red Hat Linux). We also run Windows 2003 Standard Edition Servers both OS's other great security and stability..

OSU Physics Faq's : Linux : Linux for Physics Majors : What is Linux? : What's the difference between Linux and other OS's? : What's the difference between Linux and MS Windows (NT, 2000, 9x, etc.)? :

ShoppingQ is offered on Linux only. Unlike other shopping cart systems, ShoppingQ is written in C++ and compiled into machine language. This allows ShoppingQ to run at the machine language level, which maximizes speed and minimizes server overhead. Since it's compiled, ShoppingQ does not have be read in and parsed each time it is run on your website (like other shopping carts written in Perl, PHP, or ASP).

Ans. If you are using Microsoft Windows based scripts (such as ASP, VBscript etc.) you will need windows hosting. But in any other cases we recommend to use the Linux hosting. to know more about this issue click here.