What size cutting-tip do I need?
Granite Industrial Gases - Resources - FAQ - High Pressure C...The type of torch you are using and the thickness of material being cut determine the proper size cutting-tip for use in oxy-acetylene flame cutting. Reproduced below are the cutting tip charts for two of the most popular types of torches in use. Call or email us if you don't see your particular torch listed here. Harris Cutting Torches & Tips CAUTION - At no time should the withdrawal rate of an individual acetylene cylinder exceed one-seventh of the cylinder contents.
Related QuestionsWhat size system do I need?
Frequently Asked Questions - Drying & Dehydration | Nyle...The first step is to determine how much lumber you’ll dry in a year. Then figure your average drying time for each of the species you’ll be drying, and you can calculate the size kiln you need from there. For example: you need to dry 500,000 board feet of oak per year. Fresh off the saw, oak takes about 28-30 days to dry, so you’ll be able to do 12 loads in a year. Each load will need to be 42,000 board feet to give you the 500,000 board feet you need for the year.
Related QuestionsBestswimwear.com Frequently Asked QuestionsAs we offer many designer swimwear collections from different manufacturers, we chose to simplify sizing selection by providing sizing conversions in the individual sizing selection boxes. You will notice the sizing selection boxes while shoppingRelated Questions
Fuzzi Bunz Frequently Asked QuestionsWith any type of cloth diaper, you need to select the correct size diaper for the baby. With clothing you can get away with sizing up. If you size up with diapers, however, it will only lead to leaking. Even a heavier newborn needs to be in a size small at birth.Related Questions
What size cutting decks are offered?
TISCA - Products - SWISHER - FAQOur rugged cutting decks are built with 1/8" steel for strength and durability. Sizes include 44" and 60".
Related QuestionsWhat is tip?
Expect FAQ (Frequently Asked Questions)For many years, all UNIX boxes came with the tip or cu programs. Their basic function was to allow you to interactively read/write a serial port. If you don't have tip or cu, you almost certainly has some other equivalent. Call your vendor (or ask around) to find out the name.
Related QuestionsCosta Rica Deep Sea Fishing and travelTipping for meals is generally included in the bill. The amount included is 10%. A reasonable tip for the captain is $25.00 per day for each fisherman/fisherwoman. (top)Related Questions
Los Cabos FAQSWaiters are usually tipped 15% although for large parties tip may be automatically added to the bill. Bellboys usually receive one US dollar per bag. It is not necessary to tip taxi drivers. The concierge in your hotel may expect a tip if s/he spends a while explaining about Los Cabos attractions. If you take a fishing trip, make sure to tip the captain. Typically, it is a good idea to reward good service wherever you receive it.Related Questions
Cruise Holidays of MasonTipping is, of course a matter of individual preference. But there are guidelines. A general rule of thumb is to plan for about $10 per person per day. Some cruise lines include an automatic charge in your bill for all tipping. In some cases this is optional.Related Questions
Passenger Freighters : F.A.Q'sNo, this is not obligatory, but most people choose to offer a tip to their cabin steward and dining room steward. Often this will be the same person.Related Questions
ACCESSCABO.COM ~ Your Portal to ParadiseWaiters are usually tipped 15% although for large parties tip may be automatically added to the bill. Bellboys usually receive one US dollar per bag. It is not necessary to tip taxi drivers. The concierge in your hotel may expect a tip if s/he spends a while explaining about Los Cabos attractions. If you take a fishing trip, make sure to tip the captain. Typically, it is a good idea to rewardgood service wherever you receive it.Related Questions
D.R.E.A.M. Inc.in all services-related businesses it is common practice to tip the person who has done a good job to the satisfaction of the customer. The rule of thumb in day spas is 10%-15% of the cost of service, or about $10.00 to $15.00 for a one-hour treatment. Spas usually provide an envelope at the front desk when checking out for you to place the gratuity into it with the therapist's name. Restaurants wait staff will bring a bill with a place in which to leave a graduates if paying by credit or debit.Related Questions
AMAIA catamaran-thailand.com : FAQIf you forget EVERYTHING! No worries, you can always go to the Supermarket and get all what you need before going sailing. You will be amazed to find most of your products at home are available in Phuket Supermarket. If you forgot to bring few items, such as panadol, mosquito repellent, sun cream, etc, you might be able to find them on the most popular island.Related Questions
Diversion Dive Travel - Frequently Asked Questions | Diving ...Good news: No one in Australia demands any tips for services rendered. Tips have never been part of the culture. That said, people always like to be rewarded for very good service. Give as much or little as you see fit. Tipping on dive boats is appreciated but never expected.Related Questions
Why do I need to use a cutting mat?
SKAT KATZThe mat serves two purposes. Firstly the paper is pressed onto the adhesive surface of the. This is done to hold the items that were cut out in place, otherwise they would would fall out and jam in the cutter. Secondly, the mat stops the blade from cutting through the paper which may damage the cutting strip, dull your cutting blade and potentially jam the Craft ROBO during cutting. So we at Skat Katz ALWAYS use a cutting mat!
Related QuestionsDo you need to seal the ends after cutting?
McFarland Cascade Outdoor Decking for Deck Project and Desig...Yes. We recommend that the boards are end-sealed as soon as possible after cutting. A clear water resistant wax should be used.
Related QuestionsWhat size tank do I need?
Frequently Asked Cichlid QuestionsThe general rule of thumb in aquarium keeping is to have no more that one inch of fish per gallon of water. Thus, if you had a twenty gallon tank (with no substrate or rocks to diminish the total water volume), you could have five 4-inch fish. This formula also assumes you will change 25% of the tank volume each week. See What is a water change? Why is it important? for more details. Realistically, however, you will need to consider the following factors when choosing what size tank to purchase:
Related QuestionsWhat size weight distributing do I need?
Frequently Asked QuestionsWeight distributing is based on the amount of loaded tongue weight the trailer has. To purchase the correct size weight distributing hitch (WDH), you will need to first load the trailer as you would tow it down the road and then have the tongue weighed. You can weigh the trailer tongue by using a bathroom scale or taking it to your trailer dealer to have the tongue placed on a tongue scale.
Related QuestionsWhat size speaker do I need?
HSU FAQ - Frequently Asked QuestionsWhile there is no such thing as "too much" power in a sound system, the system should be powerful enough to fill your room. To help you pick the right product, each HSU speaker and subwoofer has a "Loudness Level" index —a rule-of-thumb guide to point you towards the best system for your space.
Related QuestionsHow do I work out what jewellery size I need?
Body Piercing, Jewellery Frequently Asked Questions | Flux P...Our measurements are given in stem thickness first followed by internal diameter/length eg.: 1.6 x 12mm. Our rings are always measured internally. Straight and curved barbells are always measured between the balls. On curved barbells (eg., belly bars) measure the shortest distance between the balls along the inside of the curve. Inches to millimeters conversion (you my need to round up or down to the nearest whole mm as necessary):
Related QuestionsHow do I determine the size bike I need?
Frequently Asked Questions | Gary Fisher Mountain BikesOur best suggestion in your situation would be to visit a local dealer and have them fit you on the bike. Taking a test ride on a few different sizes would also be helpful. It is too difficult for us to make an accurate recommendation as to what the best size bike for someone would be without actually seeing them on the bike. A person's height is usually a fairly good place to start when determining correct size, however each person's physical dimensions (arm length, torso length, etc.
Related QuestionsDo I need to tip my guide?
Kodiak Fishing in BCGratuities are always appreciated by our guides. If you are happy with your trip and the fish you caught, around 10% of your total cost is the norm.
Related QuestionsDo we need to tip your driver?
Swift Airports - London Shuttle and Courier Service - Airpor...Tipping is not essential, but in the UK, a tip is offered as a sign of appreciation for good service. Not Compulsory.
Related QuestionsDo I need to tip/give gratuities?
Anglia Sporting: Frequently Asked QuestionsOnly if you feel you've had a good day. A tip, say ?10 per 50 birds, is always appreciated or perhaps the offer of a pint in the pub at the end of the day. We've tried to cover most of the questions you may have to ask but if there's a (sensible) one we've not thought of please ask the question. We may even add it to the list!
Related QuestionsDo I need to tip the chauffeur?
Frequently asked questions - XL Cars WinchesterTipping is not essential, but in the UK, a tip is offered as a sign of appreciation for good service. Most clients tip in the region of 10%. [Top...]
Related QuestionsDO I NEED TO LEAVE A TIP?
Killary ToursWhen it comes to tipping there are no hard and fast rules. Some restaurants often add a 10 - 15% service charge to the bill. If this is added then you don’t need to leave a tip. However, 10 - 15% is customary if you do decide to tip. In bars and pub restaurants, tipping is not generally necessary although appreciated.
Related Questions