I can see the wireless network, but I can't connect. Why?
University of Utah Mathematics Department FAQ: Wireless netw...There are two parts of a wireless connection: a (usually powerful) wireless access point (WAP), and a (relatively puny) laptop, PDA, etc. The latter can often see one or more network access points, but not have enough power to reach them. This is particularly a problem for outdoor connections.
Related QuestionsCan I use any wireless receiver to connect to the campus network?
VPN-FAQProbably. Any wireless receiver supporting the industry standard 802.11b or 802.11g protocols should work. However, in rare cases, we have found wireless receivers which had compatibility issues with the computer upon which it was installed.
Related QuestionsWhat equipment do I need in order to connect to the wireless campus network?
VPN-FAQYour computer must have a wireless network card installed. Computer manufacturers typically indicate this by saying their equipment is WiFi enabled, or that they support 802.11b or 802.11g wireless networks. On a Macintosh computer this is often referred to as an airport card.
Related QuestionsWhy can't I connect to the Watchdog when its on my network?
Digital Watch Dog Frequently Asked QuestionFor best results, please have a Network Administrator present. Networks can be very complex and only a certified network technician would have access to the proper equipment. Most networks are configured to use DHCP, in which case, the Digital Watchdog's IP will change every time the machines lease is up. When attached to a network the client must attach via IP, and it will not have the correct IP after the Watchdog has rebooted.
Related Questionsgt; How do I connect to the wireless network?
Brimson Grow Library FAQs -- GeneralConnecting to the wireless network requires an authentication key. Instructions on how to connect to the network may be checked out at the front desk by any current Northern student, staff, or faculty member.
Related QuestionsCan I connect my PDA to the Wireless Network?
UTS: WirelessYes, however it has limited web browsing capabilities. The following is a list of tested PDA's that are known to work on the UTS wireless network. The UTS Programmer's Society will be providing in-person technical support for student's connection to the new wireless network at the following locations: Support will commence after 19th February 2007 and opening times will be published daily on the Noticeboard and Posters outside Building 10 Room 380a.
Related QuestionsWhat is required to connect to the wireless network?
Frequently Asked Questions ::You will need a laptop with a wireless network adapter that supports the 802.11b and/or 802.11g standards. If your laptop does not have built-in wireless, you may purchase a PC card from the University Bookstore or an electronics retail store. UM-St. Louis provides the Cisco VPN Client, which is required for network access. This software solution provides greater security in authentication and data transfer as compared to ordinary wireless networks.
Related QuestionsQueens LibraryTurn on your laptop. (It must have a wireless network interface card in place.) Your laptop should automatically locate and display nearby wireless networks. Launch an Internet browser, such as Internet Explorer or Netscape. Please Note: if you are blocking pop-up windows you will need to disable it, otherwise you will not be able to connect to our network. A small Bluesocket™ window will appear. This window must be open for you to remain on the wireless network.Related Questions
Frequently Asked QuestionsThere are detailed instructions for connecting to the wireless network available online and at The First United Bank Center (FUBC), the Jack B. Kelley Student Center (JBK), the Hastings Electronic Learning Center (HELC), and the Cornette Library.Related Questions
UCD - Frequently Asked Questions - WirelessMost laptops are now provided with wireless cards built in, if not cards may be purchased from any computer accessories supplier and installed using the software which accompanies it. All laptops must have the correct anti-virus and security software installed before connecting to the University's network. Once the wireless card is installed and enabled you will be able to access the UCD wireless network from any of the hotspot locations on campus. The name of the network is WaveLAN Network.Related Questions
top] What do I need to connect to the wireless network?
Phoenix Campus Wireless FAQYou will need a computer with a supported wireless network card (wireless NIC), and a valid network account. You must also register your laptop with the help desk. It is recommended that you use a supported operating system. See the other questions in this FAQ for more information.
Related Questionstop] Where on campus can I connect to the wireless network?
Phoenix Campus Wireless FAQWe have attempted to cover the entire inside of the building and the courtyard. Some areas outside of the building may provide a weaker signal, depending on sources of radio interference (or lack thereof). Remember that the campus wireless network hardware uses radio waves to communicate. As with any radio transmissions, there will be some areas that are more prone to interference and some areas where reception is better.
Related QuestionsHow Do I Connect To An Existing Wireless Network?
WelcomeFrom the drop-down box next to Data Encryption choose Disabled if the wireless network does not require security settings. If the wireless network requires security, choose the appropriate options for Network Authentication, Data Encryption, and then type in the encryption key into the Network key field. The Passphrase setting or any key generator that populates the encryption or network keys will not work with Dell wireless cards.
Related QuestionsHow can I connect a computer on a wired network to one on a wireless network?
Classroom Presenter FAQsThis runs into the problem that the current networking (Multicast) is not well supported across different networks - the wireless to wired scenario is particularly problematic.
Related QuestionsI set up my wireless, but I can't connect. What should I do?
Welcome to Actiontec Digital GearMany times just changing the Channel and or changing the ESSID of the Modem can fix this issue. You can only change the channel from the web interface (i.e. going to http://192.168.0.1) and clicking on setup and advanced setup. For more detailed information please look on page 63 of the Modem manual located on your installation disk.
Related QuestionsWhy can't I access the wireless network?
The computer support unit homepage - Answers to your questio...The institute have not jet implemented wireless networking. If your wireless network adapter is able to contact wireless accesspoints anyway these are problably accesspoints at other institutes or illegal students accesspoints at this institute.
Related QuestionsWhy can't I connect to a network drive?
The computer support unit homepage - Answers to your questio...To use your personal network drive you must connect with your institute username and password. Please consult the 'Setting up your network drives' guide. If this doesn't solve your problem and you are using a firewall different from the standard Windows firewall, please consult the 'Setting up your firewall' guide.
Related QuestionsHow do I connect to the Library Wireless network?
WCMC Library - Frequently Asked QuestionsWhen entering the Library with a laptop configured for wireless access you may see a number of available wireless networks. The strongest signal comes from the WMC Secure and Library Wireless network. The Library Wireless network is only available for our Library laptops and workstations. ITS created this secure subset to function as a wireless network for Library computers only. If you are a registered user, you may checkout a Library laptop for in-house use.
Related QuestionsCan I connect to the wireless network in the library?
FAQYes, notebook computers with a 802.11b Wireless Networking (either through a plug or built-in card), can connect to the Hastings network and get access to the Internet and Hastings Intranet, from anywhere in the library. Students with computers that have a wireless network card, can borrow a wireless PC card from the circulation desk. If you wish to purchase a wireless network card, Hastings Computer Services recommends the Orinoco WiFi 802.11b wireless card.
Related QuestionsCan I connect my wireless service to an in home network?
Waterford WISP: FAQsYes. You may connect your Waterford WISP high speed internet service to either an existing or a new in-home network. We can advise you on what equipment to get, if you would like to install an-in-home network. We can also help with the installation, if desired.
Related QuestionsHow does a wireless network connect you to the Internet?
Frequently Asked QuestionsHHN Internet's wireless network only manages internet type traffic. They are connected to the Internet via a backbone connection such as a TI-Line, DSL, or CABLE connection that offers higher download speeds than upload speeds. This is practical since most internet traffic has higher download vs. upload requirements.
Related QuestionsHow do I connect my laptop to the Library's wireless network?
Swilley LibraryPlease see Technology Support Service's FAQ. You may also register your laptop at the Swilley Library Reference Desk.
Related QuestionsCan I connect to the Wireless Network outside or between buildings?
Networking & Telecommunications | Idaho State UniversityCurrently there is no support for coverage outside or between buildings. There is, however, signal "bleed-over" from buildings in some areas on campus. The signal is usable, but not supported.
Related QuestionsIs there a limit to how many people can connect to the wireless network?
Wireless NetworkingNo, however a higher number of users can lead to a decrease in performance. The access points will be monitored and additional access points will be installed in the future in high demand areas.
Related Questions