Yes, click here to download the install disk. Please note this disk is for Mitsumi IDE CD-ROM drives only!

Windows NT 4.0 ships a utility called IMAGECFG.EXE in the support\debug folder of the Windows NT 4.0 CD-ROM (it does not ship with Windows 2000).

Best of all if you purchase the database from the AGS office and it does not meet your needs just return it for a full refund. From "Gravestone Rubbing for Beginners," a leaflet available from the Association for Gravestone Studies Gravestone rubbing is fun. It is possible to collect some beautiful artwork that can be framed and displayed. A carver's skill can be preserved, or an ancestor's stone recorded and appreciated through this craft.

The steps below assume that your disk drive is designated A: If not, substitute the drive letter of your disk drive. Download the BootFloppy files (DVDBootFloppyv1.0.exe) from our web site (http://www.port.com/support/tech.asp).

When I installed Windows NT on my PC9 on the first reboot, it rebooted to Invalid Page Fault in the NTOSKERNEL.EXE error "Blue Screen of Death" memory error screen.

Yes. There's one easy-to-use pack for upgrading from Microsoft Windows version 3.1, Windows 95, and Windows for Workgroups version 3.2x. Also, Windows 98 is backward compatible with Windows 3.1, Windows 95, and the MS-DOS® operating systems.

The interfaces are similar. But the Windows 98 interface is more like a Web browser. So you can use the same navigation and viewing techniques whether you're searching your hard disk or the Internet. Most of these options can be adjusted or switched off to resemble Windows 95. Don't worry. Windows 98 setup will have an FAT16-to-FAT32 conversion process.

Yes. Almost all software designed for Windows 95 will run well (sometimes even better) under Windows 98. There are a few cases with various utility programs in which you will need to check the companies website for an update. With Windows 98, you can use more than one monitor at a time. You can spread out your work (and play) across your monitors, just as you might spread out papers across your desk.

Windows 95 has insufficient support for USB. But, since Windows 98 Second Edition, all Microsoft Windows support USB.

Yes. Linux On A Disk was designed precisely to give you that freedom of choice. Installing LOAD will not change your Windows 95, Windows 3X, Windows NT, or DOS system, because the Linux system resides on a separate disk drive. The Linux On A Disk system will be able to read and write to your C: drive, even Windows 95 Fat32 partitions. This allows you to exchange files with Windows. You can use Linux's superior performance on the Internet to download files to be used by Windows.

On the second day of Windows my computer crashed on me. VFAT device failed, and a fatal exception OE. On the third day of Windows my computer crashed on me. No printer found, VFAT device failed, and a fatal exception OE. On the fourth day of Windows my computer crashed on me. While I was online, no printer found, VFAT device failed and a fatal exception OE. On the fifth day of Windows my computer crashed on me.

I boot with Knoppix from the CD drive. Once it has fully loaded to the KDE desktop, I open a konsole command window.

Currently not, sorry. I was developing a version of Naomi suitable for use with all Windows versions, including 95, but development is currently suspended because of technical difficulties. I'm a single programmer, so I don't know how much time will be required for this version to be ready. Anyway, there are a few free filters on the main page (English section) of my site. I think they should work with Windows 95, though I have not tried them.

The most probable cause is that your SCSI or RAID hard disk drive controller is not supported by the standard Windows Setup disk used to create a Windows Key password reset device. Please download additional drivers for your RAID/SCSI controller at hardware vendor website and copy them to a floppy. Reboot your PC with the Windows Key bootable CD/USB device, press 'F6' as soon as the blue screen appears (when Windows Setup prompts for additional drivers at the bottom of the blue screen).

Answer: CTC Parker Technical Support strongly recommends that you do not attempt to install a Windows operating system on a PowerStation. We recommend that you send it to CTC Parker for reprogramming and that, in the future, you purchase the PowerStation with the desired operating system factory installed. Question: When I installed Windows NT on my PC9 on the first reboot, it rebooted to Invalid Page Fault in the NTOSKERNEL.EXE error "Blue Screen of Death" memory error screen.

I'm unable to upgrade my Windows 2000 evaluation version to the full edition using a Windows 2000 upgrade CD.

Casper Tech Edition has full support for cloning Windows 95, 98, and ME systems, including dual boot cofigurations consisting of Windows 2000/XP/Vista and Windows 9x/ME. While Casper Tech Edition is designed to run only on Windows 2000, XP, Vista, and later platforms, the Casper Tech Edition CD may be used to boot and run Casper Tech Edition on a Windows 95, Windows 98, or Windows ME system. Yes.

Although the Card Services interface will be available to programmers, new clients should be written to interface to the [Windows '95] Configuration Manager." -- Michael Mori.

The most probable cause is that your SCSI or RAID hard-disk drive controller is not supported by the standard Windows Setup disk used to create a Windows Key password reset device. Please download additional drivers for your RAID/SCSI controller at the hardware vendor website. Specify the downloaded driver at step 2 and Windows Key will copy it on a password reset ISO image. To reset local account passwords for Windows NT4/2000/2003 Servers, please use Windows Key Professional.

Windows XP is an upgrade for almost every 32-bit version of Windows; you will be able to upgrade Windows 98, 98 SE, and Me to Windows XP Home Edition or Professional. You will also be able to upgrade Windows 2000 Professional and Windows NT 4.0 Workstation to Windows XP Professional as well, but not to Home Edition. In case it isn't obvious, then, Windows 95 and Windows NT 3.

I'm having problems with my Adaptec 2940xx under Windows 95 but it works OK under other O/Ses (like Linux or Windows NT). My drive letters map to different disk partitions than I think they should. What's going on? Table of Contents

The retail version of Windows 95 is limited to 2 GB per partition by the use of the FAT16 filesystem. Since you're getting more than 2 GB, you must be using a FAT32 filesystem. Using FAT32 with drives larger than 8 GB requires a host adapter that supports the "INT 13 extensions". If your host adapter was built before about 1996, you may not have this feature. For example Adaptec 2940W Host adapters did not support this. Even the early 2940UW didn't have it. As of BIOS ver. 1.

Go to Explorer, insert a floppy disk, right-click on the A Drive, click Format, check Make System disk and click OK.

While Casper can be used to clone all versions of Windows Vista, Windows XP, 2000, ME, 98, and 95, Casper will not run on Windows 95, 98, or ME systems. These platforms may be cloned only when running from the Casper Startup Disk or by using the included Drive2Drive. Yes. Casper supports cloning of various mutiple boot configurations, including multiboot Windows Vista and Windows XP/2000, multiboot Windows XP/2000, and dual boot Windows Vista/XP/2000 and Windows 9x/ME configurations.

This is due to a conflict with 3 network files - CLARISNW.DLL, NETBIONW.DLL and NOVELLNW.DLL. If you delete these three files which are located in the program directories, FileMaker will run. If you did not change the default install program directories when SuperSearch was being installed on your hard drive, delete these three files from the following directories that have been made on your hard drive: C:\SI-SFX, C:\SI-RFMUSIC, C:\SI-XV, and C:\SI-MUSICAUDITION.

Yes. It's called Interactive Multitasking, meaning you can work on other tasks while waiting for your computer to reboot each time Win95 crashes.

You can get a LFN driver at http://www.sylpher.com/dosuser/. I haven't tested it yet, it would be nice if someone could tell me her/his opinion about it.

Yes, IrfanView is compatible with all Win9x- and later Windows versions. Win9x means: Windows 95, 98, 98 SE and Windows ME.