Search 5,000,000+ questions and answers.

Frequently Asked Questions

How do I know the engine is running properly?

HPI Racing - Frequently Asked Questions
Of primary concern should be the amount of smoke that is seen when the car is exiting a turn. There should be a good amount of smoke with every acceleration. Second, the idle of the engine must be stable. Third, the glow plug wire (when checked after the run) should be shiny and unbroken. Fourth, the performance of the engine should be good throughout the powerband.
Related Questions

FAQ
The fastest way to know if your engine is running properly is to read the glow plug and the under head. It is usually possible to take out a new glow plug of an engine and look at it closely to see if the engine is running too rich, too lean, etc. Using a new glow plug, install it in the engine you want to test. Run the engine for a full tank of fuel at race speeds. When the engine runs rich the wire is wet and shiny and the under head is white coloured.
Related Questions

How do I know whether the automated feedback tool is running properly on my PC?

Frequently Asked Questions
If you are registered and our feedback tool is running properly, you will see the following processes in Windows Task Manager: wfpuser.exe and wfpservice.exe Please note that in Windows Vista you will need to click "Show processes from all users" to display this information. When you registered, after completing the initial survey and installing our feedback software, you may have been prompted to enter your email address again.
Related Questions

How do I know when I have adjusted the sling properly?

Nada Chair: Frequently Asked Questions
Like a good fitting pair of shoes, the Nada-Chair back slings should fit snugly but not too tightly. Much of the adjustment is self-corrective. If you feel uncomfortable over time, simply loosen the straps slightly. The goal is to keep the low back supported just enough to prevent the sagging that leads to back pain. It is recommended to vary the support by alternatively tightening and loosening the straps when you are sitting for longer periods.
Related Questions

How does the Remote Starter know that the Engine is running?

Bulldog security FAQ
The system has (2) Two ways of knowing this. When in Tach Mode, the unit knows it's running by reading the AC voltage from the (-) Negative side of the coil. In the Tachless Mode, the unit knows it's running by reading the increase in DC voltage from the Alternator.
Related Questions

How do I know if my Nitro engine is running at the right temperature?

RC FAQ- Dubai RC Hobbies
Use the spit test. Heat is the number one enemy of all Nitro Vehicles. It is important to keep your Nitro plant running cool. Two sounds to listen for are a high pitched whine(too lean)or a gurgling (too rich). Rich means that there is more gas than air and lean means there is more air than gas. The spit test consists of running the car for about two minutes for the engine to get warm. Place a drop of water on the top of the head. The drop should evaporate in three to five seconds.
Related Questions

How do I know when the battery is running low?

Highlander Musical Audio Products. Frequently Asked Question...
The battery life for our iP pickups is over 1000 hours. When the battery is close to the end of its life, the high end will start to sound dull, this means there is still about 2 - 4 hours before the battery runs down completely (see power).
Related Questions

What is the clanking sound when the engine is running?

HPI Racing - Frequently Asked Questions
If you hear a clanking noise coming from your engine, it might be a problem with the flywheel and not a problem with the engine itself. This is a brand new flywheel (#A884) that comes with any kit that comes with the Nitro Star 15FE engine. If you hear a clanking sound coming from your car or truck, your pilot shaft (#A805) may not be tight enough, causing the flywheel to rock back and forth on the crankshaft. The rocking action can cause the inside of the flywheel to wear out.
Related Questions

How do I know if I'm taking my injectable medications properly?

Center for Reproduction - Women and Children - Carolinas Hea...
Before beginning injectable medications, you will attend an instructional class involving a video demonstration and direct instruction with our staff. You may also be given a video to take home for reference during mixing and administering the medications. Mild transient redness and bruising are normal at the injection site. Your response to the medication will be monitored by bloodwork and ultrasound to assure an appropriate response.
Related Questions

How will we know our country and the DTP's are properly represented?

DTIA: Frequently Asked Questions
The majority of the international board will be made up of recognized accredited professionals (such as RDTs in Canada). The second largest group will consist of dental technician educators currently teaching, or retired from teaching. However, to ensure all stakeholders are represented, there will be a place for other recognized associations, lab owners, manufacturers, and dentists to be represented on each board.
Related Questions

What should be done to break-in my engine properly?

Frequently Asked Questions
Floorboard it right out of the showroom! Not really!!! Again, check your owner's manual. Specifically, the manual points out the following: "Your Cummins turbo-charged, charge air cooled, diesel engine does not require a break-in period due to its construction. Normal operation is allowed, provided the following recommendations are followed (if it is practical to do so): Check the coolant and oil levels frequently.
Related Questions

Is the service running properly ?

AEP Networks: SmartGate FAQs
telnet from the local console to localhost, port 2095 to ensure that the process is running. Raptor also has a daemon under NT called "Vulture." This daemon kills any service that it does not recognize. You can either disable the vulture by editing raptor/eagle/sg/vulture.runtime and placing a -1 in the first line, or add the sgsdi service to this list so that it will not get killed.
Related Questions

Can I use an engine additive during running-in?

Wynn's Australia - FAQ
No – During the running-in period the moving parts of a new engine have to adjust to one another. We recommend using a Wynn’s engine additive for the first time after the first oil change.
Related Questions

What engine is the game running on?

Free Radical Design - Frequently Asked Questions
Haze is powered by Free Radical's own next-generation engine, developed completely in-house. After all, our engine coders need something to do besides smell of fried chicken and pizza.
Related Questions

If my engine is running hot what do I do?

CEN Racing
If your engine is running too hot you need to richen up the fuel mixture. This means the engine needs more fuel to lower the temperature.
Related Questions

How do I know if my engine is flooded?

HPI Racing - Frequently Asked Questions
The quickest way to tell if your engine is flooded is if when pulling the starter cord, the engine seems to "lock up" and the car lifts off the ground. If this happens, don't pull on the cord any more! This is often called "hydro lock" and trying to pull the cord will break the pullstarter spring, the pullstart string or damage the engine.
Related Questions

Can we know how much bill we are running?

Medical Transcription - Frequently Asked Questions
Yes, just login into ACCU-CHART and go to current billing statement and you will see a summary of billing statement for the current month. Here, you may also check for individual doctor or entire group billing statement for any past months or between any time period. Yes, all our transcriptionists as well as supporting staff need to sign non-disclosure and confidentiality agreements before they take employment with us and it will be in effect two years post their disassociation from our company.
Related Questions

top] How do I know who is running?

Voting FAQ - New Voters Project
Check out Project Vote Smart or Democracy Net for information on the candidates running in the next election.
Related Questions

How do you know if the membrane is working properly?

Manta Ventures - Emergency Desalination FAQs Page One
Each and every product is tested for leaks under a positive pressure air test prior to packaging and shipping. Products require a tight membrane filter and construction so that the osmotic pressure is always contained. In the rare case where a rupture or small hole develops in the membrane or construction under severe use, osmotic pressure is released and the osmotic filtration process stops. The product will not generate clean drink because the osmotic agent is flowing out into the dirty water.
Related Questions

How can I know if my gallbladder is not working properly?

Faq About the Gallbladder
There are symptoms of a malfunction of the gallbladder. If you have indigestion and you vomit after eating fatty foods, you can blame the gallbladder. Other symptoms are pains in the upper right side of the abdomen and in the back and right shoulder.
Related Questions

How do I know if a Chiropractor is properly qualified?

Martineau Chiropractic Clinics - Frequently Asked Questions
The Chiropractic profession has statutory regulation and is controlled by the General Chiropractic Council (GCC), who are responsible for ensuring that all practising Chiropractors are properly qualified, undergo continual professional development, and abide by the Code of Conduct. It is a legal requirement for all practising Chiropractors to be registered with the GCC.Top articles Registered with the British Chiropractic Association - Copyright © 2006 All rights reserved.
Related Questions

How do I know when pork has been properly cooked?

America's Pork Industry :: FAQ's
Pork should be juicy and tender, with a slight blush of pink in the center after cooking. Your meat thermometer should read 160°F.
Related Questions

How do I know if I am doing the exercise properly?

RESPERATE: Operating RESPeRATE FAQ
When your perform the exercise properly, you can actually see the decrease in your breathing rate displayed on the device's screen. You can also press the "Current Effective Exercise" button on the top left of the device at any time to check how many "effective minutes" (The number of minutes spent breathing under ten breaths per minute) you have acquired within the session.
Related Questions

What should I do if I cannot get my engine to work properly after doing an installation myself?

Frequently Asked Questions
Telephone for assistance during business hours, but kindly avoid using email for questions of this nature. It is easier for us to ascertain the problem and offer you a more timely solution when we can speak to you directly.
Related Questions

WHERE DO THE HERBS COME FROM, HOW DO WE KNOW THE HAVE BEEN IDENTIFIED PROPERLY?

Dr.James Moore
The herbs are procured from around the globe depending on the best source for each individual herb. All of our herbs our 100% natural and free of any chemicals or preservatives. Our herbs are extracted from only the finest pharmaceutical grade raw herbs. Botanical and pharmacological experts check the quality and identification of all herbs. Herbs must not only pass a visual inspection but also laboratory analysis using the most sophisticated scientific equipment available.
Related Questions

HOW DO I KNOW THAT THE COUNSELLOR IS DOING HIS/HER JOB PROPERLY?

Cannongate Counselling - Frequently asked questions
We belong to the British Association for Counselling and Psychotherapy and as such our work is monitored through regular supervision in accordance with the Code of Practice. If you are unsatified you may use the BACP's complaints procedure.
Related Questions

How do I know the software has been properly installed and registered?

ExamSoft FAQs
After registering SofTest, you will receive a registration confirmation e-mail at your USD e-mail address from support@examsoft.com and the Registration number along with the registration date will be recorded. Additionally, when SofTest is launched, the Start Window will indicate that your "Registration" is "Complete".
Related Questions

How do I know that the sample has been collected properly?

FAQ's for Drugs of Abuse Screening - Altrix plc Simply Accur...
All sample collectors must participate in thorough training programmes to ensure the sample is collected correctly. Also, as part of the laboratory screening process, a separate test is carried out to confirm the presence of Immunoglobulin G. This substance is present in human serous fluid and so proves that it is Oral Mucosal Transudate and not just saliva or another liquid which is being tested. Any swabs failing this test will be rejected.
Related Questions

How do I know if my order has been processed properly?

WonderProducts.co.uk - Your pick of the BEST Beauty, Skin Ca...
When you submit your order you will be presented with an 'Order Complete' page which means that your order has been successfully received by us. We will also send you a confirmation email with details of your order and delivery. Please retain this email until you order has been delivered.
Related Questions

How do I know my clamps are properly set?

Sport Masters - FAQ
Make sure the clamp pad is on the foot of the clamp. Also, feel under the bed rail to ensure that the clamps are on a flat surface.
Related Questions

Got A Question? Ask Our Community!


More Questions >>

© Copyright 2007-2008 QueryCAT
About • Webmasters • Contact