A single wall black or close clearance double wall black to the point you would break surface of a wall or ceiling. Then you must continue with a 2100 degree chimney pipe to the point where you would be 2-foot above the peak or ten feet away from the roof line.

If you are using the wood flooring plans that we have provided, we recommend that you create a rock or sand hearth to put your stove on. To install your stove on the hearth, follow manufacturer’s instructions and local building codes. Each dome is equipped with a metal stove flashing. The piping will run from your stove through the flashing and above your dome. All of the piping that is used in association with the stove should be double walled pipe.

You need to balance the weight of your stove and fuel against your desire for hot meals. During the heat of summer, cold meals are often more attractive. During cold weather, a stove may be important for survival. NOTE: Fires are prohibited throughout the backcountry.

A building permit must be taken out prior to installation of a solid fuel stove (wood, coal, pellet, etc). A copy of the manufacturer's specifications should be included with the permit application. These general guidelines may be used to install most stoves, new or used. If the stove is new, installation is in accordance with the manufacturer's specifications and installation instructions. Many new stoves have built in features that allow you to reduce the minimum clearance guidelines below.

Not unless you plan on cooking yourselves as well! We know, we know! Wood fires provide a rustic, cozy ambience that country living simply needs! But the miniHome is such a small volume, that a wood stove, even the smallest ones on the market, would have you opening all of the windows within 10 minutes, our designed heatloss is only about 10,000Btu in some of the coldest weather.

Please make sure the flue is open before starting fire. NEVER remove hot ashes or partially burned loges. Please leave the ashes in the fireplace even if you are sure they are cold. It's easier to build a fire with a bed of ashes. If it becomes absolutely necessary to remove the cold ashes, use a metal container only. (Anything flammable, such as a paper bag or cardboard box, even if you are positive the ashes are cold, is extremely dangerous.

Unfortunately, no. You will need a wood pellet stove but if you don’t already have one, the savings you will realize in heating your home will more than pay for the stove. Some companies do offer converters which may be placed in fireplace inserts. Please check with your local hardware store or on the web to see if this option will work for you.

Yes you absolutely can from a technical standpoint. The building can have anything normal installed into it. Legally, we cannot answer that. You would need to check with your local fire department etc.Many places now require the Ultra low emission wood stoves and some areas no longer allow wood stoves. We cannot comment on that because we don't know your area, but yes a wood stove can be installed.

Night and Day! Blaze King classic models feature a bimetal coil thermostat This simple thermostat evens out the uneven nature of burning wood. Blaze King owners typically only adjust their thermostats once or twice and day. Nearly all other wood stoves have a damper to regulate air-flow and require more frequent adjusting. Also, Blaze King wood stoves are very deep. Not just front to back but real depth.

Yes, a permit is required to install a wood or pellet burning stove. Currently, we charge $25.00 for fireplaces, wood or pellet stoves. (See 1997 UMC 112.1)

It can be fitted on copper, iron, plastic, galvanised or lead, although lead pipes will reduce its effectiveness considerably.

Almost every gas stove, gas insert and gas fireplace we sell is rated as a heater. They operate at efficiencies ranging from 30 to 70%. As a result, they often can heat an area as effectively as a woodstove or wood insert. Just like woodstoves, they come in many sizes and output ratings. It is important to size properly for your application.

You need to determine which model of Blaze King you own first. Since there have been dozens of models made over the years, determining which model you own by general description is usually not possible. At the time all stove are manufactured, a metal or foil decal is applied to the rear of the stove. (Right hand side on inserts). This label contains all the information pertaining to the model and serial number.

Most of our cribs are made of Pine wood from harvested forests in New Zealand. We also use Rubber wood from Malaysia and Sepetir wood from harvested forests in other Asian countries. We NO longer use protected wood species like Ramin wood from Indonesia in any of our furniture.

Our standard log is lodge pole pine, and is cut from dead standing timber. This timber is normally killed by fire or beetles. Pine beetles burrow just under the bark and eat the sap wood, killing the tree. Once the tree has died the beetle either dies or leaves the tree for new food. The tree then loses it's bark which allows it to dry without roughing.

Dry, seasoned wood is best. The type of tree is not as important as moisture content. Wood must be allowed to dry for a minimum of 12 months, under cover, after being split and stacked. Popular firewood in the Northwest are: maple, alder, Douglas fir, spruce, apple and cherry. Another good fuel source is pressed fire logs, manufactured by pressurizing sawdust, as opposed to wax-based decorative logs, which have limited heating value.

There are a few differences between wood and coal burning units. Please contact us direct to disucss this at (800)750-2723.

With Regency, your options are several. First, you can install a rear vent direct vent stove, which vents directly out the back with no vertical pipe whatsoever. If this is not possible, you can minimize the amount of visible pipe with either the 2-foot or 4-foot AstroCap horizontal termination kits for DV stoves. These kits use the minimum required height for our stoves, and then turn 90 degrees to go out your wall instead of up through the ceiling.

The flue pipe from the stove to the chimney must be as short as possible to avoid cooling down the smoke. If the smoke does not have the right temperature, it may cause poor draft conditions and smoke inconveniences. Only one elbow ought to be connected to the stove as the smoke will face too much resistance. We have not been able to measure any difference in the draft conditions between a stove fitted with a top flue exit instead of a rear flue exit.

If the connector pipe is single wall stove pipe, use the Dripless Smokepipe Adapter with Coupler (DSPAC). If using the Model DSP double wall Smoke Pipe, use the Chimney Pipe Adapter (CPA). Both will allow for a smooth, easy, dripless transition.

No, I don't. I can cook on gas, induction, ceramic stoves without any problem. I need the usual cookware you normally use. Anyway, don't panic I always bring with me a "survival kit"!

No. Since the pellets are so efficient, the stoves do not need a chimney. All you need to do is vent them outdoors with a 4” pipe through an outside wall. So, choose the room you congregate in, place the stove in that room, and enjoy the ease and warmth of pellet heat! You’ll also enjoy watching the flames—and the fact that there is very little ash to clean.

quot;1 kW per 14 cu metres" in new money. 1kW=3,300 BTU. With central heating, smaller stoves may be used. The brochure sizes are Maximum dimensions for Width & Depth and Height of Stove to the top. Width & Depth allow 50mm gap around the stove but you must try to leave 225mm above it or heat circulation is masked and fitting/sealing the flue becomes tricky.

Yes. Professional chimney sweeps tell us that chimneys should be clean when the creosote has built up to 1/8" to 1/4". This will help prevent chimney fires. REMEMBER: The fireplace or wood stove is not an incinerator. Do not burn trash or large amounts of paper (especially gift-wrap). The tempertatures this can produce can damage your fireplace or chimney.

Several L.L.Bean salesclerks prefer to use butane cartridge stoves in the summer. Butane is light, clean and requires no pumping or priming to produce an instant flame. You simply plug a cartridge into your stove, turn it on and light it. During the colder months, many use white gas or unleaded fuel. The fuel is inexpensive and produces a lot of heat, which is critical during winter when campers melt snow for drinking water.

The safest installation available for a woodstove insert is one that is lined to the top. Reasons to line a woodstove insert to the top include: