How deep does the water need to be to use the Water Whoosh?
FAQ's pop-upWe recommend anchoring the product in at least 8 feet of water in an area at least 20 feet from any docks, boats or other obstructions. Use reasonable care to ensure that there is adequate clearance free of obstructions above, around and below the product. Do not allow the Whoosh to be used on land, in pools or on any other hard surface.
Related QuestionsHow deep does the water need to be to use the Aqua Deck?
FAQ's pop-upYou should anchor your Aqua Deck in at least 10 feet of water in an area at least 30 feet from any docks, boats or other obstructions.
Related QuestionsHow many people can use the Water Whoosh at a time?
FAQ's pop-upWe recommend only one person climbing and one person sliding at a time. This will prevent overcrowding and decrease any chance for collision of users. Supervised activity on the product is highly recommended. Do not allow anyone to jump or dive off the top of the slide. Although the Water Whoosh was originally designed to be used in a stand-alone application, it can be butted up next to most any jump platform product.
Related QuestionsHow long does it take to set up the Water Whoosh?
FAQ's pop-upIt takes approximately 30 minutes to set up the Water Whoosh for the first time. This time can be reduced to about 10 minutes if the slide cover is left on during storage and you gain more experience setting it up.
Related QuestionsHow deep does the water need to penetrate?
Welcome to Irrigation Solution : Lawn sprinkler, sprinkler c...Apply enough water to wet the soil to a depth of approximately six to eight inches. A soil probe may be used to check moisture depth in soil. Maintaining a soil moisture depth of six to eight inches usually requires a rate of one to two inches of water per week. You can place opened cans in the sprinkler pattern to determine the amount of water being applied. · Don't give your lawn a light sprinkling.
Related QuestionsHow do you inflate the Water Whoosh tube?
FAQ's pop-upWe highly recommend using an industrial inflator / deflator like the RAVE Hurricane Blower. With this blower, it only takes about 5 minutes to inflate the Water Whoosh tube. You can order this high volume inflator / deflator directly from RAVE Sports by calling 800-659-0790. Using the air output side of a shop vacuum is also an effective way of swiftly inflating the tube, since shop vacuums typically have high air flow rates.
Related QuestionsHow do you deflate the Water Whoosh?
FAQ's pop-upAgain, you can use the RAVE Sports Hurricane inflator / deflator or a shop vacuum, positioned in reverse, to swiftly deflate the tube. Another option is to lock the valve open on the tube and let the air naturally flow out of the large opening of the valve.
Related QuestionsWill the Water Whoosh fade in the sun?
FAQ's pop-upThe tube will retain its brilliance for years because UV inhibitors are specially blended into the chemistry of our PVC materials. We also recommend using 303 Aerospace Protectant as a secondary topical agent (like sunscreen for your skin) to prevent fading and degradation. 303 also restores lost color and luster, making your product look like new. Periodic (monthly) application of 303 Protectant will provide the best results.
Related QuestionsHow do you anchor the Water Whoosh?
FAQ's pop-upSufficient anchoring methods will vary depending on your local conditions (ex. Water depth, type of water bottom, exposure to high winds or water current, etc.). Please consult with local authorities (ie. Dock and lift dealerships, marinas or your local water enforcement officials) to inquire about proven anchoring methods or anchoring restrictions in your area. For day use anchoring, a RAVE Sports sand anchor bag works well ( call 800-659-0790 for more information).
Related QuestionsCan the Water Whoosh be repaired on site?
FAQ's pop-upYes, Locate the leak or puncture in the product by spraying the tube with soapy water. When you find the leak and determine the hole size, use a patch from the repair kit and cut a swatch 1 inch wider than the hole. Deflate the product and clean the area around the hole with rubbing alcohol. Apply glue from the repair kit to the patch and the area around the hole. Let the glue dry approximately 2 minutes until it becomes tacky.
Related QuestionsCan the Water Whoosh be used in salt water?
FAQ's pop-upYes, it can be used in the ocean and other salt water bodies as there are almost no metal components on the product and they are all made of stainless steel to provide maximum resistance to corrosion.
Related QuestionsHow deep does my pond need to be?
FAQYou can get by with as little as 12". The water temperature will be more stable, your Koi will be healthier, and your Koi will be better protected from predators with a deeper pond. If you don't have freezing weather, 24" would be a good minimum. If you do get freezing weather, 36" is a good minimum. Deeper is better for many reasons.
Related QuestionsHow deep is the water?
Intimidator Charters - Sportfishing Trip FAQ's and InfoThe water where we fish on a bottom trip is anywhere from 50-150 feet deep. On an offshore trip the water may reach depths in excess of 6,000 feet.
Related QuestionsHudson River Whitewater Rafting Frequently Asked Questions F...River depths vary. Slow, calmer stretches of water tend to be those that are deeper. Faster, choppy water tends to be shallow, often 4 feet deep or less. Regardless of the depth, however, if you should find yourself overboard (this is rare) in fast moving water, the proper procedure is to float on your back, feet pointed downstream. Don't attempt to stand until the water is less than 18 inches deep. A guide or nearby raft will assist you, or you may prefer to simply swim to shore.Related Questions
Do I need to use water?
Dermoplast - First Aid to fight infection and provide relief...Yes. To use the product you need to wet the area before applying the lotion. The water is also needed to thoroughly rinse the affected areas, which is essential in removing the oils.
Related QuestionsHow does the chiller work? Do I need one? How much water am I really going to use per minute?
Wardjet: Common Waterjet Cutting QuestionsThe chiller re-circulates the cooling water that is used by the intensifier’s heat exchanger to cool the hydraulics. It cools the water and then sends it through the pump again. A chiller is most effective in areas where there is a water shortage, in warmer climates, or if the cost of water is higher. You could go through up to 5 gal/minute of cooling water on a 50 hp pump, so it may be a good option.
Related QuestionsFrequently Asked Questions (FAQ)This is the most common asked question of every guide on every river in the world. You are no exception. All guides, over the years, have answered this question in a variety of ways, from as factual as possible to carrying a ball of twine with an attached rock for an exact on-the-spot measurement to, oh' about "chest high on a duck". The Rogue River is what is known as a pool and drop river.Related Questions
How deep beneath the surface of the water can one place a Biorock reef structure?
Frequently Asked QuestionsThere is no limit to the depth. Normally we build structures in shallow water (5 to 25 feet bottom depth) because corals grow best in brightly lit shallow water, but we also try to have them deep enough that boats can't run into them.
Related QuestionsWhitewater Rafting Lehigh River Checklist Frequently Asked Q...River depths vary. Slow, calmer stretches of water tend to be those that are deeper. Faster, choppy water tends to be shallow, often 4 feet deep or less. Regardless of the depth, however, if you should find yourself overboard (this is rare, indeed) in fast moving water, the proper procedure is to float on your back, feet pointed downstream. Don't attempt to stand until the water is less than 18 inches deep. When you reach calmer water, swim toward a guide or nearby raft, or swim to shore.Related Questions
What can I do if I hunt in deep water an want to use your decoys?
Frequently Asked QuestionsGo to a steel manufacturer and ask for 1/4 in cold rolled rod and cut them to the desired length to put them into your base on the decoy or put them into the ground and still have the decoy barely out of the water.
Related QuestionsWhat is a whoosh?
August 2007 CLA/GLA * ~* - Low Carb FriendsYou lose inches but not pounds because your body plumps the fat cells. It is a complicated biochemical process that your body replaces the fat molecules with water and fluids until you exceed your bodies predetermined fluid level. Then your body will release a chemical that releases all this stored water and you get sudden overnight loss of several pounds. Then the cycle starts over again with inches gone and the scales lag behind. This water replacement is temporary.
Related QuestionsCan I use coconut oil for deep frying?
Frequently Asked QuestionsWe don't recommend coconut oil for deep frying--it does not have a high enough smoke point and breaks down at high temperature. We recommend tallow or lard for deep frying. It is when the oils are removed from the foods that they become dangerous to cook in. Inside the food they are protected. It is fine to cook foods containing polyunsaturates as long as you don't cook at too high a temperature or burn them. No, these vitamins are very heat stable. Only the Wulzen factor is lost.
Related QuestionsWhat is a Deep Cleaning and why do I need it?
Twinbrook Dental Center FAQA Deep Cleaning is properly termed "Periodontal Scaling and Root Planing". It is a cleaning which, instead of cleaning from the gumline up onto the tooth, is a cleaning done under anesthesia, starting at the gumline and extending beneath the gum onto the surface of the root.
Related Questions