FortisBC Meter Readers take actual meter reads every two months. If you believe that there may be access issues preventing our meter readers from reading your meter, please call our Customer Contact Centre Monday to Friday from 7 am to 7 pm at 1-866-436-7847. For more information on metering and access issues, please click here.

Has the way you use natural gas changed? Click here for a checklist of items that may cause a high bill.

That depends on your new supplier. Your new supplier will either arrange for someone to come and read your meter, or may ask you to take the reading. We recommend that you keep a note of the reading to ensure that you agree with the final bill from your old supplier when it arrives.

Yes, the request for meter read(s) will show all the equipment requiring a read at that time, you may enter them all during one session.

You may add a new Meter Reads User only if you are a Meter Reads Administrator. Log in to IKON Online, select Account Information in the top Navigation Bar, and then Administer Users. Click on Add User, this will open the "Add User" page that allows you to add a new user to the Meter Reads Program in IKON Online.

Locate your gas meter at your home and compare the reading to the one found on your bill under How We Calculated Your Gas Charges: Ending Read. The reading on your meter should be higher than the one recorded on your bill. If you find it is lower, please call us at 1-877-472-4932.

You can easily read your own meter if you wish to check how much electricity you use. Your meter has five dials. Three of the hand dials turn clockwise and two turn counterclockwise. When the dial hand points between two numbers, write down the lower of the two numbers.

Log in to IKON Online, select Account Information in the top Navigation Bar, and click on Assign EIDs. Select each piece of equipment you wish to assign to a new user. Select the appropriate Meter Reads User from the drop-down listing of contacts. Click the Assign button. How many Equipment IDs can I assign to a single user? As many as you would like. However, a single Equipment ID may not be assigned to more than one user.

The RF position of the METER switch is a relative indication, that depends on where the RF pot has been set by you, or someone before you. Kenwood included it as a means of peaking your forward power, if you didn't have an inline power or SWR meter. In early hybrids, the adjustment was inside the side panel door, along with the VOX controls. On later hybrids, it's on the back panel.

In-Plant Graphics is read by about 20,000 graphic arts professionals in the United States. The majority of these readers are in-plant managers working for manufacturing firms. Banking, finance, insurance and real estate in-plants comprise the next largest audience segment. After that, educational institutions, professional services groups (legal, medical, architectural, hotels, etc.) and publishing companies make up a large chunk of our readership.

Answer: These displays are shown at different times for different reasons. Here are a few of those reasons: You don't have your thermocouple inserted and you are on the the range selection, you are on the resistance range and aren't connected to a circuit. You are locked into a range and are exceeding the maximum value allowed on that range. You may have a blown fuse if you are on the amps range.

No, the meter belongs to Metrowater. If you had a meter installed recently and were charged for it, the charge was to cover the installation, not the meter itself.

The meter boxes are located in the front on the property line, usually shared between two houses with both meters in one box.

You can find instruction in your user guide. If you wish to talk to a customer service representative, please call us at 1-800-661-0200.

The screening results are read and interpreted by our computer software, then reviewed by a board-certified cardiologist.

Do not examine patients or calibrate your machine. This message may indicate that you need to contact Hologic Service. First ensure that you have properly performed the QC and that the phantom has been stored on the machine for at least the last four hours in an environment which has not been outside of 60° to 100° F (15° to 37.7° C). Unplug the unit from the wall outlet wait ten seconds, then plug the unit back into the wall outlet.

Graduate students from all over campus have expressed interest in reading Amalgam. Amalgam will also be distributed to institutional libraries across the continental USA. The first few editions of Amalgam will be distributed freely.

SuperKids attracts a gender-balanced (55% female), 30-50 year old, affluent parent/teacher audience from a wide variety of occupations. Almost all are married, most are reasonably computer savvy, and access the SuperKids both from home and the office.

Reads are tallied when someone loads your column up in their browser. Reads are not tallied when someone discusses or critiques your column. No. We don't request rights or reprint rights. However, understand that when you post anything on the web it could be considered published, and it's up to you to disclose this information if you try to resell the work.

Your submissions are currently moderated by the following people: AlexisTaylor (Lex), Asphyxiated (Georgia), Astrid Skywalker (Lei), blazing_Axe (Chris), bogus (Danielle), ByMerlinsBeard (Emily), deanine (Bridget), Deathblade (Paul), Dory_the_Fishie (Leanne), Electronicquillster (Marie), Eponine (Abby), GringottsVault711 (Jenna), KalHoNaaHo (Kal), Little_kitty (Emily), Magical Maeve (Jan), Marauder by Midnight (Beth), Masked One (Mask), Mithostiel (Colleen), MithrilQuill (Mithril), Mrsgeorgeweas.

Reaching senior-level consultants (Partners, Practice Leaders, Directors, etc.) within small, medium and global enterprise consulting firms, Consulting Magazine is the industry source for the key decision makers and influencers in the profession to read about what's going on in their world. Circulation: 23,000.

You may be wondering why you should bother with a weblog, especially if you’re coming to this blog for the first time. You’ve never heard of blogs before, or you’ve only just heard of them, but never had the time to see what the fuss was all about. Who reads these things, anyway? (more…)

Only the relevant employees of the Telegraph will read the research results. On the rare occasions when we ask questions on behalf of a 3rd party, they will also see a copy of the overall results. If we send you a survey where a 3rd party will have access to the results we will inform you of this on the email, so that you can opt-out of the survey if you wish.

Our typical reader/client is a top-level manager with a foreign company in Warsaw (an American, Briton, German or, say, Japanese) Our corporate clients include consultancies, analytical organisations or international legal firms. PNB publications are read by nearly all foreign embassies in Warsaw. Over 40% of our internet clients live in the US, and 14% in the UK.

Answer: The initial findings will be documented with photographs and explained to you by one of our staff professionals. If there is follow up work that needs to be done they will indicate that. Your family Physician will guide you to the next step. Only a qualified Physician or specialist will render a diagnosis if necessary.

Our judges are individuals deeply engaged in independent filmmaking and include directors, producers, writers, actors as well as film aficionados, investors and entrepreneurs.

The Globalist is regularly visited by tens of thousands of people from over 120 countries around the world on a regular basis. We believe that anybody with a keen sense of curiosity and openness to diverse viewpoints will find our content interesting and illuminating.

Readers are primarily business leaders, corporate managers, and investor relations staff looking to help their brand, employee recruitment and employee retention. Among CEO’s, the list is regarded as the third most influential corporate ranking, behind Fortune magazine’s “Most Admired Companies” and “100 Best Companies to Work For” according to PRWeek/Burson-Marsteller CEO Survey.