The contamination 'sticks' to the surface of an item. This adhesion needs to be broken. Water alone has no cleaning properties and is not sufficient to break down the bond. The most powerful ultrasonic cleaner will not work effectively without the proper cleaning solution, it is the interaction between the cleaning fluid and the cleaning tank that produces the results. Walker Electronics Ltd manufacture a wide range of cleaning solutions to suit most applications.

Not necessarily. Following normally accepted cleaning practices prior to any stain or sealant application should be adequate. These are that the surfaces to be chinked must be clean, dry (18% surface moisture content and 18-25% TMC depending on the product used), and free from previous oil finishes, lose or aged wood fibers, and other contaminants.

Yes. Successful use of our decontamination product requires application training, the correct kind of equipment and most importantly, the knowledge to understand the production of mold and mold by-product issues.

Special cleaning should be focused on surfaces that potentially come in contact with wounds or infected skin, e.g. wrestling mats and trainer’s exam table, and any other areas that are seen or expected to be soiled by human contact, e.g., locker room benches. Routine cleaning with EPA-registered cleaners, or a bleach solution of 1 part bleach to 9 parts water, is sufficient to kill staph (including MRSA). If using a bleach solution it must be freshly mixed on a daily basis.

The oral dispenser and clear medibottle are dishwasher safe. The clear medibottle can be boiled, but the Universal Bottle Adapter (UBA) and Oral Dispenser can not be boiled. Yes, but the oral dispenser should only be to the 0.6 mL point. Beyond that your hand will have a difficult time stretching enough to deliver the medication. Also, please note that there is very little back-pressure on the plunger so it is easier than normal to depress the plunger.

Use a regular smooth sponge with normal dish detergent for cleaning stains resulting from cooking. When stains are left remaining for extended periods, they may result in the discoloration of the stove and will be harder to remove. In this case special cleaning agents may be required which is why cleaning the stove immediately after use is highly recommended.

ScoopFree needs little cleaning because the parts most likely to get soiled or dirty are thrown out every month. Occasionally, you may choose to wipe down the litter box or the rake. Click here for more "Care and Cleaning" details.

When cleaning medical instruments, it is recommended that new solution is added to the bath twice a day - based on an 8 hour day. ie. once every 4 hours. Depending on the convenience and application, industrial ultrasonic tanks may require a fluid change more or less regularly. The cleaning results and fluid in the bath should be monitored for contamination after cleaning and judgement made by the operator on how often the fluid needs to be changed. Please contact Ultrawave for guidance on this.

Modern ultrasonic cleaning solutions are compounded from a variety of detergents, wetting agents and other reactive components. A large variety of excellent formulations are available, designed for specific applications. Proper selection is crucial for acceptable cleaning activity and to preclude undesirable reactivity with the part being cleaned.

This is a very common question with no direct answer. It depends on so many factors: the level of contamination on the components being cleaned, how many times the fluid has been used etc. Suffice to say, change the fluid when there is a noticeable decrease in ultrasonic cleaning action or when the fluid is visibly dirty. For most application this will not be every time the machine is used. The fluid level should be maintained at the tank ridge level, as the system is tuned to this.

Yes - if you do not adhere to the manufacturer's guidelines regarding dilution and handling. While manually cleaning lines you should always use protective clothing, goggles and gloves. Also, make sure that you add the detergent to the water – doing the reverse can result in severe burns.

Yes. Food debris may collect at the junction of the tooth and bracket and around the "O" rings used to hold the wire in place. These areas require special care.

Daily cleaning solution is used with both soft and gas permeable lenses. It is used to loosen debris and remove deposits and secretions that have formed on the lens. For more information, please see here.

No, you do not have to rinse your shower once the product is sprayed. Scrubbing Bubbles® Automatic Shower Cleaner works best on surfaces that are wetted during showering. If the cleaning solution is sprayed onto dry surfaces, it may leave spots. However, any spots can be wiped off with a damp cloth. No. The cleaning solution will dry to a clear, non-slippery film between showers to prevent soap scum and hard water spots.

No. Unlike many other systems, the LCS1 has intelligent sensors in the chemical container, which inform the controller to stop the system. At this point the system informs the user and waits for them to replace the cleaning solution bottle. Once replaced, the system will resume with the clean.

Increasing the temperature of a solution is the best way to improve its cleaning power. The use of ultrasonics or other agitation will further improve the cleaning action. Finally, lengthen the dwell time or increase the concentration of the solution.

This Concentration Control sheet will help you to determine the amount of cleaner present in a tank or rinsewater.

Everyday household cleaners - although not likely to harm the stone itself - could lessen the effectiveness of the sealer which has been applied. For regular cleaning, we recommend a specially formulated stone cleaner. For occasional cleaning or to bring back any lost luster, polish preserver is a good choice. On occasion, although granite is very solid and nearly non-porous, spills left on the surfaces for an extended period can leave some residual staining - even when sealed properly.

Windows with film applied are easily cleaned without damage to their appearance as long as a few common-sense guidelines are followed: The availability of scratch resistant coatings as a standard feature of quality films has virtually eliminated the need for extra special precautions in cleaning.

Rinsing is recommended to remove any chemical residue, which could be harmful to the part. Parts can be rinsed right in your ultrasonic cleaner, using a clean water bath, or in a separate tub containing tap, distilled or deionized water

Metal roofing and siding can be easily installed using standard hand tools such as a screw gun, hammer, metal snips, caulk gun, pliers, chalk line and tape measure. Cutting metal panels is best accomplished with an electric metal shear; however, panels may be easily cut with a circular saw with a metal-cutting abrasive blade. Standing seam roof systems require hand or mechanical seaming tools available from Fabral. See our installation instructions for complete details.

No more care than you would have had with your own natural hair. Shampoo and condition when necessary, let dry naturally or blow dry into your favorite style, the choice is yours. Feel free to swim, play sports, entertain or just relax. Whatever your life-style demands, your Samson hair is here to stay.

Colored mortar that matches or complements the Marble Face Polished /Ground Face colors can create a beautiful effect. For more information on mortars see Mortars in the GENERAL information sheets in our product literature. W.R. Grace DRY-BLOCK® is recommended for all exterior mortar.

MARVEL! works best with more recent versions of web browsers (Internet Explorer, Netscape and Mac's Safari). With Netscape 4.7, your display will be similar to a text-only browser like Lynx. You will not see all of the graphics or images but still have full access to all the text in a linear format. Please try minimizing those browsers and use Internet Explorer (IE) that came pre-installed on your computer.

Please contact your Account Manager or e-mail us your special instructions. Do not leave any notes in your home.