Yes. Some subscribers are already using the fax machine connected the phone line coming from splitter and are not having any problem with it.. However, please check with the fax machine manufacturer/ for ADSL compatibility

Coaxial cable cannot be spliced together like telephone or speaker wire. Therefore in order to 'connect' the two or more coaxial cables together a splitter is required. Splitters allow multiple coaxial cables to be connected together. Splitters range from 2 way (one cable in and two out) to 8 way (one cable in and eight out) to suit various needs. Whenever a splitter is used, it degrades the signal. Yes, they are CHEAPER. See similar questions...

Answer: LEDs show your system status visually. The good news is "It will not damage your system even you connect to the wrong pins". This means you can use "try and error" approach to find out correct pins and polarity. If it does not work as you expected, reverse it and try again. See similar questions...

Answer: A video splitter takes VGA video output from one source (i.e. one computer, or a user port of a KVM switch) and splits it to be displayed on multiple monitors. Depending on the model, the video signal can be sent over Cat5 cables or standard VGA cables to multiple monitors in varying distances from the video output source. Some models also support sending audio signals for multimedia applications, or serial signals for projection and touch-screen applications. See similar questions...

Please keep in mind that the device you plug into your phone jacks all over your house are not POTS "Plain Old Telephone Service" splitters but filters and if you are doing this all of your non DSL lines under your house are counting in your total line length and are robbing you of bandwidth. A POTS splitter goes inside of or next to your SNI/NID which is usually a gray or black box located outside where your phone line comes into your house. See similar questions...

Try not to touch the mask once it is secured on your face as frequent handling may reduce its protection. If you must do so, wash your hands before and after touching the mask. When taking off the mask, avoid touching the outside of the mask as this part may be covered with germs. After taking off the mask, put the mask into a plastic or paper bag before putting it into a lidded rubbish bin. A surgical mask should be changed at least daily. See similar questions...

Your heel should stay seated in the shoe when running and/or walking. Certain lacing patterns can help hold the heel in better if the shoe fits well otherwise. The length of the shoe and the amount of toe room you need are somewhat dependent on your mileage. In general, the more miles you run, the bigger you want your shoes to fit, because your feet swell on longer runs. Marathoners need approximately a thumb-width of space between the end of the toe and the end of the shoe. See similar questions...

First you will need to remove any tight-fitting clothing from your left arm. Now you are ready to put your left arm through the cuff loop. The bottom of the cuff should be about one-half inch above your elbow. Turn your arm so your palm is facing up. Adjust the cuff around your arm so that the tubing runs down the center of your arm. Secure the cuff so it stays in place. You should be able to fit one finger between the cuff and your arm. This space is very important. See similar questions...

Not at all! Just because you can do the math does not mean it is correct. For instance, if you did a creatinine determination on urine over a 4-hour period, you could multiply the answer by 6 and suggest this is the creatinine value for a 24 hours period. Once you understand renal physiology, not all compounds are excreted and reabsorbed at the same rate. Normal values are generally relative to a specific time period. You cannot do the math to get an "equivalent answer". See similar questions...

The design of EMG active pickups doesn't allow access to the individual coil outputs from the pickups. As such, it's not possible to wire coil taps or pickup phase switches in the traditional manner. We do provide a number of alternative accesories to help you simulate some of these tone mods. See similar questions...

For a given input power, a two-way splitter will typically decreases output by 3.5 db, three-way by 5.3 db and four-way by 7.5 db. See similar questions...

You should see a white icon in your systemtray (right-bottom of your screen). That is Haali Media Splitter. Double-click on that icon to view its options. You can also get to the options by clicking on the Haali Media Splitter shortcut in the start menu. Once you are in the Options screen, click on 'Languages'. There you can set the preferred language(s) for audio and subtitles. The language should be input using a three character code, for example eng for English. See similar questions...

If you do not have either a splitter or filter installed, then you may hear interference through the telephone when ADSL is connected. Your ADSL connection may also be affected when you make telephone calls. A splitter is used to separate the voice and data traffic into 2 separate lines. The telephone signal is connected to the circuit in the building which is connecting to the phone and the other digital line connects to the customer's ADSL modem. See similar questions...

A POTS (Plain Old Telephone Service) splitter, also known as a low-pass/high-pass filter, separates the voice and data portions of the DSL line. The customer premise splitter "splits" the analog voice signal from the DSL digital signal, and allows two wires to simultaneously activate phone jacks while others act as data jacks to the DSL modem. See similar questions...

A micro filter is a small device that plugs into your normal telephone socket and splits the line into both a standard telephone socket and a ADSL broadband socket. You must have one micro filter connected to each telephone socket on the line the ADSL service is enabled for even if you will not connect the ADSL modem / router at that point. The micro filter must be the first device plugged into the telephone socket. See similar questions...

The splitter is only used if you have an ISDN connection. The splitter separates the two bands, which are used for ISDN (up to 120 kHz) and ADSL (up to 138 kHz). See similar questions...