Solar power is generally 120-volt only, and there is an inverter involved to convert DC to AC. The manual transfer switch could be powered by solar when the "GEN" main is connected to the inverter. The two poles of the "GEN" Main would be tied together so both phases would only receive 120 volts. Therefore, no 240-volt circuits could be operated.

By replacing single breakers with "dual" and "quad" breakers, you can get 16 circuits into your PowerStay manual transfer switch. See similar questions...

About an hour by a qualified electrician familiar with residential wiring electrical codes. If installed with a power inlet box, the installation could take slightly longer. Since each unit is ready to wire, the installer simply needs to determine which circuits will be needed in an emergency/outage, wire each set of wires in the transfer switch to those circuits, install the neutral and the ground, and test the installation under load. See similar questions...

Yes. Each unit is equipped with an array of individual branch circuit breakers. Click here to see the different model configurations. In most cases, a power inlet box is required for a flush-mount installation. In this case, the PowerStay manual transfer switch would be hard wired to the power inlet box outside. See similar questions...

No. However, if the generator is to be connected to the house electrical system an approved means of isolating the house from utility power is required. This is to prevent the generator from back feeding utility and injuring the line workers that are trying to restore power. Significant damage can result from the generator being on line when utility power is restored. See similar questions...

long as you can supply enough power to the system, it can run off any electrical source. Here is a break down of the power requirements for different sized systems: Some floor surfaces will heat up a little quicker than others, but once the floor surface is up to temperature, the system has equal effectiveness. Our systems can heat any floor surface to a temperature that will be desirable. Yes, you can either activate the snow melting systems with a manual or automatic device. See similar questions...

The Solar Panel converts UV rays (sunlight) to electric current which charges the main storage battery. An inbuilt regulator prevents over-charging. A high-torque 12 volt motor is then driven by the battery. Typically there is 5 days of inbuilt storage to allow for bad weather conditions. See similar questions...

When economic source of electric power is readily available, select the regular, electric powered desalinator. It is economical to purchase, easy to install and it will be economical to operate provided that the electricity is reasonably priced. When electric power is not readily available, or is very expensive, you have a choice between diesel powered desalinator and a solar powered desalinator. See similar questions...

Yes. The switches and wires in each transfer switch are rated for 20 amps. However, in the generator mode, each circuit is limited to the amperage of the circuit breakers in the Reliance Pro/Tran? transfer switch. Some of these breakers are 15 amps and some are 20 amps. The circuits with 15 amp transfer switch breakers can be connected to either 15 or 20 amp circuits in the main panel. The circuits with the 20 amp transfer switch breakers must be connected to 20 amp circuits in the main panel. See similar questions...

Our answer is, not easily. Even two identical radios would require switching the microphone cable and the receive audio connection. If you have two different radios you will have take the cover off the RIGblaster and switch around the plug in jumpers. See our Op Tips page for a tip on how to hook up dual RIGblasters with two radios to one computer. Top of Page See similar questions...

A transfer switch is a panel that is wired into the premises electrical distribution system to allow a generator to be used. It prevents the generator from back feeding into the mains power supply which could cause serious injury to line workers trying to restore utility power supplies. See similar questions...

The Wave Relay™ device can easily be solar powered. We do not provide solar systems, but it should be easy to use an off the shelf solar power system with Wave Relay™. The Wave Relay™ device consumes only a few watts of power and accepts a wide range of DC input voltage, making it an extremely flexible device for solar operation. See similar questions...

It is your choice how many computers in your home will have access to the internet. We hardwire (run a direct line) to the main computer. From there you have a few options. The best option is to purchase a wireless router and run your network wireless. The other option is to run lines to each computer you want directly connected. We can run lines to additional computers at a rate of $50.00 each. See similar questions...

Yes, but use a switch box that switches all 25 signal lines. Look for a switch box that states "Premium Data Switch." See similar questions...

You can find a detailed write-up for one possible solution by clicking on the following link http://www.chevelles.com/techref/ftecref4.html. See similar questions...

Facing south, a 5,000 watt solar system will produce between $850 - $1350 annually in electric saving depending upon the utility electric rate. See similar questions...

You sure can. The most effective systems are on homes with a south facing roof and no shading from other buildings or trees. See similar questions...

There are a lot of different circumstances which can lead to the need to transfer your Solar Fire charts or data from one computer to another but the process to follow is the same in all cases. Look under the C:\ for your SOLFIRE folder. When you find it, click on the + sign in front of the SOLFIRE folder. ((Your Solar Fire Folder might be named SolFire3-6 or SFDeluxe) Locate the USERDATA folder within the SolFire folder. Double click on this. See similar questions...