If you already have a brick or stone fireplace, or a factory-built fireplace, and you want to convert it to gas, then the most cost-effective solution is an insert. If you are remodeling a part of your home that never had any kind of built-in structure, then you need a Direct Vent fireplace that does not require an existing opening or chimney.

im buying a new ac ready furnace for my mobilehome,., i have the paperwork from the previous owners purchase of a new kenmore outside cooling condenser,tech info and so on but it does not say its a 1 ton or3 ton or3.5 ton ,HOW CAN I FIND OUT WHAT TONAGE IT IS SO I GET A PROPERAC READY FURNACE THE FURNACE IM LOOKING AT WILL HANDLE UP TO A 4 TON I am interested in purchasing an Eden PURE portable infared heater, Model 1000, which the internet site states is 5200 BTU.

Installation of our hearth products must be done in strict accordance with local or national building codes, and the unit's installation manual. We recommend that our products be installed by a factory-trained Mr. Fireplace installer.

Yes, we sell Mr. Flame Fireplace Glass Doors which are designed to work with the Fireplace Radiator™. Click here to view them.

No, any of the freestanding fires can simply stand on a hearth, although Burley do produce a range of surrounds which can stand against a wall.

Yes. We recommend annual service of your fireplace by a qualified serviceperson. This will ensure that your appliance is functioning properly. Your decision really comes down to how much a priority heating efficiency is for you. If you want a lot of heat from your fireplace, you should consider a direct vent gas insert. From a cost standpoint, an insert will cost approximately five times the cost of a nice gas log set.

Chances are there will be a gap between the insert and the inside of the fireplace. That is why we offer a range of faceplates designed to cover the gap. The faceplate also houses the on/off switch and fan control, so you don't have to crouch or bend down to operate your insert.

The Building Safety and Sustainbility Division reviews these plans to ensure that installing the fireplace and flue does not compromise the structural integrity of the home. The plans are also reviewed to verify that the fireplace is properly vented and that the chimney is a safe distance above the roof. The installation of a wood burning stove or other heater also requires a permit.

A good start is to view our Cabinet Dimensions sheet, print it and refer to it as we discuss it here. The dimensions shown on the sheet are overall outside dimensions for standard size A & B cabinets, which will help you determine if the outside measurements will fit within the room, or corner that you are placing it in. Keep in mind that our outside cabinet measurements are for use with rear vent & vent free gas fireplaces (with the exception of some manufacturers' electric models).

It is sometimes called a base-page. It is the foundation of the album and is attached to the binding of the cover by pins, hinges, clips and stitching.

Lamartine would advise that the following should be done to prepare for the installation of your new fireplace Room cleared as much as possible (if the room cannot be cleared we would advise for you to remove curtains and cover any furniture) Please note that timber floors should always be laid after the installation of your fireplace. Lamartine will take into account whether or not you are getting timber floors and will raise the hearth height accordingly.

Yes. A floor protection is required for any wood fireplace, unless it already sits on a non-combustible surface. You have many choices, such as stone, brick or tile. You need to consult your owner's manual in order to know the dimensions of the floor protection specific to your model.

Before answering this question, it is very important that you clearly identify what your needs are. Some people will buy a fireplace simply to enhance the ambiance of a room, while others will by a fireplace as their main source of heat. There is no good or bad reason for buying a wood fireplace. If you simply want to enhance the ambiance of a room, most small to medium fireplaces will suit your needs.

Gas logs burn cleaner than wood burning fireplaces do. Annual inspections are recommended but cleaning annually isn't necessary.

You will need to contact a Mr. Fireplace Sales Representative in your area. Refer to contacts for locations

Yes, but placement is key. Again the fan needs to draw cooler air from behind to operate and the surface on which the Ecofan is placed should never exceed 340ºC (650ºF).

Freestanding stoves can be connected to chimneys built especially for them. The chimneys may be of masonry construction or be a factory-built metal system that's been designed, tested and listed for use with wood burning appliances. Freestanding stoves can also connect to an existing fireplace chimney, if the height and position of the stove's flue collar permits it. When this type of installation is done, the stoves may be called hearth stoves.

Please be aware that streamers, poppers, silly string, face paint, chewing gum, food and drink MUST be kept away from the jumping castle at all times. If the above-mentioned items are in contact with the jumping castle and it has been damaged it will be consider malicious and you will be liable for the full cost of repairs, transport costs associated with the repairs and the loss of business costs while the castle is repaired.

There are a few laboratory/blood tests needed, that NHI can provide for a nominal fee. A $1,000 deposit is required to secure your procedure date or Standby status. Deposits are refundable provided the request is made 7 days or more prior to your scheduled surgery date. Your balance is due and payable 14 days prior to your surgery date. There is a $3,000 minimum fee per procedure.