Refilling means recycling your ink jet cartridge, mostly containing the print head on the cartridge itself. Refilling is good for the environment and can save you a lot of money on your cartridge cost, too.

It is always recommended to refill the cartridge before it runs dry or refill the empty cartridge immediately. Otherwise, inks may dry out and block the print head that consists of very thin and small nozzles backed by a thermal resistor that boils and cools the ink. See similar questions...

YES! Toner is a nontoxic substance of plastic, iron and a very small amount of pigment (this information was provided by the OEM manufacturers). It’s advisable to perform the Toner Refill in a well-ventilated area, especially when using the melt and the refilling process. It’s safe to refill a cartridge as long as you follow the instructions that we provide you along with our Kit. YES. Our toner has the same gram weight as the original toner cartridge. See similar questions...

HP #40 and HP #45 cartridges use a green indicator on the side to indicate how much ink is left. This green indicator moves out of view when the cartridge is empty and may not reappear after refilling. This is due to the way that the indicator is made. However, you can tell that the cartridge is full by its weight. After refilling, the cartridge will be noticeably heavier than when it was empty. See similar questions...

That depends on your market. However, the following cartridge types represent more than 90% of the typical range: 51626, 51629, 51645, 51641, 51625, 51649, BC 01/02. See similar questions...

Refilling means recycling your ink jet cartridge. Basically you reload your existing printer inkjet cartridge with new ink. Refilling is good for the environment and can save you a lot of money on your cartridges costs. See similar questions...

Using the syringe supplied in your refill kit, inject air into the top air vent to clean the nozzles. A small amount of ink should be emitted from the nozzle upon injection. If this procedure is ineffective, fill a small dish with warm water and soak the nozzles for approximately 1 hour. After soaking dry the nozzle using a soft tissue or cotton swab and inject air into the top vent. Reinstall the cartridge and attempt to print again. See similar questions...

No, refilling your cartridge does not have to be a messy process. Latex-free gloves alongwith cleaning tissues are included in your ink refill kit and it is strongly suggested to refill your cartridge over newspaper or a sink. The main thing to remember in order to have a mess-free, successful refill is to inject the ink into the cartridge slowly since you are displacing air with ink. See similar questions...

Refilling your empty inkjet cartridges not only reduces the burden on landfills, but it also has a positive impact on the world's resources.  Inkjet cartridges are made of plastics. It takes approximately 2.5 ounces of oil to manufacture a new cartridge. It is estimated that 8 cartridges are thrown away every second in the United States. It takes hundreds of years for the plastic to decompose. It just makes sense...recycle and  save! See similar questions...

No, they do not have any form of money at all on Thiaoouba. They say that the monetary system is a true curse on Earth. Most people on Earth are totally enslaved by the monetary system (by taking a job and a loan for example). They pay interest all their lives (@0.5 million dollars per person over their lifetime) and it never crosses their minds that by doing so they help strengthen the very system that makes them slaves. See similar questions...

Replacement ink and toner cartridges are ordered by each department. ITS can help you identify the correct replacement cartridge and supplier if necessary. See similar questions...

Install a Cleaning Cartridge to remove the particles which cause blocking of the print head. Cleaning Cartridge may also be used before each installation of a new cartridge to maintain the print head in good condition. Experiments have been conducted to prove that the solvent is not corrosive to the print head and, therefore, no damage is experienced. See similar questions...

The Printing Mailbox must be plugged in before inserting a new or replacement print cartridge. Once the device is plugged in and the blue Ready light is on, please proceed as follows: Step 1—Open the top cover. Push the cover gently until it stays up. Wait for the printer carriage to move to the right side of the Printing Mailbox. Step 2—Lightly press down on the print cartridge to release it (a), then remove it from the cartridge slot (b) as indicated below. See similar questions...

There is no fix number of prints you can get from a printer ink cartridge. There are too many variables to consider when talking about such an amount. It mainly depends on the manufacturer and the size of the cartridge itself. In other words, it depends on the type of printer you have. However, roughly speaking, the average printer ink cartridge will provide you with around 800 pages for color and 600 pages for black. See similar questions...

The printer will not let you remove a cartridge unless the empty light is on. Here is what to do: Turn the printer on and when the cartridges are in a position so they can be removed, pull the power plug. They will stay in this position and can easily be removed. When the power is turned back on the cartridges will return to their proper position. Empty cartridges that are unwrapped and not installed in the printer will dry out and may become clogged. See similar questions...

This can happen to cartridges with attached print heads such as HP, Lexmark or Dell. All cartridges are weighed and tested before leaving the factory so lack of ink isn't the problem. It usually has to do with the print head of the cartridge not having any ink to feed it. This happens because cartridges are kept flat or upside down for weeks or months before being used and the ink settles away from the print head. See similar questions...

The two most common signs are (1) white streaks where there should be black ink and (2) lighter-than-normal print. Sometimes these also can be signs of clogged nozzles, bad circuitry or worn internal components. There are a lot of myths about compatible cartridges. The following should clarify most of the misconceptions : Reality 1: It is very unlikely that a problem with your printer equipment would stem from the cartridge. See similar questions...

No, and we do not sell universal refill kit or cartridges. One type of ink will not work with all printers models, for ink molecule, chemical elements and density of ink are different for every printer model. If wrong ink is used, it may clog the nozzle and affect the printing quality. See similar questions...

HP uses AN and DN after their cartridges to differentiate between their high and low capacity cartridges. InkSell.com carries remanufactured high capacity cartridges. Our remanufactured cartridges will still fit into your HP printer and give the same yield amount as a genuine HP color cartridge. See similar questions...