Make sure that both the TV and VCR are set to the proper output channel 3 (or 4) and program the VCR to turn on at the appropriate time. Tune the digital terminal to the channel you want to record and leave the box on. See similar questions...

Your digital television/Freeview box will only have one digital tuner. Therefore, in order to watch a different freeview channel at same time as recording a freeview channel, you need to connect another freeview box to your set up. In order to keep wires to a minimum you may wish to purchase a DVD recorder and integrated freeview box like the RDRGXD500. See similar questions...

Make sure your TV and VCR are set to channel 3 (or 4). Program your VCR to turn on at the appropriate time and make sure it remains tuned to the proper input channel. Tune your digital unit to the channel that you wish to record and leave the system on. This is commonly known as ingress, which is caused by two different signals competing for the same channel. Ingress can be caused by any of several conditions. See similar questions...

Your VCR just has to be set to TV mode, which is analog. Program your VCR or start recording when the show starts. Then, press the TV button to choose digital input using the BYPASS button. Finally, press CABLE to change channels on the digital decoder. This lets you watch a digital channel while recording an analog show. P.S.: If you think you will be recording more often in digital, set your VCR to digital; if you record in analog mode, use the instructions above. See similar questions...

The most likely cause of this problem is the station power is not sufficient to spin the disk, in which The interval is shorter than, or equal to, the record length. The interval is the time between the start See similar questions...

Start recording the digital program when you start watching the cable channel. In this case, the digital decoder has to be set for the channel you are watching. When the recording starts, go from digital to analog mode. To do this, go to TV mode by pressing the TV key, then the BYPASS key, which is just below the 7 key. Then, VIDEO 1, VIDEO 2 or even VIDEO 3 is used to record the digital program. Simply chose the TV mode. See similar questions...

Yes you can but it's not a function of the cable box. The easiest way to do this is to install an A/B switch to the incoming cable, then run one cable to the digital cable box and the other to your VCR. Then, you can watch TV on the digital cable box and record on the separate signal running to your VCR. See similar questions...

Yes. But you must have a GUIDE Plus+ unit with more than one tuner, or you can use a splitter (Y-piece) and connect your GUIDE Plus+ unit and your TV separately. With a splitter you can connect one end to your TV and one end to your GUIDE Plus+ unit. See similar questions...

When you print the pictures, a data form prints at the same time. This form will match the treatment set you chose. Use this form to record data during your treatment session. Later, go back to the same treatment profile and select it. At the bottom of the page, click "Enter Offline Data." Enter the data you recorded earlier. See similar questions...

Not at this time but we are working on a software upgrade that will allow the Ti48 to record into the hard-disks using the digital ( S/PDIF) input. See similar questions...

Yes.You can record and playback Digital Music.However, the playback controls (Pause, FF and REW) are not functional for recorded digital music. See similar questions...

Yes, each input channel has a digital attenuator. This is found on the ATT/HPF/EQ pop-up. Control is from the first multifunction controller below the screen when this window is open. See similar questions...

WCSA100 has NO "audio in" device. The included software Webcam WatchdogX can take audio input from Windows wave device. You can use other Windows compatible 4 channel sound card to achieve 4 video and 4 audio recording with WCSA100 if you wish. Unless you need CD quality audio, otherwise using WCSA440 will be easier and cheaper than the other solution. The 440 was developed a year later after WCSA100 simply for this. See similar questions...

In Mono, the original sound is picked up by one ( or more ) microphone(s). Only one signal is recorded, regardless the number of microphones that have been used, i.e. only one signal is involved in the playback stage. Disc phonographs, television, motion picture and radio all use monophonic system. 2 Channel encodes a left and right signal (this is refered to as stereo sound). Channel sound is refered to as Dolby Surround. See similar questions...

Occasionally one sees individuals with Crohn's disease and ulcerative colitis who have one attack and never have another one. A more common pattern however is for it to settle for long periods of time and then act up. The vast majority of people with Crohn's disease and ulcerative colitis lead normal and productive lives. They work, have families and go on vacations like anyone else. See similar questions...

Juvenile records are not erased when the juvenile becomes an adult. They are permanent but confidential and cannot be given out to anyone without a court order. The armed Services, Colleges, or some employers can request release of juvenile records from applicants. The City of Keene has two Diversion Programs for two different levels of offenses. The level of offenses are status offenses and deliquencies. The two programs are CHINS Diversion Program and Juvenile Conference Committee (JCC). See similar questions...