It is preferred to use a thinset mortar for floors, but in residential use, mastic can be used with tile up to 6" x 6" in size on floors.

Concrete Floors must not contain a sealer or finish of any kind. For installing below grade (below floor level, like in basements), we recommend Basement Proofer to prepare concrete floors. First, clean the sub-floor for any remaining dirt and grease. Tiles must be in the room of installation for at least 2 days to stabilize temperature. Never use polyurethane over vinyl tile. See similar questions...

Ceramic tile can be bonded to ceramic tile with a polymer modified thinset BUT your installation will only be as good as the weakest tile in the old installation. See similar questions...

You first need to flatten the floor with a skim coat of a Portland cement based patching compound. Or, you can simply install a floating clic cork floor directly over the existing tile. See similar questions...

Yes, you can install a 3/4'' or 9/16'' solid wood floor over a radiant heating system, provided you know how the latter works and how it may react to flooring. Solid wood floors installed over such a system must meet certain specifications and recommendations. See similar questions...

The am-cor? system was developed with this type of heating in mind. It is our opinion that solar based radiant is the most efficient way to heat a structure, saving both cost of purchase and operation of HVAC equipment. Radiant floors and ceilings may be heated by a gas-fired boiler, or by solar panels with gas backup. So for a little more than the cost of a large water heater, gentle heat may be distributed throughout interiors via the structure itself. See similar questions...

Typically the removal and disposal of that type of asbestos containing material is not regulated by EPA (even commercially) if it is in good condition. If the material can be taken up with no significant breakage, there is little risk for fiber release. See similar questions...

The answer is yes, but if a room has under floor heating, it is doubly important that it be properly installed to allow for expansion and contraction. We are able to supply manufacturers' technical specifications regarding underfloor heating. See similar questions...

Yes, when proper installation methods are followed. Exterior applications require special precautions and installation methods. Do not install floor tile on exterior walls unless the product specifically recommends this application. See similar questions...

Ceramic tile in either glazed or unglazed form do not need to be sealed. These products are impervious to moisture and topical sealers will not properly adhere to them. Also, you can not change or alter the appearance or the sheen of a ceramic tile by adding a sealer. Therefore, a sealer in not recommended for glazed and unglazed surfaces. See similar questions...

Tile mosaics are a wonderful, lively addition that complements the appearance of your pool. They can be selected and ordered upon your visit to choose waterline tile. See similar questions...

Water and oil will bead up on your floor when sealed as recommended in our Installation Specification Guide. You need only mop it up with a sponge. For routine cleaning vacuum or sweep it, as you would any other natural stone floor or a wood floor. To wipe up, use a non-acid based cleaning product. Warm, soapy water is also fine. AquaMix makes a tile cleaning product, Concentrated Stone & Tile Cleaner, which can be used on your floor. Check their website at www.aquamix. See similar questions...

No paint must be removed off of a concrete floor before tile can be applied. Removal of Paint can be done by scraping it or a shot blaster machine. See similar questions...

If the floor is cracked it is advisable to use an anti-fracture membrane, otherwise cracks may transmit through the tile. Also as stated in question #2 you cannot tile over a painted concrete floor. See similar questions...

Do not use household dust treatment chemicals on the tile. Use a vinyl floor cleaner and separate finish. Both must be water-based. Vacuums: Do not use a beater brush on a vinyl floor. Use the proper solid floor attachment for vacuuming. NO WAX! Do not wax a vinyl floor. All of our vinyl flooring contains a no-wax finish. The flooring is non-porous and will not absorb wax. It will build up and collect even more dirt. See similar questions...

Because tile is a unique product, it takes a craftsman to install a tile roof properly. Professional roofing contractors install over 96% of all tile roofs. A handy person may be able to lay field tile without much trouble, but installing underlayment, battens, flashings for valleys, chimneys, solar panels and skylights and cutting the tiles along hips and valleys are more complicated tasks. We recommend using an installation professional to properly install your tile roof. See similar questions...

Layout - My husband is having trouble with the layout/cuts in the ceramic tile for our tub/shower area. There is an uncentered window in the primary wall. He keeps saying "no matter how I figure it, I still end up with 1/2" gap at the top of wall". Is there any way you can tell him what he's doing wrong? Thanks SOOO MUCH! Exterior Chimney - Do you have any information on tiling the exterior of a stucco chimney? Below freezing in winter. See similar questions...