The year (94 to 96), or model (Impala, 9C1, LT1 equipped Caprice) makes no difference in the lockup speed. It was whether you had the Chuggle & Surge TSB update. All the above numbers are +/- 2 mph in range, and are accounted for by either speedometer error, or error in reading the speedometer. Those lights actually use 2057 bulbs, which are dimmer both on low and high filaments than 2357s.

Any type of structural crack on any solid cement type surface, 3" or thicker. Learn about the different types of cracks.

This question applies to Automatic Transmissions only. It's not required, the factory converter will be OK to use. But depending upon the use of the vehicle on the street or the track then maybe one step up on the factory stall speed could improve acceleration off the line. Other factors like the weight, gearing , tire size can come into play too. Speak to a Transmission expert on this. Two part question.

Torque is a force that, when applied to what object, causes a turning motion. Torque is used to open doors, tighten screws, rotate wheels, and ride see-saws. Although forces are used on all these objects, these forces do not cause the object to accelerate in a straight line, but instead to turn. Torque is calculated by multiplying the force that is applied to the object by the distance the force was from the axis of rotation.

Breakaway Torque is the amount of torque that an actuator can generate immediately when power is supplied — the torque generated from a standing start. Stall torque is the actual amount of torque an actuator can generate — measured as the amount of torque required to stall the momentum of a running actuator. For electric actuators in general, breakaway torque is a minimum of 20% less than the stall torque.

The only other method is epoxy injection. Epoxy injection is a cement sealant that dries and hardens to seal the crack. In essence, you are gluing the crack together. Water will eventually find its way through.

When we talk about an Inverter, we are talking about converting from a DC power source (usually a battery) and Inverting the Flat DC into For a Converter however we mean converting from one DC Voltage to another, for example whether it is converting up from 12VDC > 24VDC or What's the point of a low voltage disconnect? I want my system to stay running as long as the battery will last.

A Converter re-routes the pinning to meet the demands of the package of the chip. No additional drivers are required. Adapter is the same as a converter with the additional of a bit of electronics to meet the demands of programming the chip. This can be a buffer, oscillator etc. An additional driver is required.

The time frame in the description will show the minimum time frame possible for shipping the item(s) of your choice. While they may arrive sooner, we will not accept an order requested sooner or make such a promise.

OBD stands for On Board Diagnostic. There are 2 versions. OBD-I and OBD-II. In 1970 Congress passed the Clean Air Act and established the Environmental Protection Agency (EPA). This started a series of graduated emission standards and requirements for maintenance of vehicles for extended periods of time. To meet these standards, manufacturers turned to electronically controlled fuel feed and ignition systems.

Coupon-eligible converters are currently not in stores. Beginning in early 2008, they will appear in stores where you would also buy televisions and other consumer electronics products.

A slip tip syringe has a smooth pointed tip, a luer lock syringe has a threaded end, which twists and locks into a needle.

The differences are that the complete package includes insulation for walls and ceilings, drywall, interior doors and bi-folds, door and window casings,baseboards and optional cabinets.

A rotary phase converter runs your three-phase equipment continuously on existing single-phase power (220V). A static converter will start three-phase equipment and therefore can be useful when used with the appropriate device, but it will not run three-phase equipment continuously. Some American-made motors can be started with a static converter, but will then run at a lower power output. (For more information, call toll free 1-800-454-6555.)

A voltage regulator functions as a voltage converter as well as a voltage stabilizer. A voltage stabilizer will stabilize the electricity to a fixed current. VC model transformers come with a European-to-American plug adapter. You can find additional types of plug adapters on our site.

A Transformer is an electrical device by which alternating current of one voltage is changed to another voltage using coils. There are several different types, but they all basically do the same thing - change the voltage. They are usually heavy for their size due to the weight of the coils (size and weight depends on their rating). A Converter is an electronic device that is used in some cases instead of a transformer.