Yes, but most times you need to install additional window and door trim to ensure that the product lies flush with windows and doors. Sometimes this additional trim requirement makes it less expensive to tear off the old siding and start from scratch. Look at the diagram in the CSSB's Exterior and Interior Wall Manual for more details.

Log siding gives the "Log Look" to your home, cedar siding is more contemporary - preference in taste AND appearance is the deciding factor of difference... Log siding is a horizontal siding, so it must be prepped and installed after you get it - making Log Siding vs Cedar Siding a choice of convenience vs. personal needs or tastes.. See similar questions...

Western Red Cedar contains natural oils that act as a wood preservative to resist insect attack and decay. It exhibits high dimensional stability and contains no pitch. Properly pre-treated, installed, and maintained Western Red Cedar siding can enhance a home's exterior for 50-70 years. See similar questions...

Assuming local Building Official approval for this type of installation is obtained, you should use the length of nail recommended for that specific material. Add the thickness of the existing insulation and this gives you the nail length required for the fastener to penetrate ¾" or more into the sheathing. Refer to the CSSB's Exterior and Interior Wall Manual. See similar questions...

Although cedar is a natural durable species, leaving it untreated is not recommended because a finish or protective coating will greatly increase it's service life. Cedar is free of pitch and with its high degree of dimensional stability, it is the best of the softwoods for accepting paints, stains, oils and other coatings. Lakeside Lumber recommends an initial coat of high quality oil based primer on all four sides of the siding, followed by two coats of high quality 100% acrylic latex paint. See similar questions...

Our sheds normally come with a 5/8th inch pine siding, but if you plan on putting on vinyl or some other type of siding, we can put on OSB siding. OSB (chip board) is a little cheaper and better for vinyl siding. Just let us know when ordering that you plan on putting up your own siding. See similar questions...

Our unique three-coat process consists of one coat of sealer and two coats of tinted top coat, for a finish that is beautiful and will last. See similar questions...

The CSSB only deals with cedar shake and shingle roofing and sidewall queries. You should contact the Western Red Cedar Lumber Association at www.wrcla.org for more assistance. See similar questions...

This can be caused by excessive filing. The file used on your nails also may have been too coarse. Be sure to tell your nail technician you have sensitive nails. Red puffy cuticles may also be caused by a reaction to products used on your nails. Consult your nail technician to prevent problems like this. See similar questions...

A fungus is a living organism that thrives in dark, damp environments. Fungal infections are very common in nails on both fingers and toes, but toenails are more likely to be affected by the fungus since it is attracted to dark and damp environments more typical of the foot than the hand. Affected nails have a yellowish or brownish discoloration and may thicken or become brittle over time. See similar questions...

ArtPro Nail Printer is a machine that can print different colourful patterns directly onto fingernails or tips (finger or toe tips). Just insert your finger or a set of tips directly into the machine and beautiful fine detailed patterns will be printed onto the nail/tips in a flash, resulting in a higher quality design than that of nails done by hand. The speed of application results in higher efficiency and better returns. See similar questions...

Generally, yes. Felt paper and other moisture barriers should not be used between the panels and siding; however, an air barrier such as Tyvek or Typar is recommended. See similar questions...

Most type of type of cladding can be applied to the panel (acrylic stucco, vinyl and metal are applied directly to the panel). As an alternative, the panel’s outer skin can be supplied in weather resistant surface. In that case surface finishing resembles wooden siding and it does not require any additional siding. Felt paper and other moisture barriers need not be used between the panels and siding. See similar questions...

The hair is individually bonded using the latest Ultra Sonic technology. Holly is one of the few in the Mid Atlantic to provide this advanced application technique. See similar questions...

ASC has an assortment of Beretta and Browning shotguns available in Houston for you to use. We need a 3 week advanced notice if you would like to use a specific gun and we will do what we can to have it for you! See similar questions...

Certi-Guard® products will not affect the copper; the treatment seals any tannic acid into the shakes or shingles. See similar questions...

The Boss™ can be used on most metal, including galvanized metal to protect the finish. In addition, you can use The Boss™ on any surrounding areas covered by wood. Apply multiple light coats of The Boss™ to a clean warm surface in direct sunlight, ensuring that the product dries completely between coats. See similar questions...

Cedar is light weight but very durable and is unique in its resistance to bugs and its ability to weather without treatment (unlike other species). No. White Cedar will last 25-30 years unfinished. There is no need to treat the wood, because it is naturally resistant to rot and pests. However, some people like a little color; for that, it is recommended that you stain the product (rather than to apply paint to it) in order to retain the natural protection of cedar. See similar questions...