Yes, any flat roof is suitable for an EPDM covering, so long as the roof can be walked upon. Structurs such as prefabricated corrugated roof garages are not suitable.

We recommend a light-colored, thermoplastic membrane for almost all flat or low-sloped roofs, whether a small porch roof or a large commercial building. "Thermoplastic" means that the membrane is heat-welded together at the seams, providing an almost monolithic roof covering, assuming the those welds are held to high quality-control standards. Some other roof membranes rely on adhesives or tapes for bonding at the seams, which tend to fail over time.

EPDM membrane can be used for low and steep slope roofing, as well as unusually shaped structures (such as domes, barrels and other geometrically shaped roofs) due to its versatility. The membrane can be adhered, mechanically fastened, or loose laid. It can be installed above or below insulation (i.e., an IRMA application), and can also be used in below grade waterproofing applications.

There is no one roof system that is best for all applications. Keep in mind that even if you are using the best materials, your roof system still can be installed improperly and you could end up with a leaky roof. Good workmanship and proper attention to detail (e.g., flashing and drainage issues) are just as important as material selection. Also, maintenance plays an important role in roof system integrity and service life.

EPDM has a proven track record in various waterproofing and pond lining applications which somewhat resemble roof top applications. However, there are certain rules that should be followed when designing a roof top garden regardless of the type of membrane used: No. No special coating or other surface treatment is required. General maintenance in the form of good housekeeping should periodically be performed to remove debris and leaves, and to investigate the performance of other components.

Yes. Insulation is used as filler between the flutes (or ridges) of the metal roof panels and then overlaid with a rigid board. Both layers may be mechanically attached or adhered to the metal panel roof. The EPDM membrane is then adhered to the rigid insulation or mechanically fastened to the structural purlins beneath the metal roof.

The availability of a wide range of accessories and components make an EPDM roof system versatile. For example, the membrane can be adhered directly to wood and structural concrete decks, or mechanically anchored to steel decks. For decks with low pullout resistance (i.e., gypsum, fibrous cement and light gauge steel), special fastening components are available. Ballasted assemblies can be used on any deck as long as the structure is capable of supporting the weight of the installed system.

The use of reinforced membranes over a rigid substrate such as Den-Deck, high density wood fiber board and plywood provide excellent protect and both pecking and the dropping of clams to break them open. Additionally placing pavers over any of the EPDM membrane thicknesses would also provide protect as would an IRMA roof system design. Special detailing of the corners, such as double flashings are also recommended.

A Galvalume? SSR is an ideal system for retrofit roofing. Its light weight makes it suitable for retrofit applications over any old, leaking, conventional, nonmetallic roof system. Retrofitting is accomplished by installing to the existing roof structure a light weight sub-framing system, generally made with light structural steel sections, that provides a minimum ?:12 slope for the new Galvalume? SSR.

Yes to both, but the panel would need to be mounted onto a special frame and extra piping may be needed. There would be an additional cost, which the installer will discuss with you.

Wood shake roofs give a quality appearance to any home and Rustic Shingle has the distinctive look of the wood it replaces. Many of the most prestigious homes use shake roofs for an eye-catching appearance. The deep, natural texture and earth-tone colors of Rustic Shingle give it the authentic look of hand-split cedar shakes.

It is usual to fit the panels over the existing roof tiles as this is much cheaper, however solar panels can also be integrated into the roof.

Yes. We fit genuine brand Velux Roof Windows and not the cheaper roof windows that are also sometimes referred to as "Velux" but actually belonging to another manufacturer. We do not install Colt Roof Windows and do not stock this range of roof lights

No matter what kind of school building you have, an installation can accommodate your roof type. In the past, schools have installed PV systems on flat roofs, sloped roofs, as awnings, and on ground-mounted poles.

EPDM is a synthetic rubber polymer made from ethylene and propylene monomers. It was developed in the early 1960's and is used in radiator and steam hoses, freezer gaskets, tires, roofing membranes and aircraft seals to name only a few applications where EPDM is superior to other materials.

The answer is no. Apart from rare exceptions its physical and mental-emotional growth will be prejudged. The puppy should grow on a natural ground (earth, stones, sand, mud, grass) at least until the morfological and character completion (when it is nearly 3 years old).

If you know your prescription, then try: Am I Suitable? for a quick check. The only way to know for sure, and to find the best treatment for you, is to come and see us for a FREE consultation. We have vision correction solutions for long-sight, short-sight, astigmatism, presbyopia (the age related need for reading glasses) and those with strong prescriptions.

Yes, but tile roofs require a special order. Click here to contact Tubular Direct for more information.

There are a number of brush-applied, liquid roof coatings available through your local branch, which provide waterproof protection to most conventional roofing surfaces. Contact your local branch for further details.