If so, the button may have been pressed by mistake. The alarm will now "chirp" once a minute for up to 15 minutes.

If you are not seeing the "Yes" button to continue to the Player, your font size may be set too large within your browser preferences. Go into Edit>Preferences>Appearances>Fonts. Try using a smaller Variable and Fixed Width font. About Netscape Canada | Join Netscape Online Internet Service | Netscape.ca E-Mail | Netscape en Français

With so many different alarm systems in use my best recommendation is to have your alarm company walk your staff through the process.

If you are in a constant state of radiation exposure and wish to silence the alert, just open the housing and remove the battery. The included manual will instruct you how to easily open the unit. ALL-AMERICAN Steam Sterilizers are used world-wide to sterilize a wide range of materials. Temperature, pressure, and time are the main factors in this process.

The Reset button is used to retrive the setting that was last saved and discard any changes made that were not saved in your current session.

Your alarm company will provide you with testing information. Please follow their instruction carefully to avoid unnecessary false alarms.

Make sure the battery is installed properly and snapped all the way in place. Even if the alarm sounded briefly when the battery touched the terminals, you still need to make sure it is snapped securely in place. If the battery is loose, it cannot power the smoke alarm properly. and AC/DC units will have a power indicator light (red or grean) that shines continuously when they are receiving electrical power. The smoke alarm may not have been properly activated.

Enter your four digit user code twice. The first time will silence the alarm and the second time will reset the system.

No. You may press reset at your convenience to stop PeaceMaker from flashing/beeping, which it does to inform you of siren silencing. Even if you don't push the reset button, PeaceMaker will automatically enable siren soundings after Type 1, Type 2, and Type 3 false alarm conditions no longer hold. After a false alarm, PeaceMaker will eventually run out of charge (typically in the 12 to 24 hour range) and will go to sleep. This will have the same effect as pressing the reset button.

The tilt/motion sensors do not work until 30-40 seconds after the doors have been locked. To test the alarm, roll down your windows then lock the car. After waiting a minute or so, stick your hand in the window. The motion sensor should set the alarm off.

The reset button is usually located on the burner. It is generally a red button (as opposed to a switch) on top of a grey control box that may read Primary Control. In many cases the reset button is labeled. Have your Service Technician point it out to you at your next annual service.

The Chat Reset button should only be used to reconnect to the VPC Chat Server if you're disconnected by accident or to reset the chat if it's giving your errors. The Chat Reset button will not log you off the VPC and/or log you back in again.

It stops PeaceMaker from flashing/beeping. The flashing/beeping is used to inform the operator of the reason for siren silencing. It clears all memory of alarm triggering history from its memory. This is especially important for Type 3, which bases its decision to silence the siren on the previous 2 to 8 hours of alarm triggering history.

The siren is programmed to stop after 12 minutes or at whatever time the installer has set. During Fire Alarms the siren does not silence until the panel is reset. Once the siren does silence the system is still armed and able to activate if another event happens.

Example: With Alarm Setpoint as 0.65%, the alarm is activated and resets at 0.55% with the difference of 0.1%.

Yes. However if you need to look at the course to answer the next question on the test, make sure that you write your answers down on a note pad. Using the back button on the browser will reset all of your answers to "A".