Normally it is not necessary to clean the brine tank. In time dirt and silt can build up in the brine tank and if you choose you can clean it out. Let the salt level drop down very low. The night before you clean, manually regenerate the softener. Disconnect the brine line and dump out the old salt, (Do not dump the old salt anywhere near living plants). Reconnect the brine line, add about (3) gallons of water, and add the new salt.

Usually it is not necessary to clean out a brine tank, unless the salt product being used is high in water-insoluble matter, or there is a serious malfunction of some sort. If there is a build-up of insoluble matter in the resin, the reservoir should be cleaned out to prevent softener malfunction.

We recommend keeping the level of salt in the brine tank about half full for most households. Larger households can start out with more. Let the salt level drop down to the water level before adding more salt. Potassium should be kept as close to the water level as is practical to help prevent a “salt bridge”. Periodically you may experience a salt bridge. A salt bridge occurs when the salt forms a crust right at the water level in the brine tank.

Aqua Pure does not recommend for the brine tank to be elevated above the resin tank. During the brine and slow rinse cycles, the brine may be used too quickly because the elevation could cause less restriction on the injector, thus allowing all of the brine to be used too soon.

The Water Quality Association has performed studies on this subject. These studies have indicated that a properly placed septic tank that works adequately cannot be damaged by brine that is discharged from a water softener. And softened water can sometimes even help reduce the amount of detergents discharged into a septic tank.

All the precious rainwater is kept in your tank and only the rubbish is removed in the cleaning process. However, hanging on to water in very poor condition only serves to contaminate fresh water.

If you do not overcrowd the tank and do not over feed the fish, you can treat the coffee table aquarium as a normal tank. Once a month remove 10% of the water and add fresh "aged" water. Some areas of the country require bottled or "RO" water for aquariums. Check with your local pet store for more information.

The amount of salt placed into the brine storage tank has nothing to do with the amount of salt used during the regeneration cycle. Water will dissolve and absorb salt only until it becomes saturated. A given amount of brine (salt saturated water) contains a specific amount of salt. Just make sure that there is at least enough salt for a regeneration cycle (12 lbs. in the case of our unit). Most homes are plumbed with ?" copper pipe (in larger custom homes might be 1").

For meat curing purposes, a brine, also known as a sweet pickle cure, is a mixture of Morton® Tender Quick or Morton® Sugar Cure (Plain) and water. This mixture is then pumped into the meat or the meat is placed in the brine and refrigerated for a specific period of time. Back to Top

After every pump out we recommend you clean the tank with fresh water and one of those enzyme cleaners or “Odorloss”. Coast Guard regulations tell us we must use the tank. Considering what we put into it, it requires attention to keep it clean.

It all depends on the hardness of your feed water. If you are using a water softener, it may never scale up and cleaning the surface areas may not be necessary. If you have hard water, then you should clean the boiling tank whenever the metal surface of the heating element is no longer visible because of scale cover.

Primarily, keep your gutters clean. This will ensure plant matter such as leaves will not end up rotting away at the bottom of your tank and contaminating your water. Secondly, reduce sunlight infiltration into your rainwater tank. This will inhibit the growth of algae. If a manhole/access cover is fitted to your tank, ensure that it always in place. Thirdly, have your tank regularly cleaned by a professional tank cleaner. Please refer to Tank Care and Maintenance for more information.

Yes, except for systems that have a riser or manhole installed over top of the septic tank access port. How Often Should Our Septic Tank be Cleaned? The Department of Health and Environmental Safety recommends a septic tank be cleaned every 3 to 5 years (depends on usage). Frequent use of a garbage disposal puts more hard material and grease in the tank, which shortens the time span between tank cleanings.

No. A clean-out is used to unstop a line from outside of the house and is generally placed within a couple of feet from the house. A tank can be cleaned through a 4: x 6: pipe installed over the tank lid which is called a riser. However, we do not recommend this method of clean-out. In case of an emergency, a riser dos not allow for easy access to the tank lid.

Hatching baby brine is relatively easy. You can go the your local pet store and buy a hatching kit which includes brine shrimp eggs and a hatcher and follow the included instructions. Purchase a brine shrimp net if one is not included in the kit. You can also build a hatcher of your own out of a one-gallon jar with an airstone or as I do, use an inverted 3-liter bottle with air feeding from the narrow neck. I cut the bottom out of the bottle and save as a cover.

Mono Lake Brine Shrimp have two to three generations every year, and they live for up to 6 months. They all die off by the end of the year as the water cools. Cysts hatch the following April and the cycle repeats. Click here for more on Mono Lake Brine Shrimp. top

This a detail guide on how to clean your fish tank. Apart from just the general guide, there are things that you MUST do and MUST NOT do. Make sure you read this one. Java moss is a very popular aquarium plant since it will adapt to most conditions and require a minimal amount of maintenance. Tropical fish need warm water - here are some tips on getting a good heater that will keep your fish happy.

This depends on the severity of your water problem, the size of your tank, and the amount of water that you use. A typical 5,000 gallon tank will stabilize anywhere from a few days to a few weeks. If your tank is 10,000 gallons and needs a lot of cleaning, it can take a several weeks to completely stabilize. Regardless, you will notice a dramatic change in your water within a few days.

Lumen is an excellent de-scaler. If Lumen is not readily available, white distilled vinegar, 50/50 mix with hot water, can be used. Let the solution sit over night for at least 8 hours, Using a plastic bristled brush, never metal, scrub the surface areas of the tank. You may be required to repeat the soaking process if the tank is heavily scaled.

Yes! There is not one product on the market that will take away all the hard materials in your septic tank. We recommend a treatment that will enhance the performance of your system and keep you drain lines open. Our products contain enzyme producing bacteria that aid in breaking down the solids. This is good because the cleaners , bleach and soaps we use kills the bacteria that septic systems need to function effectively.