AXTRO® is capable of heating areas above 260 square meters (buildings constructed to regulation 10/91) with any number or type of radiator installed.

Solution: Gradually close the air control mechanism in order to keep the flue temperature within the comfort zone, between 250 and 475oF (150 to 250oC). If you do not have a chimney thermometer and would like to get one, visit your local Osburn dealer. Solution: Replace the gasket using a genuine OSBURN adhesive and gasket kit. Please consult our accessories sections. Solution: Put less wood into the fireplace. The fireplace will not produce as much heat and will not heat as long.

Solution: Use smaller pieces of wood and place them to allow proper air circulation between the logs. The same weight of wood cut in many small pieces will produce more heat than fewer, larger logs. Only add big logs when you have a good bed of red embers. Logs with a diameter exceeding 6 inches (153 mm) should always be split. Avoid stacking logs to the top of the fireplace. Solution #1: In many cases, a weak draft is simply due to insufficient heat in the exhaust system.

InFlame Fireplaces have a heat output of up to 9000BTUs/hr depending on the fireplace. This is guaranteed to bring ample warmth to any room in your home. A typical electric fireplace offers from 1500 to 5000 BTUs/hr (approximately.) so our entry level 6000 BTU/hr max. output fireplace will provide you with a great heat supplement.

Yes. All our fireplaces incorporate a self-generating millivolt system that operates independently. The only part of the fireplace that will not operate at time of power failure is the blower, if one is installed on your unit. Yes. All our fireplaces must have the ability to shut off the flow of gas if the there is no flame to burn it off. All models must meet strict safety certification requirements and testing. Always make sure that a licensed gas fitter installs the unit that you purchase.

All gas fireplaces are equipped to burn either natural gas or propane. When you order a fireplace we will determine which fuel will be needed. After the fireplace is installed, if you want to switch from one fuel to the other, this can be easily done (for most models) using an approved conversion kit. It is always good to discuss before you purchase, if the unit that you are considering is approved for conversion at a later date.

Most current Montigo fireplaces that have a standing (continuous) pilot ignition system will still operate during a power outage. Fireplaces like these generate a small amount of their own electricity - enough to operate the gas control - so that the fireplace will operate safely even when your furnace will not. If you have optional fans or a handheld remote control installed, they will not run during a power outage.

Are you using any room deodorizers, burning candles, spraying hair spray, paint, stain shellac, polyurethane, laying new carpet, or is there anything new in the area? Also are there any smokers in the house? If yes, the heater will pick up tobacco smoke and spread it through the house in the form of a yellow film clinging to walls. If you have pets, please also note that animal dander will produce the same results.

There are a few precautions to take before implementing this TV application. First, take a thermometer and tape it to the wall above the mantel (where the plasma TV will be placed). Then and build a fire, let it roar while. Check the thermometer. If the temperature is above 90 degrees then the area is receiving too much heat - either escaping from the front of the fireplace and rising up the face, or radiating through the chimney to warm the outside wall.

All gas fireplaces using a self generating millivolt system and gas pilot valve do not need any electricity to operate. Only accessories such as blowers and some hand held remotes rely on house current for power.

Sunjel? Fireplaces operate on a non-toxic, environmentally friendly, alcohol gel called Sunjel? Premium. The gel is made from 100% natural sugar-cane or corn and burns into water vapour. The Sunjel? Premium is poured into a 'Fuel Holder Box' that sits between a set of realistic ceramic logs. The Sunjel? Premium is ignited with a long match or barbeque lighter. It is easy to operate the fireplace as every Sunjel? Fireplace is equipped with a manual shut-off for safety and convenience.

Answer: Gas fireplaces with a standing pilot light will operate during a power failure because there is a continual gas supply.

Yes, the Symphonytm flame and heater operate independently of each other. this means you can enjoy the ambiance of a realistic flame all year round!* In many gas units, the flame cycles off as the room temperature rises and you lose the flame effect until the room cools down again. In smaller rooms, gas fireplaces can be off a lot of the time and in warmer climates they may not come on at all unless the thermostat is set higher than the room temperature.

Heat pumps are operated with an infrared remote control that lets you control all features such as On/Off, the temperature, fan speeds, the mode (such as 'heat' and 'cool') and the timer. Heat pumps can be programmed to turn on when you're away from home or overnight, ensuring a warm or cool room on your return.

HEAT routes will be in operation approximately 39 weeks out of the year to coincide with college and university schedules.

Yes. Aside from the fact that all of our fireplaces radiate heat from their fronts, there is still heat that can be withdrawn from the fireplace. Using the blower increases the airflow thereby maximizing the heat being conducted from the back side of the fireplace. Adding a fan is easily done if 110 power is hooked up to the electrical box inside the unit. If power is not already at the fireplace, it still may be possible but may be more costly.

More so. A Bellfires? will provide ample heat without the grills and fans. The special refractory material of the Rosin Design radiates a comfortable warmth into the room. This type of system has been used in Europe for over 65 years.

The product can not be installed in any area where its temperature could exceed 120?F. Solid wood moldings or trim may be used to buffer the product in these areas.

Operating gas logs in a fireplace can be similar to burning wood in the fireplace. Yes you will receive some heat, but it is impossible to predict how much. Gas logs retrofitted to existing fireplaces are primarily for aesthetic benefit. They look great, provide a large yellow-orange flame and are not particularly efficient. If heat is your primary motive for retrofitting your fireplace you should consider a gas fireplace insert. Either way, you'll have something easy to use and maintain.