Burying the pipe is the best for some obvious reasons ( i.e., aesthetics, out of harm's way, no freezing, longer life, etc.) Burying the polyethylene pipe between 12" and 18" is adequate in the state of Texas but not required.

Allowable depth of bury can be calculated based on the allowable deflection as described above. Uni-Bell member products have been installed successfully at depths of fifty feet or more. The following tables are provided as quick reference. See similar questions...

Depending on the size of the pet and/or the casket, the graves are dug 26-32" deep, (allowing for 18" of dirt on top of the burial container). See similar questions...

We recommend that you bury the wire 1 - 3 inches underground to give it protection from possible damage caused by small rodents or surface traffic. It is not vital to the operation of the system that the wire be buried, but it is highly recommended. You can also bury the wire deeper, (up to 6-8 inches) if you are concerned about damage caused by aeration, etc. The wire can be attached to an existing fence, hedges or other items if it is not going to get damaged. See similar questions...

The mainline tubing can generally be buried with no problems. However, it is possible for burrowing rodents like gophers or moles to chew right through the line. That aside, it is often desirable to bury the line to have it out of the way so it won't be seen or tripped over. Emitter tubing can always be covered with mulch, which is, in fact, desirable to protect it from the sun and extend its lifespan. See similar questions...

A Deep Cleaning is properly termed "Periodontal Scaling and Root Planing". It is a cleaning which, instead of cleaning from the gumline up onto the tooth, is a cleaning done under anesthesia, starting at the gumline and extending beneath the gum onto the surface of the root. See similar questions...

YES! Lots of field experience shows that even with burial 3 feet deep, wires and cables can be struck by lightning. This occurs, once again, because soil is not a good conductor. So the lightning current keeps going down until it finds something metallic. Shallow burial (less than 1 foot deep) provides very little protection. See similar questions...

No, unless the body is to be transported out of state (and only if the burial state requires such a permit). You will also need the transit permit for out-of-state burials. Contact the Vital Records office in Hamilton County for more information at (423) 209-8025. A Tennessee Death Certificate must be filed whether your family handles the burial at home or a funeral handles the arrangements. See similar questions...

Sprinkool's tubing is supplied in 15-foot lengths, and systems are designed in what we term as a "15 by 15 design". This means that the Fields-lines as well as the Sprayheads are 15-feet apart. Although some tubing will need to be cut, the system is designed to maximize material and minimize cutting. See similar questions...

Not always. It depends on your bike, where you live, what you want from the bike. Do some research, read on the forum what others have done. Usually it is required that you go DOWN one size but not always. See similar questions...

Helical Piers need a minimum of 5 feet of soil above the top helix and need to be deeper than the active zone of soil, which is the zone of seasonal wetting and drying. Also, the Helical Pier needs to achieve the torque (turning or twisting force) specified on the plan of repair. Torque will vary based upon depth and density of the soil. See similar questions...

Retaining wall- 4 to 6 inches, depending on soil conditions. If your soil contains lots of clay, then excavate 6 inches. See similar questions...

I have heard that the Travis County Room is at a depth of 54 feet below the surface. I have also heard numbers that the Edwards Aquifer is 254 feet below the surface. Since caves do not form below the water level of the Edwards Aquifer, that is approximately the maximum depth of caves in Austin. See similar questions...

You can purchase a steamer from a home improvement store or grocery. They generally come with several attachments that can be used thru-out your home and vehicle. The machine will shoot hot steam through the foam/batting of the furniture. You can also use it to steam around doors and windows and floors. If you use DE, please do not use the steamer. You will create a mess! See similar questions...

You should always use a pipe insert when you connect Speedfit Pipe. Inserts help ensure that the shape of the pipe is kept circular, making for a better seal between the outside diameter of the pipe and the ‘O’ ring. They also make the pipe more rigid, helping to prevent ‘weeping’ past the ‘O’ ring if a side load is applied. See similar questions...

Depending on your condition, you can use one or both of them. However it is recommended to get as much exposure of the salt therapy as you can. Salin Plus has to be plug-in and can be used during the night and have a long time exposure as you sleep, and the Salt Pipe is handy and small and could be used when you travel and are outside of your home. They are complementary products and should obtain great results if used as indicated. See similar questions...

Definitive Sealing: by welding the Valsir sealing cover (art. 342). Non-definitive sealing: solution A: by welding the Valsir sealing cap (art. 340). Solution B: by welding the Valsir collar (art. 347) then, using the Valsir free flange (art. .45), the corresponding set of Valsir bolts (art. 341), the Valsir sealing gasket (art. 343) and the Valsir blind flange (art. 346). See similar questions...

Typically for the 9kW unit, you will need approximately 300m of pipe. Standard PVC pipe 20mm diameter is sufficient. This can be purchased as 150m rolls. Typically in warmer climates you should lay 1m of pipe per 40watts of heatpump (heating) rating. In colder climates, 1m of pipe should be laid for each 30watts of heatpump. The pipe should be laid between 2 and 4metres deep. If space is limited, it is possible to lay pipes at different depths in the same trench - eg 4m/3m/2m. See similar questions...

Depending upon the type of the wall or floor construction we would recommend that the minimum fixing shall be M8 x 65 sleeve anchor or expanding bolt type. Do not rely upon fixings that rely upon plastic components for grip, this also applies to chemical fixings. See similar questions...

The technician must be able to measure the fuel level and check the tank bottom for water prior to starting the test. See similar questions...