The bezel of the re-issue SUB 300T has graduations in Meters. There are 2 major diving institutes in the world; SSI and PADI, their courses adhere to the metric system. This was the reason for DOXA to choose the metric bezels but after they received lots of inquiries regarding a SUB 300T bezel with Feet graduations, they decided that the new SUBXXX bezels will be available in Feet, as they were on the original watch.

For units that have been purchased after 2000, when you open the cap (not the battery end) there will be 4 switches on the opposite side of the circuit board from where the cap snaps in. The 2nd switch from the right (or the 3rd switch from the left) is the unit of measure switch. For Meters, push the switch back (away from you), and for Feet, pull the switch forward (towards you).

Meter to feet Length ratio=3.3 (One meter equals 3.3 feet) Sq.meter to sq.feet area ratio= 10.76 (One square meter equals 10.76 square feet) In order to get the feet equivalent, you just have to multiply the meter amount with the length ratio (3.3) to get the amount of feet, or divide the feet amount by the length ratio to get the meter amount. For areas and spaces, just multiply the square meter amount with the area ratio (10.

Very easy. 100 square meters is 1076 square feet. Surfaces are given in square meters, written m2 or m2.

There are generally two types. One calibrated loop will hold 0.01 mL of sample; the other will hold 0.001 mL of sample. If a 0.01-mL loop is used, the number of colonies counted is multiplied by 100. IF the 0.001 mL loop is used the number of colonies counted is multiplied; (can you guess?), 1000.

Storm Case bezel kits are supplied as an aluminum rectangular frame system for mounting the equipment into the case's base or lid at various heights. Bezel and panel mounts are used for a variety of applications. A standard use is to contain and mount electronic, test and measurement equipment within the case to be utilized as control device or data collection unit.

The frequency of required calibration will vary with individual accuracy requirements and sensor drift.

All AstroRide and AstroSlide is priced per square meter. To help you in your estimates a meter is approximately 3.25 feet. A square meter is approximately 10 square feet.

To change units while using Passport Charts, select TOOLS | OPTIONS | UNITS. Note: Depth unit changes do not affect raster charts.

By best approximation, to get sq. meters, divide sq. ft by 10.75, or multiply sq. meters by 10.75 to get sq. ft. The conversion rate is currently 44 INR to one dollar. This is a fluctuating rate. Divide INR by 44 to get close approximation of prices in U.S. dollars. To get the current rate go to: http://wam.org.

The results of the dome calculator are the same unit of measure you used for the radius. If you enter the radius in feet, the strut lengths will be in feet. The dome calculator simply multiplies your number by constants, so the unit doesn't matter.

Hire a cleaning service. A spotlessly clean home is essential; dirt will turn off a prospect faster than anything. Serve cookies, coffee, and soft drinks. It creates a welcoming touch. But be sure the kitchen has been cleaned up; use disposable cups so the sink doesn't fill up. Lock up your valuables, jewelry, and money. Although the real estate salesperson will be on site during the open house, it's impossible to watch everyone all the time.

The RadDetect sensor is tested with a small Cesium source and a DSO to ensure disintegrations are detected. Then, the sensor is subjected to low-energy x-ray radiation to determine the sensitivity to a source that would be moderated (a Beta source in a steel jacket for instance). A program, uploaded to the RadDetect through a programmer's port, then sets the threshold levels in the processor.

ORP does not have to be "calibrated" but it can be tested if desired or required. Standard ORP Test Solutions with stable mV outputs are required. Two types of solutions are available. One type requires you to mix pH buffers 4 and 7 with quinhydrone. These offer 2 different stable values, but the shelf life is only several hours and they cannot be stored. Sensorex part number B125 is a complete kit with everything that you need to complete 2 point testing.

Its prime purpose is to keep track of time under water. It is unidirectional so that if it gets bumped, it will only lessen the time left for diving (i.e. bumped from 30 to 29 minutes). It can also be used as a timer, elapsed time, and time zone indicator.

You can use a fine metal polish paste but you will risk that orange and black numerals on the bezel would fade. www.watchpolishing.com sell a polishing compound which is very effective for removing fine scratches.

Walk barefoot. Walk barefoot some more. Go barefoot everywhere you can. Your soles, foot muscles, ligaments, and tendons are like any other parts of your body: you have to use them to develop them, otherwise they will atrophy. Note that you wouldn't need to build up your feet if you went barefoot from birth as nature intended. What you're actually doing by "building them up" is getting them back to their natural state.

The symptoms of arthritis which may include joint swelling, pain, tenderness, heat, redness, and/or limitation of motion, plus early morning stiffness, and skin rashes - often show up first in the feet? Since arthritis attacks the joints - and each of your feet has 33 joints - it is easy to understand how arthritis can seriously affect foot function. Fortunately; there is much you can do offset these effects on your feet and stay as active as you want to be.