Unfortunately, that's far too complicated a question to answer here. In general, turn compression off, and turn uucp 'spoofing' on. This can all be done on the fly by sending register settings as part of your send-expect sequence when you call out, or you can do so as part of your modem initialization string in static. Some Telebit modems don't save the register settings. You might have to set the registers in both the init string and in the calling sequence.

You may use any you'd like. Please note: it is your responsibility to purchase the correct, DSL appropriate, modem. If you need assistance, please contact our customer support team.

No, Alpha Telecom has a list of approved modems that have been tested with the ADSL service and are ACA approved. You may install a non Alpha Telecom if it is approved. Most importantly, it is a legal requirement that any equipment connected to the ADSL Service must be labelled with the ACA telecommunications compliance mark.

ClearSail recommends that no modems be used under the speed of 56K. It is recommended that you consider upgrading to a 56K x2 or v.90 modem. These modems will perform approximately twice the speed as a 28.8, and with prices coming down, most major computer stores offer 56K v.90 modems for under $50.00.

A#8.6: Currently the GNO serial drivers only support the two built-in serial ports. This does not imply that you cannot use a serial card in a remote machine (such as a IIe) that is connecting to your IIgs running GNO. A#8.7: These settings will usually work. See the Notes, below.

Enter your quote and service availability request information below to view, shop and compare DSL rates in "real time".

The v.92 modem-on-hold function is software that is located on your computer that should have come with your modem or computer.

Yes you can, but there are some complications you need to be aware off. If you have a permanent connection, with a fixed IP number then there is no problem. If you have a fixed IP number but you don't have a permanent connection then your site will not be available sometimes and you may wish to consider putting your Web or FTP site on a permanently connected computer- it can be very frustrating for users of your site to find that it is mysteriously not available some times.

The internal modem is a 56k baud modem, which uses modem manager technology. Modem Manager Technology initializes the modem, it answers the phone when a call is received and it controls the flow of data to the modem during dropouts. This eliminates most common problems. The internal modem will take over communication port 2 on the Nexus 1250. Port 2 can then become a gateway for other Modbus based serial devices.

Not for DSL. A DSL modem is required. Your old modem can still be used if you are ever away from your DSL line and need to connect to LavaNet via traditional dialup.

Although our headsets are not tested to work with modems, we have had some customers request this and have had reported back to us that they have been successful. However we cannot guarantee that this will definitely work.

Most routers are designed for broadband internet connections only. The Apple Airport is an exception as it has a dial-up modem built-in and can also support Broadband connections.

If you have a Router/Modem it will work with 2U ADSL Broadband. You will simply need to re-configure it with your 2U ADSL username and password etc.

Yes. There is no need to purchase an additional modem, although it is recommended if you have dedicated modems; one for Internet connections and one for RelayFax.

ePowerSwitch M8, ePowerSwitch-8 Guard, ePowerSwitch D4, ePowerSwitch-4 (all versions). You can use modems with all models that can be configured from a terminal program.

PCI-RAS modems were designed to be used on the standard 2-wire analogue PSTN telephone system. If your PBX conforms to this specification for its internal lines then the modem will work properly. Most PBX’s also require you to place a ‘0,’ or a ‘9,’ in front of the number to get an outside line. PCI-RAS modems will not work on Digital PBX systems and may be damaged if connected to such a network.

A 56k modem would be the minimum connection speed recommended for a single user. It is not recommended for multi-user environments.

No. Lightning DSL is based on very specific hardware. You cannot install any modem to be used with your service.

Yes. Each room has a private telephone line with its own direct incoming phone number. You may plug into the line to make toll free calls to your Internet service provider or corporate network.