The normal operating temperature depends on the type of system being used. A hot water baseboard system normally will be set 180° F supply water temperature. A radiant floor system can vary widely with a supply temperature from 90°F to 130°F depending on what type of construction and material covering it (carpeting, hardwood flooring, and ceramic tile). A boiler with hot water reset control will vary the water temperature according to the outside air temperature.

Most systems utilize a desuperheater to transfer a small amount of excess heat in the system to a standard electric Domestic Hot Water, (DHW) tank. Annually a desuperheater can provide 50% to 60% of the hot water requirements for a family of 4 or 5. Demand hot water heating, (a.k.a. 100% hot water heating or a triple function machine), requires that a second condenser be built into the unit for hot water heating.

Yes. A GSHP can be a combination heating/cooling and hot water heating system. You can change from one mode to another with a simple flick on your indoor thermostat. Using a desuperheater, some GSHPs can save you up to 50% on your water-heating bill by preheating tank water.

The tub is designed to get up to a temperature of 40 degrees.The most popular temperatures are between about 36 to 38 degrees.

Depending on the location, season, and heating delivered to the house the temperature can vary, but it could reach up to 65?C.

By installing an air elimination system external of the boiler to remove air form the water system, this is installed on the main supply pipe as the water leaves the boiler.

Yes, under normal circumstances. An additional storage tank will be required to be installed to pre-heat the cold water prior to entering the existing tank.

Temperature ranges vary by age group. The following ranges are based on an oral measurement. The first group, babies and toddlers, ages 0 to 2 years range from 97.5 to 100.4 degrees Fahrenheit. Children age 3 to 10 years range from 97.0 to 100.4 degrees Fahrenheit. Young people and adults age 11 to 65 range from 96.6 to 99.7 degrees Fahrenheit, and adults over the age of 65 range from 96.4 to 99.5 degrees Fahrenheit.

Temperature range is typically (87 to 98 degrees C) 189 to 208 degrees F. Maximum allowable temperature is 216 degrees F. With the cooling system pressurized cap, higher temperatures may occur under certain conditions.

Ocean water temperatures rarely vary beyond 27 - 30° C although thermo clines can sometimes be experienced at depths below 20 meters.

Recommended water temperature by Balneo therapists is about 38º C (nicely warm - watch out for cooling of the bath) as hot water could cause fatigue. Some patients may prefer hotter bath - generally OK but watch for high blood pressure, heart problems and fatigue factor.

The “Magic Faucet Bidet” models 2000 and 3000 get their hot water from the same hot water point your bathroom sink uses, and mix the hot water and the ambient temperature water to get a variety of water temperatures that you can regulate. The water temperature will never be hotter than what you can get at your bathroom sink but please start with a lower temperature setting so that you reach a level that is comfortable for you and not a harmful one.

The hot water that comes from the 600 ft. well is about 160? F. If the water were allowed to come to the surface, the temperature would be 135?.

Flakes are caused by calcium carbonate and magnesium carbonate precipitates. When hard water is frozen or boiled, the carbonates in the water come out of solution, appearing as whitish flakes and attaching to containers. This calcium is the same as that in dairy products and is harmless. Soft water does not have any calcium or magnesium carbonate deposits, but the use of soft water is not recommended.

The best way to tell if your ballast is running too hot is to take a wooden kitchen match and touch to the ballast box. If it ignites the match then it is operating too hot. I would recommend having it looked at by a professional or have it serviced at your local hydro shop. Yes if heat is already a problem in your garden then I would suggest moving your ballasts outside the grow room. Especially if there is more than 1. They can really increase the overall room temperature.

There is a Public Health Act regulation of 1936, which states that water should not be discharged down a public sewer at a temperature greater than 43ºC, but in reality this is unlikely to be a problem when power flushing. However, do consider the risk of cracking a toilet pan if you discharge very hot water into it when power flushing.

Yes. For cast iron construction heat exchangers we recommend using an anti-freeze designed for hydronic systems such as propylene glycol, or ethylene glycol. Always follow the manufacturer's recommendations when mixing a solution of up to 55%. Never use automotive anti-freeze or any petroleum based anti-freeze in a hydronic heating system. Note that it is better to add a heat exchanger rather than adding antifreeze to any main hot water system as glycol will reduce heat transfer by 50%.

When you're aware of the advantages, maybe you can find a house you like that already has hot water baseboard heat. If you are having a new home built for you, ask the architect or builder to specify hot water baseboard heating. If you are modernizing a home that has hot air heating, you can leave the cooling system in place but replace the furnace with a boiler, piping and hot water baseboard radiation. No.

Yes, the gas hot water service will provide hot water to the Quench shower throughout normal showering mode (Step 1). When you operate Auto-Mode (Step 2) Quench relies upon it’s own on-board electric heating system.top