Yes, as long as the height difference between the two installations is at least 25 cm. You are allowed to install two stoves to the same chimney if the height difference is min. 25 cm. However, do never install a stove to a chimney where a gas furnace already is installed. Use separate flue pipe stacks for each appliance.

Make sure all switches are in the on position. This includes the emergency switch at the top of the stairs and there may also be a work switch on your heating unit itself. Turn your thermostat well above the room temperature and not just a few degrees. If in doubt, turn it all the way up. Make sure you have oil in your tank. There should be a gauge on indoor tanks and we can provide you with a tank stick if you have an in-ground tank. Press the reset button just once. It will try to start.

No. Unlike natural gas and propane, heating oil is very stable and hard to ignite. While a delayed start can be unsettling, you are in no danger of your house exploding due to heating oil.

No. The stoneware cannot withstand the extreme direct heat and will break if placed on a stove top burner. You may use the stoneware in the microwave or oven. However, the tempered glass lid is not suitable for microwave or oven use.

No. Since the pellets are so efficient, the stoves do not need a chimney. All you need to do is vent them outdoors with a 4” pipe through an outside wall. So, choose the room you congregate in, place the stove in that room, and enjoy the ease and warmth of pellet heat! You’ll also enjoy watching the flames—and the fact that there is very little ash to clean.

If you are using the wood flooring plans that we have provided, we recommend that you create a rock or sand hearth to put your stove on. To install your stove on the hearth, follow manufacturer’s instructions and local building codes. Each dome is equipped with a metal stove flashing. The piping will run from your stove through the flashing and above your dome. All of the piping that is used in association with the stove should be double walled pipe.

It is always advised to use a HETAS approved installtion engineer. If is however the person carrying out the installtion is not on the approved list you will have to seek authority from your local 'Building Control' office. They will come out and inspect the installation. There will be a charge for this service.

Yes, as long as the local building requirements are followed. The clearance distances to combustible materials are to be kept. It may be a good idea to ask the chimney sweep for advice.

this time the emergence of Bioheat® fuel is much too new for burner manufacturers to comment on. However, in work accomplished throughout the northeast, organizations like Carlin, Beckett and Power Flame (notable burner manufactures) all are reviewing Bioheat® fuel. Bioheat® fuel appears to have little or no negative impact on a burner’s performance while providing emissions, sulfur, lubricity, global warming and health benefits.

per the space and size of the product , it is provided with two hooks for hanging it on the wall. The company provided with two screws for the Kitchen Hood.

No, this unit will not exhaust properly vented into a chimney. It must have its own three or four inch pell vent piping throughout its entire installation.

You should have your heating system tuned up once a year by a professional. A properly-serviced system can pay for the price of the tune-up over the course of the heating season in fuel savings and also help prevent untimely breakdowns or other major problems.

Yes. The BOZ is designed for installation in existing metal chimneys with 6 or 8 inch diameter flues. In addition, it can be adapted to many other chimney types.

Installation of our hearth products must be done in strict accordance with local or national building codes, and the unit's installation manual. We recommend that our products be installed by a factory-trained Mr. Fireplace installer.

If your stove outlet ID is about 1/8" larger than the size pipe you are looking at (ie: 6" pipe = 6 1/8" inside diameter outlet), then yes. If it is exactly the same size or smaller, you will need a Male-to-Male coupling or a Tee Connector where both ends are crimped. Hart's Hearth is a Christian Company that promotes and supports the commission of the word and works of Jesus Christ.

Yes, We carry Stainless Steel and Copper Chimney Caps that carry a lifetime guarantee. A cap will keep out animals, leaves, twigs, and rain. Rain entering from the uncovered top, does most of the damage in a chimney by getting into the mortar joints inside the firebox causing them to become weak and deteriorate. The single flue cap chimney cap starts at $95 Installed and are priced according to size. Multi-flue caps (covering more than one flue) start at $225 installed.

Most oil burners should be cleaned and serviced annually. Some may operate longer but the efficiency level may drop. Some older units may require more frequent service due to sludge problems that clog nozzles and filters.