The boiler will normally maintain 160-180 degrees. If plumbing into an in floor system, you will use a mixing valve to bring the water temperature down to the recommended level.

A Stanley Steamer boiler generates nominally 550 to 600 PSIG of steam pressure. Saturated steam at that pressure range is between 475 and 486 degrees Fahrenheit. I needed a new boiler for my car and ended up building it myself. If you go to the Restoration section of the web site I describe how I built my boiler. If you do not want to build your own, there are several people that do make them.

A.The salt water temperature ranges from 55F in the winter to 68F in the summer and is pumped in and filtered from Boston Harbor.

For cooling water in the intensifier your inlet water should also have a temperature less then 70 ° F (21 ° C). This will allow the water to be used by the heat exchanger to reduce the temperature of the hydraulic fluid. Should this not be available, a chiller could be added to your system. You would also like to have a temperature of less then 70 ° F for your cutting head water. This should help you to achieve the maximum seal life.

A - There is a facility on the microGENUS boiler to keep the hot water heat exchanger warm while the boiler is off so that hot water will be at the tap within 5 seconds this is activated by an ‘Economy/Comfort’ switch. When in the ‘Comfort’ position the boiler may fire up for a very short period from time to time in order to maintain the standby temperature within the heat exchanger.

Very cold water (below 38 deg.) will drastically slow down the aggressive behavior of the steelhead. Warm water (above 62 deg.) will make them dour or lazy. 42 - 58 degrees is just right.

The water is always cool and clean. The temperature of water delivered from this pump should be optimal for performance according to research. Well water will come out of the ground between 50-56 ? F. (13 ?C) Extensive records of well-water temps have shown that the water temp between depths of 9 and 18 m. is essentially constant throughout the year. Ideal drinking water temperature for livestock is between 40 and 65 ?F. Steers having access to cool drinking water gained .3 to .4 lbs.

Accepta’s advanced boiler water treatment chemicals include scale and corrosion inhibitors, antifoams, sludge conditioners and more, used for improving the efficiency of steam and other boiler systems.

There is an air block, so you should let the air out as the water goes in by lifting the syringe slightly out of the tank when filling with water.

A - Beneath the boiler, incorporated in the isolating valve set on some of our boilers, there will be a ‘filling loop’ for introducing mains water into the boiler circuit for filling and topping up purposes. These generally have an isolating valve at each end. To introduce water into the system, undo one of these valves completely and gently open the other valve to control the rate of flow of water into the boiler circuit.

If because of age, inefficiency or lack of capacity your current boiler needs to be replaced, we can advise you on the latest developments in boilers and tankless water heaters.

Through normal usage, some of the steam escapes and therefore does not return back to boil as water. Radiators make two sounds: "hiss" and "click." The hiss is small amounts of steam leaving the radiator; the click is the valve shutting off the release of steam. If you need to add water frequently, it could mean you have a leak somewhere in the system.

Average water temperature is 53 degrees and may fluctuate plus or minus 5 degrees with thermoclines or seasonal changes. Autumn water is warmest and may reach 58 degrees.