Neutralises acids and other harmful chemicals formed in the combustion process to prevent rust and corrosion

Due to the high ambient temperatures, high underhood temperatures are produced. In addition new aerodynamic body styles reduce air flow to the engine compartment. Engine oil not only lubricates but also absorbs a lot of heat from the engine and due to this, oil crankcase temperatures can reach 120°C or higher during normal operation. Maximum load conditions can cause oil to exceed 135°C. See similar questions...

It is generally suggested that you check your oil level on a monthly basis. More often if you travel a lot or burn/leak abnormal amounts of oil. Pull the dipstick out, wipe it with a clean paper or cloth towel, and then replace it firmly back into its engine cavity. See similar questions...

Oil is used to provide lubrication between two moving parts to reduce wear. Oil is used to gather or absorb heat from the internal engine parts and carry it away. Oil is also used to flush the metal particles from the bearings of your engine. 90-95% of all mechanical engine wear occurs in the first 10 seconds of a cold engine start up. That initial cold start wear can equal hundreds of kms of warm engine wear. Using the correct oil for the season can increase the life of your engine. See similar questions...

Gasoline and diesel engines operate according to different engineering principles and burn completely different fuels. Gasoline engines require a volatile, high octane fuel whereas diesel engines run on a low octane and relatively low volatility fuel. Gasoline engines usually operate at higher temperatures and because of their composition and the high temperatures produce entirely different combustion products than does diesel fuel operation. See similar questions...

Due to high ambient temperatures and the tremendous heat generated in an automatic transmission, an auxiliary transmission oil cooler is an economical way to help protect against costly repairs. Automatic transmission fluid (ATF) cools, lubricates and cleans internal transmission components. When transmission temperatures exceed about 93°C, the ability of the ATF to perform is greatly diminished. Subsequently, the life span of the fluid, seals and moving parts are significantly reduced. See similar questions...

By law and specified by the Department of Motor Vehicles, we absolutely cannot, under any circumstance, set the miles back on any odometer. See similar questions...

Fill the transmission & rear end until it trickles out the level hole. If you put too much in the transmission it will blow out the transmission vent. Transmission takes about 1 qt and the rear end takes about 1/2 qt. The engine requires about 3 qts. See similar questions...

Only our Super Nitro RS4 can fit a 4-stroke engine, and fitting this type of engine requires a special mounting kit which at this time is only available in Japan from a company called Racy. At this time we are unaware of any other company that makes a conversion kit. We have no plans to release a 4-stoke engine conversion for any of our kits. See similar questions...

Not very important at all. Unfortunately, due to ?a**e covering? reasons we cannot print this advice on the can! Although officially all manufacturers advise against mixing different makes and grades, in fact there is very little chance of any harm being done, even if one is a mineral 20W/50 and the other is a 5W/30 synthetic. Obviously, avoid this if you can, but do not panic if there?s no other alternative. See similar questions...

We recommend every 3,000 miles or 6 months. Combustion by-products contaminate and break down your engine oil which reduces its ability to protect your engine. We have seen manufacturer's recommend substantially longer intervals, their concern is making it through the warranty period, and our recommendations are based on trying to get you 200,000 plus miles from your vehicle. See similar questions...

About 4 liters. A good rule of thumb is that you need to fill the engine oil until the oil pours out when the top pepcock is open. If the oil does not pour out, then add more oil. See similar questions...

No, Rislone Engine Treatment is formulated to be left safely in the crankcase for the life of the oil change for maximum performance. It is not an engine flush and does not require draining. See similar questions...

Yes, Rislone works with all petroleum-based motor oils including conventional, high mileage and synthetic. Rislone is also safe for use with PTFE-based engine treatments and will not alter the PTFE coating. See similar questions...

Many old engines show signs of oil burning. Tufoil can help in some cases by freeing up partially sticking piston rings. There have been some dramatic improvements reported from the field where Tufoil freed up the rings and they started working properly again. However If the rings are cemented solid in their grooves or the cylinder is scored, no lubricant can eliminate the smoking. See similar questions...

Crane Cams does not recommend the use of synthetic oils during the initial break-in period for a new camshaft. Use a good quality grade of naturally formulated motor oil during this period. If you choose to use synthetic oil after the engine has been broken in, change the oil filter and follow the oil manufacturer's instructions. See similar questions...

No, Crane Cams does not recommend the use of oil restrictors. The oil is the life blood of the engine, not only lubricating but cooling the engine components as well. For example, a valve spring builds in temperature as it compresses and relaxes. This increase of temperature affects the characteristics of the spring material, and if excessive, will shorten the life of the spring. Oil is the only means the spring has for cooling. See similar questions...

Yes, there is no harm in using a Synthetic blend or a full synthetic oil. There are many benifits to using a synthetic engine oil, such as ease of starting, lower operating temperature, and reduced component wear. For more information, visit the Mobil 1 site See similar questions...