All ProCalV5 products go through extensive Quality Validation Testing as a part of its development life cycle. This Prime Technologies’ assurance to our Customers that the product they receive will work as intended and when combined with a compliant System Validation Process is Validatable.

A.We can apply for a v5 in our name and send off for change of owner for you if you are not an english citizen(taking the vehicle abroad,etc),We would charge the ?25 fee for the v5.and send on to you recorded delivery

You can apply for a V5 using a form 'V62', available from the post office (or we can supply you with one at point of sale). It is free for CAT C vehicles, however, there is a ?25.00 charge for CAT D, CAT X or UNRECORDED vehicles.

Typical installation takes less than an hour. Only two wires need to be connected and routed. Mounting on the instrument panel is accomplished with a Velcro? hook and loop fastener. Routing of the two wires must consider possible sources of abrasion. Good aircraft electrical wiring practices must be followed.

A minimum roof slope of 2-in-12 is recommended, though lower slopes are acceptable if the side laps are caulked. Met-Tile may be installed over existing shingles or decking, and may also be applied over open steel purlins or wood rafters.

No. You drill the few holes needed for your kiln, place the EnviroVent 2 spring loaded plenum cup under your kiln and mount the motor to the wall. We supply the aluminum drier ducting that is used between the plenum cup and the motor. Skutt even supplies the stainless sleeve that is needed to pass through the wall. It runs on 115V household current. If you install the EnviroVent on a kiln with a metal floor plate, you will need an electric drill.

We install a small antenna on or near the roof of your home or business. Then a Cat5 cable is run down and into your home.

Check out the STL license Create a CATPart Load the STL Workbench Select the Import button Set the file type to ASCII-Free and Browse to read the .stl file This will load the raw STL data into the open part Any further manipulation requires further training (try F1 Help).

The purpose of a Thick Surface is to model a solid to represent a constant thickness of material from a given contour. This can be used to model sheet-metal, plastic, or even a machined part that needs to mate with a defined surface.

Yes. Version 5 and 6 install in separate locations such that they can both be installed at once. Desktop icons for Version 6 identify their major version (e.g. "STRIP.LOG 6"). On the Start Menu, Version 5 programs appear in a program group called "WellSIght Systems V5", and Version 6 programs appear in a program group called "WellSIght Systems V6". Note: Shortcuts for Version 5 programs only identify their major version (e.g. "STRIP.

We are unable to purchase any car without the original V5 document (log book) as this allows us to check all is in order with your car. If you do not have one you can obtain a new document by filling in form V62 which you can download from the DVLA or pick up from any Post Office. The completed form and appropriate fee should be sent to DVLA, Swansea, SA99 1AR. It normally takes 3 - 4 weeks to obtain a new V5.

Questions or problems regarding this page should be directed to webmaster@bisque.com. Please send your message to one address only.

Most of our customers do their own installations. All of the products we offer arrive to you with complete installation instructions. Our website also has general guidelines for installation. Please refer to the instructions included with your kit, as installation instructions.