Yes. Most building codes allow the installation of a gas fireplace in a sleeping room as long as it is a sealed combustion, direct vent model. Your decision really comes down to whether heat or aesthetics is your number one priority. If heat is your first concern, or the existing wood fireplace has had a history of down drafting (smoking), you should purchase a gas insert.

Yes. Most building codes allow the installation of a gas fireplace in a sleeping room as long as it is a sealed combustion, direct vent model. Your decision really comes down to whether heat or aesthetics is your #1 priority. If heat is your first concern, or the existing wood fireplace has had a history of downdrafting (smoking), you should purchase a gas insert.

All vent-free appliances, whether natural or propane, produce water. The accumulation can range from 3/4 to 1pint of moisture per hour in the room. Under normal conditions, this does not cause a problem. However, if you have a problem, you will need to provide an outlet for this moisture. This can be accomplished by providing adequate ventilation or using a dehumidifier to help control the moisture. Yes/No.

Since 31 October 1998, any room converted to use as sleeping accommodation should not contain the following types of gas appliances: A gas fire, gas space heater or a gas water heater (including a gas boiler) over 14 kilowatts gross input unless it is room sealed. A gas fire, gas space heater, or a gas water heater (including a gas boiler) of 14 kilowatts gross input or less or any instantaneous water heater unless it is room sealed or has an atmosphere-sensing device.

Direct vent fireplaces are the only fireplaces that most building inspectors will approve. Electric is also permissible, but not very efficient.

No, you may contact any licensed plumbing contractor. The best source for locating a plumbing contractor is via the Yellow Pages. Back to Top Yes, we have a complete Installation and Service department to install and maintain residential and commercial gas piping and appliances. For expert installation, maintenance and repair services call the Clearwater Gas Service and Repair at 727-562-4900, ext. 7419. Back to Top

Although the frequency of your fireplace servicing and maintenance will depend on use and the type of installation, you should have a qualified Mr. Fireplace service technician perform an appliance check-up at the beginning of each heating season.

No! The beauty of Regency Direct Vent technology is that you do not necessarily need to go up through your roof to terminate the venting. All you need is proximity to an outside wall, the distance to which depends on the model you choose. Not only does this make installation more flexible, but it also keeps the costs down. And with our sleek and attractive patented AstroCap horizontal termination cap, you won't be cluttering up the outside of your home either.

We recommend not moving the logs. Placement of the logs is critical to the operation and performance of the fireplace. Misarranged logs can result in operational problems. If you notice the logs have been moved during cleaning, contact a service person or check your installation and operating instructions for proper placement.

This is a normal result of the curing process of the paint and logs. Glass should be cleaned within 4-6 hours of initial burning to remove deposits left by oils from the manufacturing process. A non-abrasive cleanser such as Brasso may be necessary. The glass panel must remain in place but the screen will be removed so that the fixed glass doors will not fit on the unit.

Vent free fireplaces are fireplaces that do not require any type of vent system. Instead, they are designed to burn clean and the combustion by-products allowed to flow into the room the fireplace is located in. Stringent requirements ensure that these fireplaces not only burn cleanly, but that they are located in rooms of sufficient size to ensure an adequate supply of fresh air is always available for the combustion process.

No. Gas fireplaces are designed to burn gas only. Burning wood would damage the fireplace and could be very dangerous.

All Osburn gas fireplaces are very user friendly. Each fireplace is equipped with an easy-to-access control knob that enables you to turn the fireplace on and off. You simply have to push a button to turn the fireplace on. Likewise, you turn the fireplace off by setting the control knob at ?OFF?. You can adjust the intensity of the fireplace from low to high with the control knob.

Fires r us given a scoot link for our customers to look for registered gas installers of your area but a more comprehensive list of registered gas installers can be obtained from the council of registered gass installers(CORGI) website and their web address is www.corgi-gas.com and you are advised to look in yellow pages too.Please note that you must get your gas fire installed from a competent corgi engineer.

Gas logs burn cleaner than wood burning fireplaces do. Annual inspections are recommended but cleaning annually isn't necessary.

Your fireplace would reflect heat into the room & would have to be burned for a long period of time to make the fireplace heat efficient. There are other sources of energy such as wood stoves or inserts that are more efficient.

instant, roaring fire with no logs to lug or mess to clean up is what makes gas logs a joy to own without polluting the air like a wood burning fire.