After the source of moisture has been controlled, visible mold growth on hard (non-porous) can be scrubbed using detergent and water. Some stains may still be seen on the surface after cleaning. Various strengths of bleach solutions have also been recommended for disinfecting, but proper safety precautions should be taken to prevent skin, eye and respiratory damage when bleach is used.There is no evidence that bleach is more effective than detergents in removing mold from non-porous surfaces.

The AGRO-JET® cleans up in a jiffy without need for any disassembly. Simply replace the medication in the 60cc syringe with de-mineralized water and flush by pressing on the syringe plunger or cycling the AGRO-JET® through 5 to 10 shots. You're done!

Clean up mold and take care of the problem by following the advice above to keep your home dry and keep mold out. Decide if you have a large or small area of mold. A small area is less then about ten square feet, or a patch three feet by three feet square. To clean a small area, follow the advice below. You may use a cotton face mask for protection. If you have a lot of mold damage (more then ten square feet) consider hiring a cleaning professional.

The mold cleanup is finished when there is no visible mold remaining and there is no dust or dirt remaining that could contain large amounts of mold and mold spores. Routine clearance testing for mold is not necessary. Leaving a few mold spores behind is not a problem if the underlying moisture problem has been corrected. Remember that mold spores are virtually everywhere. Even if all mold and mold spores are removed as part of the cleanup, spores from outside will re-enter that space.

The time you are most likely to stir up spores and be exposed is the very time you are trying to clean up your mold problem. That's when you need to be the most careful. First, try to determine the extent of the mold infestation. You can do it yourself if the area is small and well defined, as long as you are free of any health symptoms or allergies.

Glass Cleaner is great for most interior or exterior hard surfaces where you want a dust resistant, wax free finish.

For normal cleaning, any non-abrasive cleaner mixed with water will be sufficient. For more stubborn problems Colonite #920, a fiberglass polish, is recommended.

Molds are not choosy about where they grow as long as the place has excessive moisture. Moisture seeps through concrete walls and floors, wood and plastics and

The act of cleaning mold can increase the airborne spore level by ten-thousand times, which can result in severe illness and actually spread mold growth if done improperly. Such high levels of airborne mold spores warrant protective clothing, including gloves, goggles, and a respirator. If you suspect you have toxic mold in your home, then you should consider hiring a professional mold remediation expert to clean up the mold and safely dispose of it.

When mold is disrupted by cleaning, it releases tiny spores that disperse into the air. After cleaning, the mold may be visibly removed but the spores are still present. If moisture is present from a water leak or elevated humidity, the mold spores will grow into new mold colonies. As a result, each cleaning spreads the mold problem and causing re growth. The key is removing the moisture. Properly removing the mold spores through filtration and treatment will prevent the mold from reoccurring.

There are hundreds of thousands of types of molds. All are fungi, which means they are many-celled organisms that reproduce by sending tiny seeds called spores into the air. Molds need four things to grow: food, air, the right temperature and water. Although fungi grow naturally "outdoors", molds are very common in buildings and homes and will grow anywhere indoors where there is sufficient moisture.

Isolate the affected area and/or materials and reduce the circulation of air from the affected area to the rest of the building. This may be accomplished by hanging plastic sheeting and sealing doorways, windows, vents and other openings. Avoid using fans, as this causes the mold spores to become airborne. Porous materials, such as ceiling tiles and carpet may have to be disposed of if they become moldy.

The buff is recommendable for cleaning rails and other wood surfaces. Never wet it the chamois because you want it to keep it as soft and smooth as possible. You can also lightly rub the leather pockets to keep them

Contact the Louisiana State Licensing Board for Contractors for Do's and Don'ts when hiring a contractor.