Your Group directive (probably in conf/httpd.conf) needs to name a group that actually exists in the /etc/group file (or your system's equivalent). This problem is also frequently seen when a negative number is used in the Group directive (e.g., "Group #-1"). Using a group name -- not group number -- found in your system's group database should solve this problem in all cases.

You get NFS timeouts because you are using soft mounts. Normally, mounts are hard, which requires the client to continue attempts to reach the server forever. A soft mount allows the client to stop trying an operation after a period of time. A soft timeout may cause silent data corruption if it occurs during data or metadata transmissions, so you should only use soft mounts in the cases where client responsiveness is more important than data integrity. See similar questions...

All login information is case sensitive, meaning that you must enter your e-mail address and password exactly as you did when you first submitted your resume. Otherwise, the system will not recognize you as a registered user. See similar questions...

NFS Version 2 supports up to 8KB reads and writes. NFS Version 3 allows larger reads and writes (see question A1). Stock 2.4 kernels earlier than 2.4.20 do not support read or write operations larger than 8192 bytes for either NFS Version 2 or 3. Server-side TCP support, introduced as an experimental compile-time option in 2.4.20, increases the server's maximum I/O size to 32KB by increasing the value of NFSSVC_MAXBLKSIZE (see question B2). See similar questions...

A material argument is one that a reasonable person would believe was intended to influence the agency's decision. A question or statement about a matter of practice or procedure is not a material argument. See similar questions...

quot;Invalid configuration” messages result when you attempt to start SIMPLE while it is disabled during normal business hours or for scheduled maintenance. You must start and finish your O/PUS load during the specified time blocks. When determining your start time, you need to allow enough time to complete the process before business hours begin. To help you determine the best day and time to begin O/PUS Updates for your time zone, see Determining when to perform the update. See similar questions...

If you are sure that you are entering your password correctly, check to see that you are trying to access the proper server. Also check to make sure that you are typing the correct password and user name. You may have successfully logged in to mlode.com instead of www.mlode.com. You wouldn't have a public_html directory on mlode.com. See similar questions...

Hopefully, this bug has been fixed in the latest version. I changed the memory manager that gcc uses in order to work around a bug in one of the POSIX functions in Cygwin (mmap). Compilation might be slower on machines with lower memory because it now uses a less efficient scheme which may take more memory. This might introduce new bugs, but I have not seen anything yet. See similar questions...

Some start page programs have an adverse effect on sign-ups and may return a "sponsor ID invalid" error. If you are within the confines of a start page surfing-for-credits session and receive such an error, simply type (or copy and paste) the following URL directly into a separate browser window address bar. Make certain you replace the red x's with the sponsor ID shown at the top of the page: See similar questions...

Some versions of the Linux NFS code only accept mount requests from a privileged port; try # mount -o -P linuxbox:/blah /mnt See similar questions...

Sun workstations running SunOS 4.X only accept mount requests from a privileged port; try # mount -o -P sunbox:/blah /mnt The most frequent problem is not understanding the correct format of /etc/exports. Please review exports(5) and the NFS entry in the Handbook, especially the section on configuring NFS. See similar questions...

Yes, but there is no guarantee it will always work. There are no restrictions in the software which limit where the source data is located. However, CD-R requires a continuous stream of data as it is writing, and a busy network could interfere with performance. Also remember, the greater the recording speed the greater the sustained data transfer rate the drive requires. It is easy to test using a Dummy Write. Slow down the write speed and increase the buffer size. See similar questions...

Some versions of the Linux NFS code only accept mount requests from a privileged port; try # mount -o -P linuxbox:/blah /mnt See similar questions...

It means that the Username or Password that you have entered is not a valid combination. If you have forgotten your Username and Password, you may go to the Forgot Password section under Profile to obtain your password. You may also send an e-mail to the webmaster, who will then send your password to you upon matching your e-mail address with our database. See similar questions...

You might have made a typing mistake. Before you enter the information again, check the NUM Lock and CAPS Lock keys. See similar questions...

Verify that you entered the correct License Type. If you purchased online, check that the License Type you entered matches the one in the email you received from us. If you purchased from a retail outlet, use the License Type "Individual" Verify that you entered the correct Purchaser's ID. If you purchased online, enter the Email address used when the product was purchased. If you purchased from a retail outlet, use the Purchaser's ID that came with the product. See similar questions...

There are several reasons why you may be getting an error. First, check again to make sure that all of the information was filled in completely with no errors. The name needs to be keyed in EXACTLY as it is on your credit card. Also, the billing address must be the same as the one for your credit card. The credit card number must be entered with NO SPACES OR DASHES. If all this information is correct, then your card may be expired, or you may have insufficient funds for your purchase. See similar questions...